WenmarOpen by Wenmar Pro

Service bulletins for the 2019 BMW X5

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

482 on file from NHTSA, as of 2026-10-19.

By type

By component

Bulletins, newest first
B1703202020-06-15. Service bulletin. FUEL SYSTEM, GASOLINE; ELECTRICAL SYSTEM; LANE DEPARTURE; SERVICE BRAKES, HYDRAULIC; ENGINE AND ENGINE COOLING. COOLANT LINE QUICK DISCONNECTS LEAK IN LOW TEMPERATURES AT OR BELOW -15Ë?C (5Ë?F): The coolant reservoir in the high or low temperature cooling system is low There may be a coolant leak under the vehicle There may be a check control message (ID166) to top up coolant The low temperature cooling system have a low level warning indicator. One or more faults may be stored related to the low temp cooling system: DME - 20A201 - charge air cooling system: Coolant pump protective function due to dry running active DME - 20A209 - charge air cooling system: Coolant pump protective function due to dry running active IHKA - 80120A - Compressor: Switch off due to excess pressure in the refrigerant circuit The outside temperature at the time of the complaint is at or below -15Ë? C (5Ë? F) The O-rings that seal the quick disconnect coolant lines will not seal properly when outside temperatures are at or below -15Ë? C (5Ë? F).
B1701202020-06-15. Service bulletin. ENGINE AND ENGINE COOLING. SERVICE ACTION - ADD SILICONE BOOSTER TO LOW TEMP COOLING SYSTEM: The coolant in the low temperature cooling system may not have sufficient coolant corrosion protection.
B1304202020-06-15. Service bulletin. ENGINE AND ENGINE COOLING. TANK VENTILATION AND MIXTURE CONTROL FAULTS STORED IN THE DME: The Engine Malfunction Warning is illuminated and one or more of the following faults are stored in the DME. All models: FC 191C02 - Fuel tank ventilation system 2nd discharge point: malfunction FC 195014 - Differential pressure sensor tank vent valve signal: fixed FC 118001 - Mixture control: mixture too lean FC 118401 - Mixture control: mixture too lean large deviation I01 only: FC 124103 - Mixture control: mixture too lean FC 124101 - Mixture control: Mixture lean large deviation CAUSE Internal mechanical defect in the tank ventilation valve. The defect can also result in a very loud clicking noise when the valve is cycling.
B1101202020-06-15. Service bulletin. ENGINE. B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing.
B8402202020-05-18. Service bulletin. ELECTRICAL SYSTEM. REMOTE 3D VIEW NOT AVAILABLE: Remote 3D View cannot be launched In the BMW ConnectedDrive App. Software error in the Advanced Telematics Module 2 (ATM2).
B8401202020-05-18. Service bulletin. ELECTRICAL SYSTEM. BMW CONNECTEDDRIVE SERVICES ARE NOT AVAILABLE: The BMW ConnectedDrive services are not available for an extended period. This may include: Calls in the BMW Assistance app (Concierge Service) Vehicle data and status in the BMW ConnectedDrive app Remote services Remote 3D View Real Time Traffic Information (RTTI) Weather News Software error in Advanced Telematics Module 2 (ATM2).
B6614182020-05-18. Service bulletin. ELECTRICAL SYSTEM. CHECK CONTROL MESSAGE CROSSING TRAFFIC WARNING WHILEPARKING: The check control message (CCM) "Crossing traffic warning. It is possible to continue driving" can appear when parking. This can occur when the vehicle is parked too close to adjacent solid walls such as a single car garage or an underground parking space. The wall can be on either side of the vehicle regardless if the vehicle is pulled in forwards or backed in. If the customer switches the vehicle off and starts it again immediately the same CCM may occur again.
B6606202020-05-18. Service bulletin. ELECTRICAL SYSTEM. SERVICE ACTION - REPLACE RIGHT FRONT SHORT RANGE RADAR SENSOR (SRR): The functionality of the right front SRR sensor could be reduced which would display the Driving Assistance Check Control Message.
B6605202020-05-18. Service bulletin. ELECTRICAL SYSTEM. SERVICE ACTION - REPLACE LEFT FRONT SHORT RANGE RADAR SENSOR (SRR): The functionality of the left front SRR sensor could be reduced which would display the Driving Assistance Check Control Message.
B6114202020-05-18. Service bulletin. ELECTRICAL SYSTEM. DEACTIVATION OF THE INTERIOR MOVEMENT DETECTOR/TILT ALARM SENSOR IS NOT POSSIBLE: Customer complains that the interior movement detector and the tilt alarm sensor system cannot be deactivated by pressing the lock button on the remote control / BMW display key twice. The second button press on the radio remote control / BMW display key is not detected. Customer may have to press the button 3 times to deactivate the interior movement detector and tilt alarm sensor. CAUSE Software error in the control unit of the roof function center (FZD).
B6113202020-05-18. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM. SERVICE ACTION - CHECKING THE DUAL STORAGE SYSTEM AND REPLACE IF NECESSARY: In the event of an accident the two-battery Dual Storage System (DSS) is disconnected from the electrical system via an internal relay. In some cases the relay is stuck closed and a fault is set. In these circumstances: A crash shutdown of the DSS does not occur The power distribution box is supplied with power until the DSS is fully discharged
B6111202020-05-18. Service bulletin. STRUCTURE; LATCHES/LOCKS/LINKAGES. WHEN LOCKING VEHICLE DOORS ARE LOCKED BUT VEHICLE IS NOT SECURED: The customer complains that when locking the vehicle from the outside using the remote control: The doors lock The alarm system is not activated The side mirrors (when the function is activated) do not fold in CAUSE Due to a software error on the Body Domain Controller (BDC) it identified the remote control as being inside even though the remote control is actually located outside the vehicle. This caused the doors to be locked without securing the vehicle.
