Recalls that may apply to the 1984 Ford E-350
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 89V140000 | 1989-08-15. VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:HEATER CORE. HEATER HOSE MAY BE INCORRECTLY ROUTED. Built 1982-08-01 to 1986-07-01. |
|---|---|
| 89V062000 | 1989-04-17. ELECTRICAL SYSTEM:WIRING. NYLON TIES THAT SUPPORT THE MAIN WIRING HARNESS TO THE CHASSIS COULD WEAR AND BREAK DUE TO EXCESSIVE VIBRATION. THUS, WIRING HARNESS COULD FALL ON ENGINE COMPONENTS AND SHORT CIRCUIT. Built 1983-01-01 to 1989-02-01. |
| 88V133000 | 1988-08-09. ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS. EXTREME OPERATING CONDITIONS COULD CAUSE PREMATURE DETERIORATION OF THE ENGINE COMPARTMENT HEATER HOSES OR ENGINE BYPASS HOSES. Built 1977-01-01 to 1987-07-01. |
| 87V144000 | 1987-09-09. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. VEHICLES ARE SUBJECT TO EXCESSIVE UNDERHOOD TEMPERATURES AND FUEL SYSTEM PRESSURES IN SEVERE DUTY APPLICATIONS. Built 1983-08-01 to 1987-08-01. |
| 87V113000 | 1987-07-21. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. EXPULSION OF FUEL DUE TO OVERPRESSURIZATION. Built 1983-08-01 to 1987-08-01. |
| 87V111000 | 1987-07-16. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING. FUEL LEAK AT THE TOP OF THE FRONT FUEL TANK IN THE AREA OF THE VAPOR VALVE GROMMET. GROMMET MAY SPLIT DUE TO COMPRESSIVE LOAD WHEN INSTALLED IN THE FUEL TANK. Built 1983-08-01 to 1987-08-01. |
| 86V092000 | 1986-07-14. POWER TRAIN:DRIVELINE:DRIVESHAFT. COMPOSITE GRAPHITE DRIVESHAFTS ARE SUBJECT TO OVERHEATING WHILE IDLING, WHICH MAY RESULT IN THE DRIVESHAFT TWISTING AND SHORTENING CAUSING THE SLIP YOKE TO DISCONNECT FROM THE TRANSMISSION. CONSEQUENCE OF DEFECT: IF THE DRIVESHAFT DISCONNECTS FROM THE TRANSMISSION THE VEHICLE WOULD BECOME IMMOBILE WITHOUT WARNING. Built 1983-07-01 to 1985-11-01. |
| 85V061000 | 1985-05-14. FUEL SYSTEM, DIESEL. WHEN FRONTALLY IMPACTED INTO A FIXED BARRIER AT 30 MPH, AS SPECIFIED IN FEDERAL MOTOR VEHICLE SAFETY STANDARD (FMVSS) NO. 301, THE LEFT FRAME RAILS OF SUCH VEHICLES MAY DISPLACE INBOARD, PINCHING THE FUEL/WATER SEPARATOR CANISTER BETWEEN THE FRAME RAIL AND ENGINE SUFFICIENTLY TO DISPLACE THE FUEL/WATER SEPARATOR DRAIN ROD, ALLOWING THE CONTENTS OF THE CANISTER TO DRAIN. CONSEQUENCE OF DEFECT: FUEL LEAK DURING OR AFTER A CRASH INCREASES THE POSSIBILITY OF A FIRE. Built 1983-03-01 to 1985-04-01. |
| 84V119000 | 1984-10-02. FUEL SYSTEM, GASOLINE:CARBURETOR SYSTEM. THE SECONDARY THROTTLE SHAFT MAY, WITH ACCUMULATED MILEAGE, BECOME CONTAMINATED AND MAY STICK IN A PARTIALLY OPEN POSITION WHILE DRIVING. Built 1983-08-01 to 1984-03-01. |
| 84V034000 | 1984-03-23. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING. ATTACHING BOLTS ON FUEL TANK SUPPORTS MAY NOT HAVE BEEN ADEQUATELY TIGHTENED; ALSO, THE SUPPORTS ARE TOO THIN. HIGH LEVELS OF STRESS, WHICH COULD OCCUR UNDER NORMAL OPERATING CONDITIONS, COULD CAUSE CRACKS TO DEVELOP IN THE SUPPORT STRAPS. IF THE FUEL TANK SUPPORTS FRACTURE, THE FUEL TANK WILL SLIP FROM THE NORMAL POSITION, AND FUEL LEAKAGE COULD RESULT. Built 1979-09-01 to 1983-12-01. |
| 84V014000 | 1984-01-07. WHEELS. SOME VEHICLES MAY HAVE BEEN BUILT WITH IMPROPERLY MANUFACTURED WHEELS. THE WELDS SECURING THE CENTER SECTIONS TO THE RIMS MAY CRACK FROM FATIGUE. Built 1983-11-01 to 1983-12-01. |
| 83V094000 | 1983-09-21. FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS. FUEL SUPPLY TUBES INSTALLED IN THE AFFECTED VEHICLES ARE TOO SHORT. CONSEQUENTLY, FLEXIBLE HOSES THAT ATTACH TO THE TUBES MAY BE TAUT AND THIS WOULD HAVE AN ADVERSE EFFECT ON THE DURABILITY OF HOSE CONNECTIONS. IN THE EVENT OF HOSE SEPARATION, SOME FUEL SPILLAGE WOULD OCCUR. Built 1983-08-01 to 1983-08-01. |
