Service bulletins for the 2011 Chevrolet Volt
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1715 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| PIP5117 | 2017-08-15. Service bulletin. EQUIPMENT. This Preliminary Information communication provides information to the technician with a service repair tip about using caution during service procedures involving plastic components. Technicians will need to take special precautions when servicing today?s engines to avoid damage to these components. |
|---|---|
| PIC5856 | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This Preliminary Information communication provides information to the technician about vehicles that have Check Engine Lamp. Technician may find Diagnostic Trouble Code P0C58 and P0C62. Technician will need to replace the Motor B Position Sensor for this concern. |
| PIP4840J | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This Preliminary Information communication advises the technician that 4ET50 electric variable automatic transmission assembly and component will be placed on a parts restriction through the General Motors Technical Assistance Center. Dealer will need to contact General Motors Technical Assistance Center for further assistance. |
| PIT4720C | 2017-08-15. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. This Preliminary Information communication provides information to the technician that after replacing the Instrument Panel Cluster the exchange center is unable to program the actual mileage on the odometer or the actual mileage is unknown. Dealer will need to follow dealer to the General Motors service policies and procedures manual section 3.2.4 odometer servicing. |
| PIC5803C | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:12V/24V/48V BATTERY. This Preliminary Information communication provides information to the technician about vehicles that the vehicle did not fully complete a charge or that charging was interrupted. Technicians may find Diagnostic Trouble Codes P1E00 set in the Engine Control Module and P0D3E or P0D3F set in the Hybrid Powertrain Control Module. Technician will need to update the Battery Charger Control Module to address this concern. |
| PIC5322C | 2017-08-15. Service bulletin. SEATS; ELECTRICAL SYSTEM. This Preliminary Information communication advises the technician of a customer concern where the heated seat indicator light is not functioning or the heated seats are not up to operating temperature during a remote vehicle start event. This is normal operation of the heated seat during a remote vehicle start event. The electronic climate control module is not in a complete wake up state during a remote vehicle start mode and will not enable the light emitting diode. After a cold soak below 32 degrees Fahrenheit the seat will not get hot in the 10 minutes or less of the remote vehicle start mode. This is due to the fact that the heat element is not in direct contract with the seat surface while the seat is unoccupied and the foam below the heater is full cold insulating air which takes time to heat up. Technician is to communicate to the customer this condition is a normal operating characteristic of their vehicle. It will not impact the designed performance or reliability of the vehicle. Please share this information with the customer, including a copy of this message. |
| PIC4788E | 2017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This Preliminary Information communication provides information to the technician of diagnostic instructions to take when the key will not fold into the fob or will not stay in the folded position. The technician may comment that the key in the fob will not fold close or stay latched closed. Damage to the folding mechanism could result from storing the key in the door lock cylinder and accidently bumping or making contact with the key fob. Please advise all dealer personnel to refrain from storing the key in the door lock even for brief periods. |
| PIC4707D | 2017-08-15. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). This Preliminary Information communication provides information to the technician about vehicles that have at times the XM Traffic or Weather for the local area takes several minutes to update and may read "NO DATA" or "UPDATING" during that time. Technician should be advised that Traffic and Weather data from local reporting stations and then send the updated info process may take up to 24 minutes. Technician should test for full operation of the XM band if the system has not started receiving the Traffic and weather update within 30 minutes. Also ensure the customer has not shut XM NavTraffic off in the user settings of the navigation radio. Technician will need to contact XM customer assistance to review the account status and verify that the XM Traffic option has been enabled and is available in the area. |
| PIP5081A | 2017-08-15. Service bulletin. SERVICE BRAKES; POWER TRAIN:AXLE ASSEMBLY. This Preliminary Information communication provides information to the technician about vehicles that may have whistle, scrape or whine type noise while driving that may be more noticeable during regenerative braking. Technician may find this noise emanating from the left side of the drive unit. The tech may also state that the vehicle has a current or history diagnostic trouble code P0A46. The noise may be caused by the drive motor B rotor bearing cage separated. Technician should replace the bearing with the new updated part number. Technician should also inspect the end cover for any abnormal bushing wear, if found the side cover will also require replacement. |
| PIP4880C | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM:PROPULSION SYSTEM:TRACTION BATTERY; HYBRID PROPULSION SYSTEM: INVERTER; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician with the steps to diagnose and repair vehicles with a Malfunction Indicator Lamp on. Technician may find a Diagnostic Trouble Code P0335 and or P0336 stored in the Power inverter module. Technician will need to inspect G106 and G113 if the ground eyelet is not tight replacing the bolt with a shorter bolt. If either of the Diagnostic Trouble Codes P0335 or P0336 are stored in both the Engine Control Module and the Power inverter module or the codes are current, please follow published Service Information diagnostics. |
