WenmarOpen by Wenmar Pro

Service bulletins for the 2013 Dodge Charger

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

259 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
S20080001132022-09-26. Service bulletin. ELECTRICAL SYSTEM. No Start Intermittently, Vehicle Requires Multiple Keyless Push To Start Attempts To Start Vehicle, Intermittent Key Not Detected Message
S18210000012022-09-26. Service bulletin. POWER TRAIN. Gear Ratio DTC?s, Transmission Shift Concerns, Does Not Shift At Times, Shudders
90040092022-09-26. Service bulletin. POWER TRAIN. Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.
0900214REVB2022-09-26. Service bulletin. EXTERIOR LIGHTING; FUEL SYSTEM, GASOLINE. MIL Illumination: P0300, P0302, P0304 or P0306 (X56 Warranty Extension) This bulletin involves checking for excessive cylinder leakage and replacing the cylinder head if necessary. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that any the following Diagnostic Trouble Codes have been set: P0300- Multiple Cylinder Misfire P0302- Cylinder 2 Misfire P0304- Cylinder 4 Misfire P0306- Cylinder 6 Misfire
21041142022-09-26. Service bulletin. AIR BAGS; POWER TRAIN. 845RE Harsh 2-1 Downshift This bulletin involves replacing the transmission valve body. A small number of customers may experience a bump sensation during a 2-1 downshift. This condition can occur at any transmission temperature and is most noticeable during light braking or while coasting to a stop. No Diagnostic Trouble Codes (DTCs) will be set as a result of this.
21012142022-09-26. Service bulletin. POWER TRAIN. 8 Speed Transmission Shift Adaptation, Drive Learn Procedure This bulletin involves performing a Transmission Adaptation Learn procedure based on a subjective shift quality rating evaluation.The adaptation drive learn procedure must be performed on all 8-speed transmissions when the transmission is repaired/replaced and/or the Valve Body/TCU assembly (mechatronic) is replaced, or when the adaptation memory cells are cleared with the wiTECH diagnostic scan tool. Customers may indicate that their transmission shift quality does not meet their expectations.
21028142022-09-26. Service bulletin. POWER TRAIN; AIR BAGS; ELECTRICAL SYSTEM. Flash: Transmission Shift Enhancements This bulletin involves selectively erasing and reprogramming the Transmission Control Module (TCM) with new software. The following Transmission Control Module (TCM) calibration improvements are available for vehicles equipped with WA580 Automatic Transmission (Sales Code DGJ) and are broken down per engine application.3.6L Engine Hanging in gear during HOT ambient temperature conditions and high engine loads. Excessive pedal needed to downshift in high altitudes (i.e. passing). Poor shift quality, or high transmission temperatures during track or sport driving.5.7L Engine Hanging in gear at high engine speeds during aggressive driving. Gear shift point enhancements during high load or race track driving. Excessive pedal needed to downshift in high altitudes (i.e. passing). Poor shift quality or high transmission temperatures during track or sport driving. Improved acceleration response from speeds greater than 36 Mph (58 Kph) (Japan Market Only). Bump sensation felt during deceleration or braking.6.4L Engine Bump sensation felt during deceleration or braking. Inconsistent downshift during Wide Open Throttle (WOT) accelerations at highway speeds (i.e. passing). Transmission enhancements to improve acceleration while in reverse going uphill on steep grades.3.0L Engine (LX Only) Erratic excessive shifting during low speed, light pedal driving.
08040142022-09-26. Service bulletin. VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM. Police Vehicle A/C Inoperative This bulletin involves relocating the A/C fuse within the front Power Distribution Center (PDC). Customer comments A/C is warm. On further inspection the technician will notice the A/C clutch fuse is loose in its cavity (#12) in the PDC. This will cause a poor connection and the fuse cavity to be distorted.
90043612022-09-26. Service bulletin. POWER TRAIN. NAG1 Transmission Before installing the transmission with the engine, check for dowel pins (2) for alignment. If the pins are missing request to add the dowel pin first and then install the transmission
S1709000010RevB2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:CRANK/CAMSHAFT POSITION SENSOR; UNKNOWN OR OTHER. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear (roller failure) on one or more cam lobes and that camshaft/lifter replacement is necessary.
