WenmarOpen by Wenmar Pro

Service bulletins for the 2010 Chevrolet Camaro

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1633 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
99-04-20-002H2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This technical bulletin provides a revision of 99-04-20-002G to add 2013-2014 model years.
13-00-89-0042018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This technical bulletin provides a revision of 10-00-89-017Z to include updated information.
PI0572B2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This preliminary information bulletin is for information on COAX Repair Kit Availability. Revised from PI0572A
12-06-01-009D2018-04-02. Service bulletin. EQUIPMENT. This informational bulletin provides information for installing the camshaft timing chain kit for the high feature V6 timing chain kits.
09-05-22-005C2018-04-02. Service bulletin. SERVICE BRAKES, HYDRAULIC:FLUID. This technical bulletin provides a procedure for the master cylinder reservoir replacement due to brake fluid is seeping from the master cylinder reservoir cap.
PI0244B2018-04-02. Service bulletin. WHEELS. This preliminary information bulletin provides information for the brake caliper finish removal, degradation or staining from wheel cleaning chemicals.
PI0233D2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This preliminary information bulletin provides information on inaccurate or slow response of outside air temperature display.
03-06-03-004I2018-04-02. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. This informational bulletin provides information for warranty codes that are generated by EL-50313 midtronics GR8 battery tester/charger.
PI0176C2018-04-02. Service bulletin. VISIBILITY:SUN/MOON ROOF ASSEMBLY. This preliminary informational bulletin provides a procedure to replace the sunroof locking slide guides for "Sunroof will not open/close or is noisy during operation" Condition.
09-08-51-004D2018-04-02. Service bulletin. STRUCTURE:BODY. This informational bulletin provides information on the door and quarter panel paint appearance.
PI10182018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This preliminary information bulletin provides information on poor or no transmitter range when using the remote keyless entry (RKE) and/or remote vehicle start (RVS).
02-07-30-029U2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information for the PQC assembly replacement process.
10-00-89-010C2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information on key codes security rules and information on GM key code look up application.
13-00-89-0082018-04-02. Service bulletin. ELECTRICAL SYSTEM:WIRING. This informational bulletin provides information for GM wiring repair.
11-08-49-001H2018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL. This technical bulletin provides a procedure to remove the transport mode on message displayed in the DIC.
10-00-89-009B2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information on key code security and information on GM key code look up applications.
PIP5095E2018-03-12. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon and may also have an oil or coolant leak. Technician may find coolant or oil in a spark plug tube. If the Spark Plug Tube is leaking and it is determined that the oil or coolant is not coming from a leak above the spark plug then replace the cylinder Head, spark plug and coil.
PIP5136A2018-03-12. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have an engine oil odor with no oil leaks found. Technician will need to inspect for an external oil leak. Technician will need to ensure the oil level is correct. Technician will need to replace the rear main seal, if no oil leaks were found and the engine oil level is not over full.
PIP5180B2018-03-12. Service bulletin. ELECTRICAL SYSTEM:STARTER ASSEMBLY. This Preliminary Information communication provides information to the technician about vehicles that have hard start, extended crank, or black smoke from the exhaust when starting. Technician will need to perform fuel quality test, spark test, and a compression test. Technician should also install a vacuum gauge prior to cold start and watch needle for signs of a sticking valve.
PIP4670E2018-03-12. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
PIP5226B2018-02-21. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about finding needle bearings during an oil change. Technician will gain access to the roller rockers to inspect them. Only replace the roller rocker that is missing needle bearings. Be sure to clean the oil drains to retrieve the needle bearings. Each roller rocker has 66 bearings.
PIP4138Q2018-02-21. Service bulletin. EXTERIOR LIGHTING. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on, engine misfire, and/or engine noise. Technician may find Diagnostic Trouble Codes P0300-P0308. If published Service Information diagnostics does not isolate the cause of this concern technician should check for a worn camshaft lobe and/or lifter roller, a sticking valve, valve leakage, a broken valve spring, and a collapsed active fuel management lifter.
PIT3271H2018-02-21. Service bulletin. WHEELS. This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection.
PIP5540A2018-02-21. Service bulletin. ENGINE. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP5168F2018-02-21. Service bulletin. POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT; BACK OVER PREVENTION; FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a no crank concern. Technician will need to check the valve train for movement when the engine is cranked. If the valve train is not moving while the crankshaft is moving the front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly. If the valve train is rotating during inspection, disconnect the Camshaft Position sensor and check if the engine will start. If the engine starts front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly. If the engine does not start with the Camshaft Position sensor disconnected the follow published “Engine Cranks But Does Not Run” diagnosis in Service Information. Also perform an Engine Compression Test and Cylinder Leakage Test in Service Information documents all results. If the Service Information procedures above isolate an engine mechanical concern then removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.