| PIC5412B | 2017-08-15. Service bulletin. BACK OVER PREVENTION: REARVIEW SYSTEM BRAKING. This Preliminary Information communication provides information to the technician about vehicles that may have a high-pitched whine noise during braking or accelerating. Technician will need to inspect the load floor, in the rear of the vehicle, for being properly secured. If the load floor is not fully seated check the cargo tray under the floor and insure everything is stowed in its own spot. An improperly stowed 120v charge cord set, cargo in the lower tray that can pop the load floor up, and damage to the load floor that causes the floor not to clip into place. |
| PIC5491B | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have an OnStar system that will not power up. Technician should turn off the ignition and cancel retained accessory power. After the vehicle has powered down, remove power to the OnStar module for five minutes. After the power has been removed for five minutes, if the OnStar system is working release the vehicle. If the OnStar system is still inoperative continue with published Service Information diagnostics. |
| PIT4945E | 2017-08-15. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This Preliminary Information communication provides information to the technician being unable to program fobs to the vehicle. Technician will need to ensure the key FOB is a new unit and has not been programmed to another vehicle previously. |
| PIP4884B | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have a Malfunction Indicator Lamp on after charging the vehicle. The condition may be more noticeable in cold ambient temperatures. Technician may find Diagnostic Trouble Code P0D22 stored. Technician should update the Hybrid Powertrain Control Module 2 with the latest calibrations in Tis-2-Web. |
| PIC5428D | 2017-08-15. Service bulletin. SERVICE BRAKES; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have the Antilock Braking System, Service Traction Control System, and/or Service Stabilitrak lights are on. The Electronic Brake Control Module may have one or more of the following Diagnostic Trouble Codes C0035-C0050 with specifically symptom 18, 5A, or 0F. Technician will gain access to the correct wheel bear per the Diagnostic Trouble Code that is set. If debris is found on the magnetic encoder ring it will needed to be cleaned. |
| PIC5829 | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician may find Diagnostic Trouble Code U0111. Technician will need to update Battery Energy Control Module with the latest calibrations in TIS-2-Web. |
| PIC5803B | 2017-08-15. Service bulletin. ENGINE; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that the vehicle did not fully complete a charge or that charging was interrupted. Technicians may find Diagnostic Trouble Codes P1E00 set in the Engine Control Module and P0D3E or P0D3F set in the Hybrid Powertrain Control Module. Dealer should communicate to the customer that we apologize for this inconvenience and that General Motors is working on a solution for this concern. |
| PIP3140E | 2017-08-15. Service bulletin. EQUIPMENT. This Preliminary Information communication advises the technician that a noise or a vibration in the vehicle that seems to be abnormal may not have been there when the vehicle was purchased. Technician should look for Non - General Motors aftermarket accessories installed on the vehicle that can cause these issues. |
| PIC5734B | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM; PARKING BRAKE. This Preliminary Information communication provides information to the technician about vehicles that have a drumming/ ringing like noise after depressing the brake pedal or a pulsation felt through the brake pedal while sitting still with your foot slightly depressing the brake pedal. Technician will need to reprogram the Electronic Brake Control Module with the latest calibration in Tis-2-Web. |
| PIC5803A | 2017-08-15. Service bulletin. ENGINE; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that the vehicle did not fully complete a charge or that charging was interrupted. Technicians may find Diagnostic Trouble Codes P1E00 set in the Engine Control Module and P0D3E or P0D3F set in the Hybrid Powertrain Control Module. Dealer should communicate to the customer that we apologize for this inconvenience and that General Motors is working on a solution for this concern. |
| PIP4871B | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that may have Malfunction Indicator Lamp on. Technician my find Diagnostic Trouble Code P1B0F and or Diagnostic Trouble Code P1B10 set in the Hybrid Powertrain Control Module. Dealer should explain to the customer that inadvertently shutting the vehicle off while in motion (out of park) may cause this Malfunction Indicator Lamp to illuminate, and this is design intent. |
| PIP5094 | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication advises the technician that, when testing any circuit for open or resistance, it is imperative that all related terminal pin fit and tension be checked when the test steps require disconnection of the connector or component, prior to any component replacement. Always use the recommended terminal test tool during these tests. |
| 00-03-10-002J | 2017-08-15. Service bulletin. WHEELS. This informational bulletin provides information on chemical staining, pitting, and corrosion on wheels and the proper cleaners to use to fix the conditions due to multiple causes. |
| PI0572C | 2017-08-15. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). This preliminary informational bulletin provides information on GM is implementing a new service strategy that uses a set of universal coaxial repair kits to service vehicles. This only applies to cable used for high frequency signals, such as cellular (OnStar®), satellite radio (XM) and GPS (navigation). The kits do NOT apply to the AM/FM cables. |
| PI0360F | 2017-08-15. Service bulletin. ELECTRICAL SYSTEM. This preliminary informational bulletin provides information on GM Accessory Remote start not working with onstars remotelink phone applications |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.