1808816B2022-09-26. Service bulletin. POWER TRAIN. Powertrain diagnostic and system enhancement.
08047132022-09-26. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM. Flash: Inaccurate Outside Temperature Display This bulletin involves updating the Body Control Module (BCM) software. Customer may experience a delay to update the ambient air temperature display with the actual ambient air temperature. This condition is more noticeable during short/slow commutes and with a large ambient air temperature increase between drive cycles.
08043132022-09-26. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN. Flash: SRT Auto Transmission, Adding Launch Control Feature This bulletin involves updating the Anit-lock Brake System (ABS) module, Cluster and Totally Integrated Power Module (TIPM), if required. The customer may note that the launch control feature is missing.
31005192022-09-15. Service bulletin. STRUCTURE. Use of Aftermarket Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of aftermarket parts.
31003192022-09-15. Service bulletin. STRUCTURE. Use of Salvage/Recycled Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of recycled or salvage parts.
31004192022-09-15. Service bulletin. VISIBILITY. Authentic Mopar® Glass Replacement This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the recommended usage of Authentic Mopar® Glass.
31006192022-09-15. Service bulletin. STRUCTURE; EQUIPMENT. Repair Parts Used For Structural Repairs This bulletin involves discussing FCA US LLC position with regard to structural repair parts usage.
90031092022-09-15. Service bulletin. VISIBILITY:WINDSHIELD WIPER/WASHER. Washer Fluid Level Sensor Prior to replacing this part due to "Low Washer Fluid" tell tale light on the dash and the washer fluid bottle is full, please perform this inspection: Check if float sensor is rotated off location from the bottle anti-rotation features that surround the SENSOR. Check to determine if the issue has been resolved. Continue with repair if necessary. Please contact Chris Koch at cell (248) 248-622-6417 if you have questions or need additional information.
CHRYSLER2022-09-15. Service bulletin. BACK OVER PREVENTION; VISIBILITY; EXTERIOR LIGHTING; LANE DEPARTURE. The customer may experience the blind spot monitor indicator in either outside mirror maybe flashing or on continuously.
21-012-142022-08-29. Service bulletin. POWER TRAIN. Transmission Shift Enhancements - Adaptation Drive Learn Procedure This bulletin involves performing a subjective shift quality rating when customers experience poor shift quality and if necessary, performing the transmission adaptation learn procedure. In addition, this bulletin involves performing transmission adaptation learn procedure when the transmission is repaired/replaced and/or the valve body/TCU assembly (mechatronic) is replaced, or when the adaptation memory cells are cleared with the wiTECH diagnostic scan tool. Customers may indicate that their transmission shift quality does not meet their expectations.
90030812022-08-29. Service bulletin. ELECTRICAL SYSTEM. Dielectric Grease This product is no longer approved for use on ignition coil and spark plug boots. Current plug boot material(silicone) is not compatible with this grease and can cause deterioration over time.
Z5091195A2022-08-22. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL. RES / RHA / REB radio that supports Bluetooth and Hands-Free For issues with Bluetooth, Hands-Free Calling, and/or Voice Commands, DO NOT replace the radio. Diagnose the Hands-Free Module system (also called the Telematics Module). The Telematics Module (and associated components) is the system responsible for these features. A power cycle may be required for the hands-free module for proper diagnosis.~ Please reference; 8T - Navigation/Telecommunication Diagnosis and Testing (DIAGNOSIS AND TESTING - HANDS FREE PHONE)
02-007-142022-08-22. Service bulletin. BACK OVER PREVENTION; SUSPENSION; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); WHEELS. Front End Clunk Noise When Coming To A Stop - Police Vehicles Only This bulletin involves replacing the left side or the right side or both side tension struts. Police vehicles with heavy duty suspension and rear wheel drive may experience a front end clunk noise, coming from the tension strut bushing(s), while coming to a stop.
18086152022-08-22. Service bulletin. POWER TRAIN. Powertrain System Improvements/Enhancements.
1807415REVA2022-08-22. Service bulletin. POWER TRAIN. Powertrain Diagnostic And System Enhancements.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.