WenmarOpen by Wenmar Pro

Service bulletins for the 2016 BMW X1

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

219 on file from NHTSA, as of 2026-10-19.

By type

By component

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
B0104192024-09-29. Warranty extension. ENGINE. For this vehicle, the EVAP systems purge (vent) valve limited warranty for defects in materials or workmanship has been extended to 15 years/150,000 miles, from the original 10 years/120,000 miles, as determined from the original in-service date. This coverage is subject to the same vehicle eligibility requirements, limitations, and exclusion criteria that apply to the BMW New Vehicle Limited Warranty. Vehicles that are registered in California or a State that has fully adopted the State of California PZEV(SULEV) emission regulation (State of registration, model, and model year dependent), the emission-relevant coverage for this component is 15 years/150,000 miles.
B1606232024-01-03. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. Engine will crank but not start. There is no communication with the integrated fuel module (TFE) whendiagnosing with ISTA. The following two fault codes will be stored in the DME: 032B43 - Low fuel pressure system, electric fuel pump: pressure value too low CDA594 - Message (- 0x33E) missing, receiver DME, transmitter TFE
B1207232023-12-06. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. Vehicle exhibits a slight acceleration delay when taking off from a MSA (automatic engine start-stopfunction) stop.
B2203222023-01-03. Service bulletin. ENGINE AND ENGINE COOLING. During load reversal or taking off from a stop, there is a creaking or droning noise heard from the lower engine area.
B2202222023-01-03. Service bulletin. ENGINE AND ENGINE COOLING. During a vehicle inspection and/or while addressing a customer's concern, the engine stabilizer bar/link appears to be worn.
TEC262022-08-01. Service bulletin. ENGINE AND ENGINE COOLING. TEC26 Turbo Charger Return
SIM1101152022-08-01. Service bulletin. ENGINE AND ENGINE COOLING. MINI engine oil part number transition and model year 2016 engine oils
SIB6402222022-07-05. Service bulletin. ENGINE AND ENGINE COOLING. Mist formation on the windshield inside surface may occur at departure or after MSA (automaticstart/stop). Acoustic abnormality in the area of the recirculated air flap (recirculation flap closing and opening severaltimes). The above may occur individually or in combination.
B6406212021-12-13. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL. Different air temperatures are felt from left to right out of the front fresh air grilles (air vents).
B1304202020-06-15. Service bulletin. ENGINE AND ENGINE COOLING. TANK VENTILATION AND MIXTURE CONTROL FAULTS STORED IN THE DME: The Engine Malfunction Warning is illuminated and one or more of the following faults are stored in the DME. All models: FC 191C02 - Fuel tank ventilation system 2nd discharge point: malfunction FC 195014 - Differential pressure sensor tank vent valve signal: fixed FC 118001 - Mixture control: mixture too lean FC 118401 - Mixture control: mixture too lean large deviation I01 only: FC 124103 - Mixture control: mixture too lean FC 124101 - Mixture control: Mixture lean large deviation CAUSE Internal mechanical defect in the tank ventilation valve. The defect can also result in a very loud clicking noise when the valve is cycling.
B6105202020-04-20. Service bulletin. ENGINE. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B6404162020-03-16. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS. Water Ingress In Footwell Area From A/C Condensate Drain: This Service Information Bulletin (Revision 1) replaces SI B64 04 16 dated March 2016. The condensate drain hose is blocked by the heat shield The condensate drain hose is not attached properly to the housing The condensate drain hose was damaged during installation
B1302182020-02-18. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING. DME FAULT CODE 1B8004 ENVIRONMENTAL AIR CATALYST(EAC) SENSOR: This Service Information Bulletin (Revision 1) replaces SI B13 02 18 dated April 2018. The Malfunction Indicator Lamp (MIL) light is on and the following fault code is stored in the DME: 1B8004 - EAC Sensor: Temperature - Engine coolant temperature radiator outlet comparison to each other implausible DME software calibration error for EAC sensor diagnostics.