| 1991125 | 1991-09-11. Structure. THE AIR DEFLECTOR MAY BE INADEQUATELY BONDED TO THE TRUCK BODY AND MAY SEPARATE AT HIGH SPEED. A DETACHED DEFLECTOR COULD BE HAZARDOUS TO OTHER VEHICLES. CORRECTION: AIR DEFLECTORS WILL BE INSPECTED FOR SIGNS OF SEPARATION. IF SIGNS OF SEPARATION ARE FOUND, THE DEFLECTOR WILL BE REFASTENED USING RIVETS. |
|---|---|
| 1988140 | 1988-10-06. Heater And Defroster. EXTREME OPERATING CONDITIONS COULD CAUSE PREMATURE DETERIORATION OF THE ENGINE COMPARTMENT HEATER HOSES OR ENGINE BYPASS HOSES. ENGINE COOLANT COULD DISCHARGE ONTO THE ENGINE AND ITS EXHAUST MANIFOLD CREATING THE POTENTIAL FOR A FIRE DUE TO HIGH ENGINE EXHAUST MANIFOLD TEMPERATURES. CORRECTION: HOSES AND RADIATOR CAPS WILL BE REPLACED AND ON CERTAIN VEHICLES, A HIGH HEAT RESISTANCE ALUMINIZED STAINLESS STEEL MUFFLER WILL BE INSTALLED. |
| 1987105 | 1987-10-07. Structure. 1983-87 E-250 AND 350 WITH 7.5 LITRE AND 1985-87 HEAVY DUTY E-250 AND 350 WITH 5.8 LITRE 4V ENGINE AND A GVW OVER 8,500 LBS. THESE VEHICLES HAVE BEEN DETERMINED TO GENERATE EXCESSIVE UNDERBODY TEMPERATURES AND FUEL SYSTEM PRESSURES IN SEVERE DUTY APPLICATIONS, PARTICULARLY IF FUELED WITH OVERLY VOLATILE GASOLINE. THIS CAN CREATE AN ABNORMAL POTENTIAL FOR EXPULSION OF LIQUID FUEL FROM THE FILLER PIPE UPON REMOVAL OF THE FUEL TANK FILLER CAP. IN THE PRESENCE OF AN IGNITION SOURCE, A VEHICLE FIRE COULD OCCUR. CORRECTION: VEHICLES WILL BE MODIFIED TO MINIMIZE THE POSSIBILITY OF FUEL EXPULSION AND SHIELD UNDERBODY COMPONENTS FROM EXCESSIVE UNDERBODY HEAT. NOTE: E250 AND 350 CLUB WAGONS AND ECONOLINE VANS AND CHASSIS. |
| 1987094 | 1987-08-25. Fuel System. ON AMBULANCES EQUIPPED WITH 7.5 LITRE ENGINES,VARIOUS FACTORS MAY CAUSE EXCESSIVE UNDERBODY TEMPERATURES OR FUEL SYSTEM OVERPRESSURIZATION WHICH COULD RESULT IN FUEL LEAKS OR EXPULSION OF FUEL FROM THE FILLER PIPES WHEN THE FILLER CAPS ARE REMOVED. IN THE PRESENCE OF AN IGNITION SOURCE A VEHICLE FIRE OR INJURIES COULD RESULT. CORRECTION: THE FUEL VENTING AND EMISSION CONTROL SYSTEMS WILL BE MODIFIED AND VEHICLES INSPECTED FOR SIGNIFICANT DISCREPANCIES. |
| 1986078 | 1986-07-17. Structure. E350 RV AND COMMERCIAL CUTAWAY ECONOLINE VEHICLES. SOME VEHICLES WHERE COMPLETED WITH BODIES WHICH RESTRICTED THE DISSAPATION OF UNDERBODY HEAT.IN SUCH A CASE EXTENDED IDLING COULD OVERHEAT THE COMPOSITE GRAPHITE DRIVESHAFT AND,IF A HIGH START UP TORQUE APPLIED,TWIST AND SHORTEN THE DRIVESHAFT CAUSING THE SLIP YOKE TO DISCONNECT. CORRECTION:METAL DRIVESHAFTS WILL BE INSTALLED. |
| 1985062 | 1985-05-17. THESE VEHICLES (VANS AND CLUB WAGONS) DO NOT COMPLY WITH C.M.V.S.S. 301-FUEL SYSTEM INTEGRITY. |
| 1984044 | 1984-08-08. ON E350 SHUTTLE BUSES THE RETAINER STRAPS FOR THE MIDSHIP FUEL TANKS ARE ATTACHED TO TWO FUEL TANK CROSSMEMBER SUPPORTS. THESE SUPPORTS MAY BE SUSCEPTIBLE TO DURABILITY FRACTURES AT THE INBOARD ATTACHMENT LOCATIONS FOR THE STRAPS. IF THE SUPPORTS AT THE INBOARD ATTACHMENTS WERE TO FRACTURE,THE FUEL TANK WOULD DROP ABOUT ONE INCH BEFORE BEING RESTRAINED BY THE RIGID STRAPS AND CREATE THE POTENTIAL FOR FUEL SPILLAGE. |
| 1984020 | 1984-02-07. THE ARC WELDS SECURING THE WHEEL CENTRE SECTIONS TO THE RIMS MAY BE SUSCEPTIBLE TO FATIGUE CRACKING. IF SUCH CRACKS WERE TO PROPOGATE, THERE IS A POTENTIAL FOR A GRADUAL LOSS OF TIRE PRESSURE OR SEPARATION OF THE WHEEL RIM AND TIRE ASSEMBLY FROM THE VEHICLE. THIS COULD CAUSE LOSS OF VEHICLE CONTROL. |
| 1983111 | 1983-12-14. TRUCKS WITH 5.8 LITRE ENGINES. THESE VEHICLES DO NOT COMPLY WITH CMVSS 1103 - HYDROCARBON AND CO. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.