WenmarOpen by Wenmar Pro

Service bulletins for the 2025 Ford Bronco

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

103 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Suspension are shown. Show all

Bulletins, newest first
TSB 26-23802026-09-29. Service bulletin. SUSPENSION; ELECTRICAL SYSTEM; STRUCTURE:BODY; UNKNOWN OR OTHER. This article supersedes TSB 25-2575 to update the Parts list to add the applicable body wiring harnesses and underbody shield bolts. Some vehicles listed in the Model statement above may exhibit a "Sta-bar Disconnect Service Required" message in the instrument panel cluster (IPC) with any of the following diagnostic trouble codes (DTCs) stored in the chassis control module (CHCM): C103A, C1A99, C1B03, C1B07, C1B14 and/or B1A67. This may be due to water intrusion in the stabilizer bar wiring harness connector.
SSM 548072026-05-14. Service bulletin. SUSPENSION; ELECTRICAL SYSTEM; UNKNOWN OR OTHER; FORWARD COLLISION AVOIDANCE: ADAPTIVE CRUISE CONTROL. Some 2025-2026 Bronco vehicles may exhibit various cruise control, pre-collision and/or front stabilizer bar disconnect related warning messages displayed in the instrument panel cluster (IPC) with diagnostic trouble code (DTC) U0418:86 stored in the image processing module A (IPMA). DTC U0415:00 may also be stored in the CHCM. <br /><br /> If wheel speed sensor specific DTCs are present in the anti-lock brake (ABS) module and/or warning messages other than those listed above are present, this SSM does not apply. Refer to the Workshop Manual (WSM) for normal diagnostics. <br /><br /> If a vehicle exhibits this condition, carefully inspect the rear wheel speed sensors for correct installation with the rear wheel speed sensor body seated flush against the axle housing. Repair or replace the affected rear wheel speed sensor as needed, clear the DTC, and retest. Refer to WSM, Section 206-09. <br /><br /> This condition does not affect vehicle durability, and additional diagnosis or service is not recommended at this time. Replacement or reprogramming of the IPMA and/or ABS modules will not resolve this
TSB 25-25752025-12-02. Service bulletin. SUSPENSION; ELECTRICAL SYSTEM. This article supersedes TSB 24-2104 to update the vehicle model years affected. Some vehicles listed in the Model statement above may exhibit a "Sta-bar Disconnect Service Required" message in the instrument panel cluster (IPC) and an illuminated warning light with any of the following diagnostic trouble codes (DTCs) stored in the chassis control module (CHCM): C103A, C1A99, C1B03, C1B07, C1B14 and/or B1A67. This may be due to water intrusion in the stabilizer bar wiring harness connector.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.