B1112192020-02-18. Service bulletin. ENGINE AND ENGINE COOLING. MALFUNCTION INDICATOR LAMP IS ILLUMINATED WITH A CRANKSHAFT ADAPTION FAULT: When diagnosing an illuminated malfunction indicator lamp (MIL) and/or a different issue the following faults may also be stored in the Digital Motor Electronics (DME). Fault code Control module Fault code text 213A2B DME Increment wheel adaption faulty This situation is not associated with any drivability complaints and only affects vehicles built with a Factory I-level of 19-07-500 and later. An unfavorable DME diagnostic calibration may cause the fault code to be stored. In most circumstances this will cause the MIL to be illuminated.
B1223192019-08-19. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CATALYTIC CONVERTOR; EQUIPMENT:ELECTRICAL. DIAGNOSTIC HINT: CATALYTIC CONVERTER INSPECTION AFTER LOSS OF CRANKSHAFT SIGNAL. In certain situations when the crankshaft position signal is lost while driving the malfunction indicator lamp (MIL) and an engine malfunction check control message (CCM #29) may be displayed. The engine may run roughly or with reduced power.
B1101192019-07-22. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:BELTS AND ASSOCIATED PULLEYS. ENGINE VIBRATIONS OR NOISE This Service Information bulletin replaces SI B11 01 19 dated February 2019.
B1213192019-06-24. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. SERVICE ACTION: LOCK THE DME FAULT MEMORY (F39 F48). The fault memory lock in Digital Motor Electronics (DME) control unit was not activated. An activated lock would prevent the manual deletion of permanent fault codes. The DME fault memory lock has not been set.
B1107172019-06-24. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING. FAULT 118002 - MIXTURE TOO RICH SETS DURING WINTER WITH COLD AMBIENT TEMPERATURES. The Service Engine Soon (MIL) light is on with the following fault stored in the Digital Motor Electronics (DME). In the situation being described the fault is primarily stored during the cold winter months along with the use of winter fuel.
B0104192019-05-20. Service bulletin. ENGINE. B46O PZEV/SULEV ENGINE - FUEL TANK VENT (PURGE) VALVE: LIMITED WARRANTY EXTENSION TO 10 YEARS/120000 MILEAGE. The vehicle's malfunction indicator lamp (MIL) lights up.
B1101192019-03-18. Service bulletin. ENGINE. ENGINE VIBRATIONS OR NOISE. One of the following complaints may be reported The engine runs erratically; The engine causes vibrations when running; Grinding noise from the engine compartment when engine is running.
B1107172019-02-25. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE. FAULT 118002 - MIXTURE TOO RICH SETS DURING WINTER WITH COLD AMBIENT TEMPERATURES. The Service Engine Soon (MIL) light is on with the following fault stored in the Digital Motor Electronics (DME). Fault: 118002 - Mixture too rich In the situation being described.
B1204162018-12-10. Service bulletin. ENGINE AND ENGINE COOLING. Engine will not Start (No Crank). The engine will not crank or the engine loses power while driving, followed by a no crank situation. There is no communication with the DME when diagnosing with ISTA (DME is yellow on control unit tree). In certain instances, the startup of the turbocharger coolant pump can exceed the 5A rating of fuse F83.
B2202172018-11-26. Service bulletin. ENGINE. KNOCKING NOISE FROM THE ENGINE COMPARTMENT. There is a knocking noise coming from the engine compartment or the engine shakes during: Engine start When driving off from a stop When applying brakes CAUSE Damage to the right side engine mount. The damage may be subtle (1st picture) or obvious (2nd picture). Inspect the right engine mount and replace if necessary.
B1210172018-11-26. Service bulletin. ENGINE. "ENGINE IDLE TOO HIGH AT OPERATING TEMPERATURE. Primarily when vehicle is at altitudes higher than 5000' above sea level, and engine is at operating temperature, the idle is sporadically elevated (up to approx. 1200 rpm). MIL indicator is illuminated. Fault code 1E0001 - ""Idle speed control: Speed too high"" is stored in DME. DME software error"
B6621162018-11-05. Service bulletin. ENGINE; LANE DEPARTURE: SENSING SYSTEM: OTHER; SERVICE BRAKES. KAFAS CAMERA-BASED ASSISTANCE SYSTEM LIMITS. INFORMATION The situations described above may all be caused by known limitations of the system such as: Dirty windshield Incomplete calibration process Unsuccessful calibration Restricted visibility- weather conditions or parked vehicles Missing lamps on target vehicle Non-standard vehicle exterior surfaces Insufficient ambient lighting Abrupt motion of target vehicle.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.