B5116202020-05-18. Service bulletin. VISIBILITY; STRUCTURE. WIND NOISE FROM WINDSHIELD SIDE TRIM: A wind noise from the windshield area is present while driving caused by a separation of the windshield side trim (circled) on one or both sides. Improper bonding of the side windshield trim during production.
B5113202020-05-18. Service bulletin. STRUCTURE. REAR DOOR SEAL DETACHED: One or both rear door seals are detached from the rear door(s). Improper connection of the door seal to the door.
B5112202020-05-18. Service bulletin. EQUIPMENT. FIBERS PROTRUDING FROM CENTER SPEAKER COVER: Fibers are protruding from beneath the center dashboard speaker cover. Insulation material underneath the speaker may become loose. The situation may become even more noticeable on those vehicles where the dashboard area is cleaned using a vacuum cleaner.
B1303202020-05-18. Service bulletin. ENGINE. DELIVERY STOP - REPLACE HIGH-PRESSURE PUMP: Due to an assembly error the flange bolts for the high-pressure pump did not have the proper tightening torque applied.
B8402142020-04-27. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY. CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.
B7204172020-04-27. Service bulletin. SEAT BELTS:FRONT:BUCKLE ASSEMBLY; ELECTRICAL SYSTEM. FALSE WARNINGS THAT THE FRONT PASSENGER SEAT IS OCCUPIED WITHOUT THE SEAT BELT BUCKLED: This Service Information Bulletin (Revision 10) replaces SI B72 04 17 dated September 2019. Acoustic and visual warnings indicate that the front passenger seat is occupied and the safety belt is not fastened when the seat is actually unoccupied. If the situation is currently present sit in the seat and move the seat to a slightly different position. The POL (Passenger Occupancy Light) light should now function correctly. In some cases the Air bag Warning Light was illuminated.
B6631192020-04-27. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM; POWER TRAIN:MANUAL TRANSMISSION:SHIFT PATTERN INDICATOR. REARVIEW CAMERA: SPORADICALLY NO IMAGE IS DISPLAYED: This Service Information Bulletin (Revision 2) replaces SI B66 31 19 dated February 2020. When reverse gear is selected or the rear view camera is activated sporadically no image is displayed on the Central Information Display (CID). If the ignition is cycled off and back on the function is restored. Software error between the head unit and the rear-view camera.
B6619192020-04-27. Service bulletin. EQUIPMENT:ELECTRICAL; LATCHES/LOCKS/LINKAGES. COMFORT ACCESS AND COMFORT GO NOT POSSIBLE: This Service Information Bulletin (Revision 1) replaces SI B66 19 19 dated May 2019. Vehicle cannot be unlocked/locked or started via Comfort Access. Remote control functionality is restored by pressing any of the key buttons or by removing and reinstalling the remote control key battery. The Display Key Digital Key and the Digital Key Card are not affected. Electrostatic discharge puts the remote control key into a deep sleep. Various situations can lead to an electrostatic charge which is often not recognized by the customer. For example walking over carpet wearing shoes that have a hard rubber sole positive and negative charges are exchanged. The sole accumulates a negative charge and an electrostatic charge develops before touching the remote control key.
B6603202020-04-27. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM. DIAGNOSTIC HINT: DRIVING ASSISTANCE SUPPORT REDUCED CHECK CONTROL MESSAGE DISP: Driving Assistance support reduced Check Control Message (CCM) is displayed sporadically. All or some of the system functions maybe inoperative.
B6522142020-04-20. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). AUTOMATED ACTIVATION OF NAVIGATION SYSTEM DURING PDI/QC1: This Service Information Bulletin (Revision 2) replaces SI B65 22 14 dated October 2015. The INITIAL NAV enabling code no longer needs to be pre-ordered through the Parts department! When the vehicle is connected to the diagnostic system ISTA to perform PDI/QC1 the step to activate the navigation system (part of Delete Transport Mode) will automatically request the INITIAL NAV enabling code (VIN-specific) without pre-ordering the enabling code. This enabling code will be automatically delivered through ISTA and it then activates the navigation system.
B6508202020-04-20. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM; EQUIPMENT. DISPLAYS SPORADICALLY REACT VERY SLOWLY WHEN SCROLLING IN THE AUDIO MENU: Sporadically the reaction time of the display in the instrument cluster the head-up display or in the CID (Central Information Display) is very long. This can occur when browsing/scrolling through lists in the audio menu switching radio stations or albums. Software in the Head Unit High (HU-H3).
B6303202020-04-20. Service bulletin. ENGINE AND ENGINE COOLING; AIR BAGS. Headlight Malfunction Check Control Message: Intermittently a check control message may be present stating "Adaptive headlight failure" (CC message 127) or "Headlight range control failure" (CC message 100). In conjunction one of the following faults codes MUST be stored for this bulletin to apply: 805A0D control unit: Headlight range control stepper motor driver failure (left frontal light module) 805A0E control unit: Adaptive Headlights stepper motor driver failure (left frontal light module) 805B8D control unit: Headlight range control stepper motor driver failure (left frontal light module) 805A0E control unit: Adaptive Headlights stepper motor driver failure (right frontal light module) This only affects vehicles with a current I-level below S18A-20-03-524. Software error in the FLM02 (Frontal light electronics module-Right or left).
B3405172020-04-20. Service bulletin. BACK OVER PREVENTION; SERVICE BRAKES, HYDRAULIC; WHEELS; POWER TRAIN. TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.