WenmarOpen by Wenmar Pro

Service bulletins for the 2023 Ford Bronco Sport

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

114 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Brakes are shown. Show all

Bulletins, newest first
TSB 23-23082023-11-02. Service bulletin. SERVICE BRAKES, AIR:DISC:CALIPER; POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:BEARINGS/BUSHINGS; EQUIPMENT. Some 2020-2023 Escape and 2021-2023 Bronco Sport vehicles may exhibit a moan noise when the vehicle is driven in reverse (R) in cold weather and/or high humidity. This may be due to the suspension sensitivity of the vehicle. To correct this condition, follow the Service Procedure to replace the standard and reinforced rear caliper bushings and apply Kluberpaste to the machined surfaces of the brake caliper and caliper support bracket.
SSM 519482023-10-06. Service bulletin. EQUIPMENT; SERVICE BRAKES, AIR:ANTILOCK:WHEEL SPEED SENSOR. Some 2023 Escape, Corsair, Bronco Sport and Maverick vehicles built on 01-May-2023 and through 22-Sep-2023 may exhibit a squeal and/or grinding noise and/or vibration from the front brakes while braking. This may be due to excessive wheel hub lateral runout. To correct this condition, remove the front brake disc(s) of the affected wheel(s). Refer to the Workshop Manual (WSM), Section, 206-03. Clean the raised ring-like surface of the front wheel hub near the wheel studs. Using a dial indicator, slowly rotate the wheel hub and measure the runout on the ring-like surface. If the total runout exceeds 0.001 inch (0.03mm), replace the wheel hub. Refer to the WSM, Section 204-01. Document the measured run out in the warranty claim. For claiming use the causal part number 1104 and applicable labor operations in Section 01 of the Service Labor Time Standards (SLTS)
SSM 512612023-01-06. Service bulletin. SERVICE BRAKES. Some Ford and Lincoln vehicles may exhibit noise when the brakes are applied. When diagnosing and repairing brake noise conditions, use the Workshop Manual (WSM) and the appropriate pinpoint test in section 206-00. The brake rotors should only be machined if directed by the WSM because one or more of the following conditions are present on the braking surface: scoring, excessive corrosion/rust or pitting, bluing/discoloration and/or heat spots. For additional information, refer to WSM section 206-00.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.