WenmarOpen by Wenmar Pro

Service bulletins for the 2020 Ford GT

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

15 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
SSM 506162022-03-22. Service bulletin. ENGINE AND ENGINE COOLING. Some 2017-2022 Ford GT vehicles may exhibit a runs rough or hard start with or without an illuminated MIL with DTC P0300, P0301, P0302, P0303, P0304, P0305, P0306 and/or P0316. Prior to performing any diagnostics, determine if the vehicle operating conditions may have resulted in multiple cold engine start-ups without allowing the engine to reach normal operating temperature and being driven. If that operating condition is determined, inspect the spark plugs per Workshop Manual (WSM), Section 303-00 and repair as directed. If no concern with spark plugs are found, proceed with normal diagnostics per the Powertrain Controls/Emission Diagnosis (PC/ED) Manual. Upon returning the vehicle, refer the customer to the owners guide regarding proper driving cycles.
21B262021-05-04. Service bulletin. ENGINE AND ENGINE COOLING. Certain 2020 Model Year Mustang GT500/GT350 Equipped with a 5.2L Engine Secondary Timing Chain Tensioner In some of the affected vehicles, the engines secondary timing chain tensioner may not have been properly activated during assembly, which could result in a timing loss. Timing loss could lead to internal engine damage, a rough running engine, and engine misfires.
TSB 21-20112021-04-03. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. Some 2020 Mustang GT500 vehicles built on or before 28-Aug-2020 may exhibit various concerns with the active exhaust system. These may include "Drive Mode Not Available" or "Exhaust Mode Not Available" messages, and/or diagnostic trouble codes (DTCs) P26C5, P26C6, P26FE, P2BF9, P2BFB, P26C7, P2BF5, P2BF8, P2BFD, and/or P2BFA. This may be due to pinched wiring or a misaligned bracket where the exhaust actuator mounts. To correct the condition, follow the Service Procedure to make sure that the exhaust is seated correctly.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.