Service bulletins for the 2015 Cadillac Escalade
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
2518 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Axle are shown. Show all
| PIP5168F | 2018-02-21. Service bulletin. POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT; BACK OVER PREVENTION; FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a no crank concern. Technician will need to check the valve train for movement when the engine is cranked. If the valve train is not moving while the crankshaft is moving the front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly. If the valve train is rotating during inspection, disconnect the Camshaft Position sensor and check if the engine will start. If the engine starts front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly. If the engine does not start with the Camshaft Position sensor disconnected the follow published “Engine Cranks But Does Not Run” diagnosis in Service Information. Also perform an Engine Compression Test and Cylinder Leakage Test in Service Information documents all results. If the Service Information procedures above isolate an engine mechanical concern then removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly. |
|---|---|
| PIP5196 | 2017-08-15. Service bulletin. POWER TRAIN:AXLE ASSEMBLY; SUSPENSION:MULTIPLE AXLE. This Preliminary Information communication provides information to the technician with the steps to diagnose and repair vehicles that may have a whine noise at highway speeds from the rear of the vehicle. If the technician has diagnosed the noise to be a rear axle related whine noise at highway speed, then use published Service Information "Symptoms - Rear Drive Axle". Technician should also compare the concern with a vehicle of the same build. If the noise level is deemed excessive check the vehicle build. Technician will replace the propeller shafts if needed. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.