Service bulletins for the 2019 Dodge Durango
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
404 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Engine are shown. Show all
| S2109000004 | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle. |
|---|---|
| S1809000007RevC | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Customer Complaint May Include Engine Oil Leak Or Consumption |
| S2209000002 | 2022-09-26. Service bulletin. UNKNOWN OR OTHER; ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. When performing diagnosis, an internal engine concern may be suspected. |
| 9004226 | 2022-09-26. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING; POWER TRAIN. TUBE, Coolant outlet (Rear Heater Return Line) Be advised, Mopar does offer rear coolant line repair kits for MY 2018 - 2020 vehicles for coolant leak repair. Please see TSB 23-023-20 for kit part numbers and instructions. If looking to replace the rear heater line due to a rub through from the trans oil heater (TOH) line clamp on the engine side: 1) Rotate the tangs on the clamp towards the transmission and out of the direction of the rear heater line 2) Adjust the TOH line by pushing it towards the engine to increase clearance between the TOH line and rear heater line. |
| 1808919 | 2022-09-15. Service bulletin. ENGINE AND ENGINE COOLING. wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK |
| 04-001-21 | 2022-08-22. Service bulletin. ENGINE AND ENGINE COOLING. Pentastar Upgrade Oil Fill Level after an Oil Change This bulletin involves rechecking the oil fill level after filling the engine to the correct specifications. The customer may describe that after an oil change they check their oil fill level and it is showing overfilled on the oil dipstick. |
| S2108000024 Rev. | 2022-07-18. Service bulletin. ELECTRICAL SYSTEM:STARTER ASSEMBLY; ENGINE AND ENGINE COOLING:ENGINE:CRANK/CAMSHAFT POSITION SENSOR. Crank No Start Condition, No DTC?s |
| S1709000010 Rev. | 2022-07-18. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:CRANK/CAMSHAFT POSITION SENSOR. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear (roller failure) on one or more cam lobes and that camshaft/lifter replacement is necessary. |
| S1809000007 | 2022-05-31. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. Customer Complaint May Include Engine Oil Leak Or Consumption |
| S2209000002 | 2022-05-31. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. When performing diagnosis, an internal engine concern may be suspected. |
| S1809000007 Rev. | 2021-04-26. Service bulletin. ENGINE AND ENGINE COOLING. Customer complaint may include engine oil leak/consumption. |
| 9004226 | 2021-03-15. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:ELECTRICAL:ENGINE BLOCK HEATER. TUBE, Coolant outlet (Rear Heater Return Line) Be advised, Mopar does offer rear coolant line repair kits for MY 2018 - 2020 vehicles for coolant leak repair. Please see TSB 23-023-20 for kit part numbers and instructions. If looking to replace the rear heater line due to a rub through from the trans oil heater (TOH) line clamp on the engine side: 1) Rotate the tangs on the clamp towards the transmission and out of the direction of the rear heater line 2) Adjust the TOH line by pushing it towards the engine to increase clearance between the TOH line and rear heater line. |
| S1908000083 Rev. | 2021-03-01. Service bulletin. ENGINE; ELECTRICAL SYSTEM. Check Engine Light Illuminated, Stop Start Function Inoperative |
| S2108000024 Rev. | 2021-02-16. Service bulletin. ENGINE AND ENGINE COOLING. Crank No Start Condition, No DTC?s |
| S2109000001 | 2021-02-16. Service bulletin. ENGINE AND ENGINE COOLING. Customer may complain of a MIL lamp on. Upon further investigation there could be a fault code in the PCM for P1524 ? Oil Pressure Out of Range ? Camshaft Advance/Retard Disabled. |
| S1709000010 Rev. | 2021-02-16. Service bulletin. ENGINE AND ENGINE COOLING. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear (roller failure) on one or more cam lobes and that camshaft/lifter replacement is necessary. |
| S1921000007 Rev. | 2020-10-26. Service bulletin. ENGINE AND ENGINE COOLING. (Revision A) Engine Restarting On Stop/Start Event Without Releasing The Brake Pedal, EVIC Displays Shift To P Then Desired Gear, D on PRNDL Flashing |
| 9001496 | 2020-10-26. Service bulletin. ENGINE; EQUIPMENT. CAP, Engine Oil, Fill (O RING, Oil Filler Cap) For all model years, models and engines using oil fill caps with O-Ring seals: These O-Rings are now available for service. The green O-Ring is part 68029299A$. The black O-Ring is to be serviced by the green O-Ring. The blue O-Ring (thicker cross section than green & black) is part 68029300A$.~ If ordering this oil filler cap for a warranty repair due to a damaged/missing O-ring, please note that returned caps replaced for an O-ring issue will be subject to chargeback. |
| 23-023-20 | 2020-09-28. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; ENGINE AND ENGINE COOLING. Rear Heater Coolant Tube Repair This bulletin involves inspecting and possibly repairing the rear heater coolant return tube. Customers may comment on one or more of the following:A coolant leak or fluid appearing from under the vehicle. Elevated engine coolant temperature and/or indication of overheating. |
| S2008000113 | 2020-09-28. Service bulletin. ENGINE; ELECTRICAL SYSTEM. No Start Intermittently, Vehicle Requires Multiple Keyless Push To Start Attempts To Start Vehicle |
| S1909000002 | 2020-06-22. Service bulletin. EQUIPMENT; ENGINE. Customer complaint may include an overfilled engine crankcase after an oil change. |
| 9004171 | 2020-01-21. Service bulletin. ENGINE AND ENGINE COOLING. COVER, Cylinder Head, Left/Right Prior to replacing the cylinder head cover on ANY 3.6L Pentastar Upgrade Engine, verify that there are no steel dowel pins pressed into the cylinder head. If dowels are present in the cylinder head please remove carefully without touching/damaging the cylinder head sealing surface. |
| 18-089-19 | 2019-12-16. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE. wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK |
| 04-001-19 | 2019-10-28. Service bulletin. ENGINE. Pentastar Upgrade Oil Fill Level after an Oil Change This bulletin involves rechecking the oil fill level after filling the engine to the correct specifications. The customer may describe that after an oil change they check their oil fill level and it is showing overfilled on the oil dipstick. |
| 9003680 | 2019-10-28. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING. RETAINER, Crankshaft Rear Oil Seal Oil leak from rear engine seal retainer or windage tray/gasket Check for other sources of leaks using dye such as gallery plugs, camshaft cup plug at rear of engine, rear of engine valley for possible MDS solenoid, VVT solenoid, block porosity or transmission leaks. If another source of the leak was identified, proceed with the appropriate repairs. Engineering is looking for assistance in determining root cause and a corrective action on crankshaft rear oil seals and windage tray/gaskets. For concerns related to rear crankshaft seal oil leaks and windage tray gaskets, please send an email to brenton.swank@fcagroup.com. Include the VIN, mileage, and any photos identifying where the leak is coming from using dye, such as: 1. Leak between rear seal and crankshaft (seal rolled during installation) 2. Leak between outer diameter of rear seal and retainer 3. Leak between rear seal retainer and engine block (Please record the 5 retainer bolts residual torque in tightening direction) 4. Leak between rear seal retainer and windage tray/gasket (Please record the oil pan bolts residual torque in tightening direction) If the source of the leak cannot be identified, please contact Brenton Swank at (248) 804-9386 or Brenton.Swank@FCAGroup.com If no response in 15 minutes, proceed with repair. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.