Service bulletins for the 2017 BMW F 800 R
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
269 on file from NHTSA, as of 2026-10-19.
By type
By component
By topic
Only bulletins with component: Engine are shown. Show all
| SIB090121 | 2022-07-18. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE; ELECTRICAL SYSTEM:SOFTWARE. BMW offers a new special ISTA Installation made available for Roadside Assistance / Mobile Service technicians. The new ISTA Version is also able to be used in case of a Remote Software Upgrade (RSU) programming failure to get the customer car reprogrammed on site. In case of a Remote Software Upgrade failure, the engine start is prevented for safety reasons until the vehicle is programmed correctly. Most of the errors occur when only one control unit fails to program correctly. |
|---|---|
| B110521 | 2022-05-31. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. The belt pulley on the mechanical coolant pump may fracture allowing the engine drive belt to come off the coolant pump and alternator. |
| B662419 | 2022-01-24. Service bulletin. ELECTRICAL SYSTEM; ENGINE; STEERING. Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start when placing the key against the steering column. |
| B121021 | 2021-12-27. Service bulletin. ELECTRICAL SYSTEM; ENGINE. The customer complains that under moderate throttle application or on deceleration after throttle application, a Malfunction Indicator Lamp (MIL) is displayed in the instrument cluster. |
| B611421 | 2021-12-20. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION:PRESSURE/TEMPERATURE SENSOR. The BMW Gesture Control function may fail permanently as a result of high temperature fluctuations. |
| SIB 62 03 21 | 2021-10-25. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE AND ENGINE COOLING. When the vehicle is operated in Sport Mode, the engine speed is no longer displayed in the BMW Head-Up Display (HUD). |
| B610421 | 2021-08-09. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; EQUIPMENT; ENGINE. The customer may complain of a check control message stating "Safe share detected" (CCM-ID 953). Check control message can be verified by checking key reader information or performing the Check control message history service function. |
| B512219 | 2021-08-09. Service bulletin. EQUIPMENT; ENGINE; EQUIPMENT ADAPTIVE/MOBILITY. Upon visual inspection, the passenger side upper active air flaps are either stuck open or closed, and they will not move. |
| B110120 | 2021-08-09. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION:FILTER/SCREEN. On rare occasions during an engine oil service, the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. |
| B110321 | 2021-07-19. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; ENGINE. B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available. |
| B121318 | 2021-03-15. Service bulletin. ENGINE AND ENGINE COOLING. COMBUSTION CONTROL VALVE LIFT AT IDLE: The vehicle will run rough or hesitate when accelerating from a stationary position. |
| B662419 | 2021-02-01. Service bulletin. ENGINE; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM. REMOTE CONTROL IS NOT DETECTED: Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start when placing the key against the steering column. |
| B170617 | 2020-08-31. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING. COOLANT LEAK FROM LOW TEMPERATURE COOLING CIRCUIT (N63R): Coolant leaking from the engine compartment. Traces of coolant leaking from the expansion tank of the low temperature cooling system. Aluminum corrosion in the charge air intercoolers, or in the radiator for the low temperature cooling is causing an unfavorable chemical reaction to the coolant. |
| B170420 | 2020-07-27. Service bulletin. ENGINE AND ENGINE COOLING. COOLANT LEVEL CHECK AND TOP-OFF AT SECOND OIL SERVICE: A new, additional coolant level check task is now linked to the second engine oil service (Service Counter 2 only). The scope of maintenance work will display in ISPA Next that applies to the high-temperature circuit. This new coolant check only pertains to the above listed models with gasoline engines. During the normal operation of the vehicle, there is a certain amount of coolant absorption by the various components/gaskets/seals contained within the coolant systems. Over time, the coolant absorption can cause the coolant level to fall below the maximum fill level in the reservoir. In some cases, the level may even fall low enough to cause the high-temperature circuit low coolant level warning light to illuminate, along with displaying the corresponding Check Control message. |
