WenmarOpen by Wenmar Pro

Service bulletins for the 2025 Ford F-150

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

178 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Transmission and driveline are shown. Show all

Bulletins, newest first
TSB 25-25692025-12-01. Service bulletin. POWER TRAIN; ENGINE. Some of the vehicles listed in the Model statement above may exhibit an illuminated malfunction indicator lamp (MIL) with DTCs P0301-P0306, P0201-P0206 and/or various other powertrain DTCs stored in the PCM. This may be due to the engine harness contacting the hose crimp end or spring clamp tangs on the exhaust heat exchanger heater hose assembly.
SSM 544012025-12-01. Service bulletin. POWER TRAIN; SERVICE BRAKES. Some 2021-2025 F-150 vehicles may exhibit a stuck in park condition with no diagnostic trouble codes (DTCs). This may be due to connector C211 pin push out on circuit CCB61 or an open on circuit CCB61 between the antilock brake system (ABS) module and the body control module (BCM). Workshop Manual (WSM), Section 307-05 Automatic Transmission External Controls > Diagnosis and Testing > External Controls - Pinpoint Test for "Stuck In Park" has been updated with improved diagnostics. Refer to revised WSM sections for normal diagnosis.
SSM 543922025-12-01. Service bulletin. ENGINE; POWER TRAIN. Some 2021-2025 F-150/Expedition/Navigator vehicles equipped with a 3.5L EcoBoost engine may exhibit diagnostic trouble code (DTC) P0299 stored in the powertrain control module (PCM) and may also exhibit a rattle noise from the turbocharger. This may be due to the wastegate actuator rod being disconnected. Workshop Manual (WSM), Section 303-04 Fuel Charging and Controls > Turbocharger has been added to address this condition to allow servicing of the turbocharger actuator rod. In addition, the wastegate actuator rod and associated retention springs and clips have been released as lower level components to complete the repair without replacing the entire turbocharger actuator assembly.
TSB 25-25132025-11-13. Service bulletin. POWER TRAIN. This article supersedes TSB 24-2189 to update the service procedure and add 2025 affected vehicles. Some 2021-2025 F-150 non-Raptor vehicles equipped with an ESOF transfer case (minor feature code FMLAS) may exhibit an intermittent grinding/hum/rumble noise from the front wheel area while in 2WD that goes away when the vehicle is put into 4WD. These vehicles will also have no diagnostic trouble codes (DTCs) stored in the transfer case control module (TCCM). To confirm a vehicle is built with a certain minor feature code, review the build information by double-clicking the vehicle identification number (VIN) in the upper left corner in the Professional Technician System (PTS). This may be due to incomplete disengagement of the integrated wheel end (IWE) actuator assemblies.
SSM 543632025-11-13. Service bulletin. UNKNOWN OR OTHER; POWER TRAIN; ENGINE. Some 2021-2025 Expedition/Navigator/F-150/F-Super Duty/F-53 Motorhome/F59 Commercial Stripped Chassis/F-650/F-750/Transit vehicles equipped with a 2.7L/3.5L (non hybrid)/6.8L/7.3L engine and 2021-2026 E-Series may exhibit a rattle/scraping noise from the bellhousing area on start-up. Workshop Manual (WSM), Section 303-00 Engine System - General Information > Diagnosis and Testing and 303-06 > Starting System has been updated to address this condition. Additionally, WSM, Section 303-01 > Removal and Installation > Engine to Transmission Spacer Plate has been added to address this condition. Refer to the revised WSM sections for normal diagnosis.
SSM 543402025-11-04. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM; UNKNOWN OR OTHER. Some 2022-2025 F-150 vehicles may exhibit a condition where the intrusion alarm will activate without an external source. This may be due to software in the body control module (BCM). Reprogramming or replacing the BCM may not resolve this condition. Inform customers that engineering is currently working on a solution for this condition and it will be released by the end of Q1 2026. Monitor Professional Technician System (PTS) for additional information and schedule service appointments for customers once the repair becomes available.
SSM 543382025-11-04. Service bulletin. POWER TRAIN. Some 2021-2025 F-150 vehicles equipped with a 5.0L/5.2L engine, 2021-2025 F-Super Duty/F-53 Motorhome/F59 Commercial Stripped Chassis vehicles equipped with a 6.8L/7.3L engine and 2021-2026 E-Series/F-650/F-750 vehicles equipped with a 7.3L engine may exhibit a rattle/scraping noise upon startup that may remain after the engine is running. This may be due to the starter motor drive gear not retracting after starting. To correct this condition, inspect the starter motor drive gear and shaft. If the starter motor drive gear slides back and forth by hand and/or shows signs of scoring or damage, replace the starter motor following Workshop Manual (WSM), Section 303-06 Starting System > Removal and Installation > Starter.
