WenmarOpen by Wenmar Pro

Service bulletins for the 2023 Ford Mustang Mach-E

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

184 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Driver assistance are shown. Show all

Bulletins, newest first
SSM 517762023-07-12. Service bulletin. EQUIPMENT; BACK OVER PREVENTION: CAMERA SYSTEM. Some 2021-2023 Mustang Mach-E/F-150, 2022-2023 Expedition/Navigator and 2023 Corsair vehicles may exhibit a Driver Monitoring Camera Blocked message and/or DTCs B115E:97, B15E1:97 and/or B15E2:97 stored in the driver status monitor camera module (CMR). These DTCs should be disregarded unless it is a DTC with a status byte 8F. Other status bytes should be disregarded as they may be caused by a camera obstruction such as driver position, aftermarket devices or dust on the camera. To clear the DTCs, remove anything obstructing the view of the camera and light emitting diodes (LEDs), place the steering wheel in the center position and close the driver door. Connect Ford Diagnosis and Repair System (FDRS) and clear the DTCs. Turn the ignition off and wait 10 seconds. Turn the ignition on and wait 1 minute. Perform the CMR self-test and reevaluate if DTCs persist.
23PU0105DCCHG2ME2023-06-06. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Priority Update 23-PU0105-DC-CHG2 for 2023 Mach E vehicles is now available: Quality Improvements include: -Improvements to the DC Fast Charging experience.
23PU0415BLMFXVIS2023-06-06. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Priority Update 23-PU0415-BLM-FX-VIS for 2021 - 2023 Mach E vehicles is now available Quality Improvements include: -Phone as a Key Passive Entry improvement
23OTASU4P2MACHE2023-06-06. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Software Update 4 P2 for 2021- 2023 Model Year Mach E vehicles is now available. Quality improvements include: Remove Reverse Brake Assist unavailable warning Remove Beltminder Tollbooth Mode Remove incorrect frunk service now pop- up. Improves hood ajar warnings/ chimes. New thermal parameters added for increased powertrain component protection. Ford Pass Charge settings - will not revert back to previous settings.
TSB 23-21552023-05-31. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Some 2021-2023 Mustang Mach-E vehicles may exhibit various driver assistance system warning messages or inoperative features and/or diagnostic trouble code (DTC) U3000:49 stored in the image processing module A (IPMA) that will not clear and not be stored in the vehicle's history. DTCs C1001:31 and/or U3000:89 may be stored in the IPMA, but may have recently been cleared and stored in the vehicle's history. This may be due to a connection issue between the IPMA Camera and the IPMA. To correct the condition, perform the following service procedure to repair the connection and reset the IPMA.
SSM 516182023-05-24. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Some 2021-2023 Mustang Mach-E, 2022-2023 F-150 Lightning vehicles may experience an exterior charge status indicator not illuminating the blue charging segments after an over the air (OTA) update. Confirm if the Charge Port Light toggle button is not present in the center display screen by selecting Vehicle Icon> Controls> Access> Charge Port Light toggle button, as this button has been removed after OTA update. Replacing the charge port and/or the battery charger control module (BCCM) is not recommended. This condition does not affect charge behavior and no additional diagnosis or service is required for this condition at this time. Inform customers that they can continue to drive the vehicle and engineering is currently working on a solution for this condition that is expected in September 2023. Monitor OASIS for additional information.
TSB 23-21372023-05-24. Service bulletin. EQUIPMENT; LANE DEPARTURE: LANE KEEP: STEERING ASSIST. Some 2021-2023 Mustang Mach-E vehicles may exhibit various driver assistance system warning messages or inoperative features and/or Diagnostic Trouble Code (DTC) U3000:49 stored in the Image Processing Module A (IPMA) that will not clear and not be stored in the vehicle's history. DTC C1001:31 and/or U3000:89 may be stored in the IPMA, but may have recently been cleared and stored in the vehicle's history. This may be due to a connection issue between the IPMA Camera and the IPMA. To correct the condition, perform the following service procedure to repair the connection and reset the IPMA.
23OTASU4P1MACHE2023-05-05. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Software Update 4 P1: For 2021- 2023 Model Year Mach E vehicles is now available. Quality improvements include: - Improved heater performance and interior humidity compensation. - Enhanced Power Steering Control Module communication. (Removes erroneous popup message) - Improvements to Lane Keeping Feature - Improvements in Cyber Security for Driver Assist Tech.
SSM 515712023-05-04. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Some 2021-2023 Mustang Mach-E vehicles may experience loss of phone as a key after an over the air (OTA) update. There may also be diagnostic trouble code (DTC) U0214 stored various modules for loss of communication with the remote function actuator (RFA) module. This may be due to software in the RFA module causing it be locked/stuck in programming mode. To restore phone as a key functionality for the customer and RFA communication, remove RFA fuse (F18/19) located in the body control module (BCM) for one minute and plug it back in. Reprogram the RFA module using the latest software level of the Ford Diagnosis and Repair System (FDRS). For claiming, use causal part 14G617 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.
SSM 515682023-05-04. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Some 2021-2023 Mustang Mach-E vehicles built on or before 16-Feb-2023 may exhibit a false alarm activation and/or warning message in the FordPass application when the doors are locked. This may be due to the software in the door latch control module E (DCME), door latch control module F (DCMF), door latch control module G (DCMG) and/or door latch control module H (DCMH). To correct the condition, download and run the door control module software update application for each module one at a time using the Ford Diagnosis and Repair System (FDRS). For claiming, use causal part 58219A65 and applicable labor times in Section 10 of the Service Labor Time Standards (SLTS) Manual.
PU0210-ALBCMACHE2023-04-06. Service bulletin. LANE DEPARTURE. Priority Update 23-PU0210-ALBC_ON for 2023 Mach E vehicles is now available. Quality Improvements include: - Improved customer experience for Lane Change Assist and In-Lane Repositioning features.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.