| B512219 | 2020-06-15. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE; EQUIPMENT. PASSENGER SIDE UPPER ACTIVE AIR FLAP STUCK OPEN/CLOSED: Upon visual inspection the passenger side upper active air flaps are either stuck open or closed and they will not move. There are no faults stored for the active air flaps. |
| B110120 | 2020-06-15. Service bulletin. ENGINE. B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing. |
| B610520 | 2020-04-20. Service bulletin. ENGINE. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation. |
| B170617 | 2020-04-20. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. COOLANT LEAK FROM LOW TEMPERATURE COOLING CIRCUIT (N63R): This Service Information Bulletin (Revision 5) replaces SI B17 06 17 dated June 2019. Traces of coolant leaking from the expansion tank of the low temperature cooling system. Coolant in the low temperature cooling circuit may also have an acrid smell and discoloration (1). Aluminum corrosion in the charge air intercoolers or in the radiator for the low temperature cooling is causing an unfavorable chemical reaction to the coolant. |
| B121318 | 2020-04-20. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. DME FC 21A02D - COMBUSTION CONTROL: VALVE LIFT AT IDLE This Service Information Bulletin (Revision 3) replaces SI B12 13 18 dated September 2019. The vehicle will run rough or hesitate when accelerating from a stationary position. |
| B110120 | 2020-03-16. Service bulletin. ENGINE AND ENGINE COOLING. ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1). |
| B120419 | 2020-02-18. Service bulletin. ENGINE AND ENGINE COOLING. DME FAULT MEMORY ENTRY FOR THE CRANKSHAFT SENSOR: This Service Information Bulletin (Revision 1) replaces SI B12 04 19 dated February 2019. Technicians may notice this fault logged during a diagnostic session: Fault code: Control module: Fault Text: 160021 DME Crankshaft sensor: general loss of synchronism Environmental conditions are vehicle speed 0 (stationary) and engine speed less than 1500 rpm. There is no customer-facing symptom nor related check control message displayed. Phantom/pseudo fault due to unsuitable DME software. Background: After parking the vehicle and turning off the engine both DME control units go into sleep mode at different times. The DME of cylinder bank 2 ("secondary") goes into sleep mode first The DME of cylinder bank 1 ("primary") is still awake and can experience a reduction in signal voltage for the crankshaft sensor signal This signal change can mistakenly be evaluated as a skipped crankshaft sensor cog by the DME. If the engine is started while the primary DME is still awake this causes a brief loss of synchronization with the secondary DME. Fault 160021 is logged after three (3) consecutive engine starts with this momentary loss of synchronization. Note: Starting the engine after the primary DME has also gone into sleep mode will avoid the loss of synchronization. |
| B111219 | 2020-02-18. Service bulletin. ENGINE AND ENGINE COOLING. MALFUNCTION INDICATOR LAMP IS ILLUMINATED WITH A CRANKSHAFT ADAPTION FAULT: When diagnosing an illuminated malfunction indicator lamp (MIL) and/or a different issue the following faults may also be stored in the Digital Motor Electronics (DME). Fault code Control module Fault code text 213A2B DME Increment wheel adaption faulty This situation is not associated with any drivability complaints and only affects vehicles built with a Factory I-level of 19-07-500 and later. An unfavorable DME diagnostic calibration may cause the fault code to be stored. In most circumstances this will cause the MIL to be illuminated. |
| B110819 | 2020-01-21. Service bulletin. FUEL SYSTEM, DIESEL; ENGINE. B57 DIESEL ENGINE - CHECK CONTROL MESSAGE OIL LEVEL TOO HIGH. Check Control Message (CCM) "Engine oil level too high" is displayed. Fuel dilution into the engine oil due to the diesel particulate filter (DPF) regeneration strategy. |
| B170617 | 2019-10-21. Service bulletin. ENGINE AND ENGINE COOLING. COOLANT LEAK FROM LOW TEMPERATURE COOLING CIRCUIT (N63R): Coolant leaking from the engine compartment. Traces of coolant leaking from the expansion tank of the low temperature cooling system. Coolant in the low temperature cooling circuit may also have an acrid smell and discoloration. |
| B110119 | 2019-07-22. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:BELTS AND ASSOCIATED PULLEYS. ENGINE VIBRATIONS OR NOISE This Service Information bulletin replaces SI B11 01 19 dated February 2019. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.