SSM 543312025-11-04. Service bulletin. POWER TRAIN. Some 2024-2025 F-150 vehicles equipped with a 2.7L engine, built on or after 27-Aug-2024 may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble codes (DTCs) P1285 and/or P1299 stored in the powertrain control module (PCM) and Engine Coolant Over Temperature and/or Service Vehicle Soon warning message displayed on the instrument panel cluster (IPC). This may be due to the cylinder head temperature (CHT) sensor. Follow the Workshop Manual (WSM) 303-03A Engine Cooling - 2.7L EcoBoost > Diagnosis and Testing > Engine Temperature Pinpoint Test (PPT) DL1-DL10. If P1285 and/or P1299 is still present, replace the CHT sensor. Refer to WSM, Section 303-14A Electronic Engine Controls > Removal and Installation. For claiming use causal part 6G004 and labor operation 12650D and 12650D10 of the Service Labor Time Standards (SLTS) Manual.
TSB 25-24872025-10-22. Service bulletin. POWER TRAIN. Some vehicles listed in the Model Section above may exhibit diagnostic trouble codes (DTCs) P3426, P3402, P3450, and/or P3442 stored in the PCM. This may be due to a restriction in the cylinder deactivation solenoid oil feed tube.
TSB 25-24232025-10-02. Service bulletin. POWER TRAIN. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: - No upshift past second gear - Unable to achieve third gear ratio - Illuminated malfunction indicator lamp (MIL) with DTCs P0757 and P2701 This may be due to a damaged one-way clutch (OWC).
SSM 541942025-09-08. Other. POWER TRAIN; UNKNOWN OR OTHER. Some 2021-2025 F-150 vehicles built on or before 30-Apr-2025 equipped with the 9.75" rear axle (minor feature code EGPAF) may exhibit a drive pinion seal leak. To confirm a vehicle is built with a minor feature code EGPAF, review the build information by double-clicking the vehicle identification number in the upper left-hand corner in the Professional Technician System (PTS). This may be due to the rear axle drive pinion seal. To correct this condition, replace the rear axle drive pinion seal with revised part number NL3Z-4676-A. Refer to Workshop Manual (WSM), Section 205-02. For claiming, use causal part number 4676 and labor operation 4676A.
25B092025-08-01. Other. POWER TRAIN. Certain 2024-2025 Model Year F-150 Vehicles Equipped With Floor Console Gear Shift Module (GSM) On all of the affected vehicles, the GSM may experience a malfunction and the floor console GSM shifter may be unable to stow or un-stow when the gear shift stow button is pressed and an illuminated wrench light will be displayed on the Instrument Panel Cluster (IPC). The vehicle may be inoperable if the shifter is in the stowed position when the malfunction occurs. If the shifter is not in the stowed position when the malfunction occurs, the customer will still be able to drive the vehicle and may observe a wrench light on the IPC
TSB 25-23242025-07-25. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN. This article supersedes TSB 25-2276 to update the service procedure to include information where to find connector/pin location in wiring diagram and WSM info to perform PMI and TRON for GSM replacement. Some of the vehicles listed in the Model statement above equipped with a console gear shift module (GSM) may exhibit at least one of the following conditions: * Clicking sound coming from shifter after it is placed and kept in reverse, neutral or drive position (2024 only) * Shifter will not shift out of park/into park * Shifter will not shift out of gear * Shifter will not stow/unstow * Shifter will move past the park position * Loose shifter lever arm at pivot * Illuminated powertrain malfunction (wrench) indicator with active DTC P0929:77, P0929:00, P0929:07 and/or P0929:9A stored in the GSM This may be due to a faulty GSM and/or connector C211 pin push out on circuit CCB61 or an open on circuit CCB61, between the anti-lock brake system (ABS) module and the body control module (BCM). Note: If the gear shifter lever will not shift into park, the transmission will automatically shift in
TSB 25-22932025-07-08. Service bulletin. POWER TRAIN. Some of the vehicles listed in the Model statement above may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P0300:00 and P0316:00 stored in the powertrain control module (PCM). This may be due to the software in the PCM.
SSM 540092025-07-08. Service bulletin. POWER TRAIN; ENGINE. Some 2023-2025 F-150 Raptor vehicles equipped with a 5.2L engine may exhibit an exhaust rattle/rasp on a cold start. The Workshop Manual (WSM), Section 309-00 Exhaust System - 5.2L 32V Ti-VCT - Supercharged > Diagnosis and Testing > Exhaust system > Pinpoint Test D: Noises Such As Buzzing, Drumming, Thumping, Ringing Or Hissing Coming From Exhaust System has been updated to address exhaust rattling sounds during a cold start lasting for 5 seconds or less as a normal condition. For concerns with exhaust rattles lasting longer than 5 seconds, follow WSM Section 309-00 Exhaust System - 5.2L 32V Ti-VCT - Supercharged > Diagnosis and Testing > Exhaust system.
PT-25.11.0 F-1502025-07-03. Over-the-air update. POWER TRAIN. Quality improvements include: -On-Board Diagnostics calibration for an enhanced Intake Air Temperature sensor performance
SSM 539732025-07-02. Service bulletin. POWER TRAIN; ENGINE. Some 2021-2024 Edge/Nautilus, 2021-2025 Bronco/Bronco Sport/E-Series/Escape/Corsair/Expedition/Navigator/Explorer/Aviator/F-150/F-Super Duty/Mustang/Ranger, and 2022-2025 Maverick vehicles may require an A/C compressor clutch assembly replacement be performed for various concerns. Workshop Manual (WSM), Section 412-00 Removal and Installation has been updated to eliminate the need to remove and install the A/C compressor to change out the A/C Compressor clutch assembly.
TSB 25-22762025-06-24. Service bulletin. SERVICE BRAKES; POWER TRAIN. This article supersedes TSB 25-2045 to update the production fix date and add model years. Some of the vehicles listed in the Model statement above equipped with a console gear shift module (GSM) may exhibit at least one of the following conditions: * Clicking sound coming from shifter after it is placed and kept in reverse, neutral or drive position (2024 only) * Shifter will not shift out of park/into park * Shifter will not shift out of gear * Shifter will not stow/unstow * Shifter will move past the park position * Loose shifter lever arm at pivot * Illuminated powertrain malfunction (wrench) indicator * DTC P0929:77, P0929:00, P0929:07 and/or P0929:9A This may be due to a faulty GSM and/or connector C211 pin push out on circuit CCB61 or an open on circuit CCB61, between the anti-lock brake system (ABS) module and the body control module (BCM). Note: If the gear shifter lever will not shift into park, the transmission will automatically shift into park when the return to park function is triggered.
SSM 538782025-06-11. Service bulletin. POWER TRAIN. Some 2021-2025 Expedition/Navigator and 2021-2025 F-150 non-Lightning/non-PowerBoost vehicles may exhibit a rattle/scraping noise from the bellhousing area on start-up. This may be due to the torque converter studs contacting the engine to transmission spacer plate (separator plate). To correct this condition, inspect the engine to transmission spacer plate and torque converter studs for wear/damage. If wear/damage is found, replacement of the torque converter is not necessary. Replace only the engine to transmission spacer plate. Refer to Workshop Manual (WSM) Section 303-01 > Engine to Transmission Spacer Plate for full spacer plate removal and installation. When reinstalling the starter motor, make sure the starter is flush with the engine to transmission spacer plate prior to tightening the studbolts. Failure to do so may result in damaging the newly installed engine to transmission spacer plate.
TSB 25-22462025-06-10. Service bulletin. POWER TRAIN. This article supersedes TSB 25-2165 to update the labor operation allowance and update the Service Procedure. Some of the vehicles listed in the Model statement above may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P2450 stored in the powertrain control module (PCM). This may be due to the software level of the PCM.
SSM 537642025-05-21. Service bulletin. POWER TRAIN; ENGINE. Some 2020 Continental, 2020-2024 Edge/Nautilus, 2020-2025 Explorer/Aviator/Escape/Corsair/F-150/F-Super Duty/Ranger/Transit/E-Series, 2021-2025 Bronco, and 2022-2025 Maverick vehicles may require an engine cooling system flush to be performed for various concerns. Workshop Manual (WSM), Section 303-03 has been updated to eliminate the need to remove and install the radiator assembly to perform a radiator flush.
TSB 25-21652025-05-14. Service bulletin. POWER TRAIN. Some of the vehicles listed in the Model statement above may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P2450 stored in the powertrain control module (PCM). This may be due to the software level of the PCM.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.