WenmarOpen by Wenmar Pro

Service bulletins for the 2012 Audi S4

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

795 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Automatic transmission are shown. Show all

Bulletins, newest first
35 14 17 20322112022-05-31. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:GEARS. Gearbox warning light
35 13 12 20280852022-05-31. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. leaks from transmission.
35 13 09 20280852022-05-31. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. Speed S-tronic, leaks from transmission
AWA 22-032022-05-05. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This Document informs dealers on the new DSG transmission warranty extension for 2010-2012 S4 & S5 vehicles
35 13 15 20304772022-05-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL). The following message appears in the information display: ?Gearbox malfunction: you can continue driving.
37 13 09 20287152022-05-02. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY; POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:GEARS. After a mechatronics, torque converter, or complete gearbox replacement, the clutches must be adapted to the new component. This requires a gradual move of the clutch linings toward the optimal operating points in the most diverse load conditions. As a result, sporadic driving power disruptions lasting for less than a second or reduced shift comfort are possible over the first 500 miles. This is normal, and these issues will decrease over time. The issues can also occur if the adaptation values of the gearbox were deleted.
35 14 17 20322112022-05-02. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. Incorrect driving mode sensor module. The driver information system displays the message ?Gearbox malfunction: you can continue driving?.
A371882 2051685-2018-09-17. Service bulletin. EQUIPMENT; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). This bulletin contains repair instructions for when DTC P179E00 is stored and the mechantronic unit and/or gear sensor G676 are being replaced.
A371390 2032971-2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Transmission warning message appears in instrument cluster. The gearbox is in limp mode until key is cycled. Fault P17E100 (DFCC 9473) is stored in transmission control unit. The DFCC is the 4-6 digit code that is typically listed before the fault code. The fault is very sporadic and usually appears after a cold start. Fault is caused by transmission software that is too sensitive.
A661330 2030471-2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. Supersedes Technical Service Bulletin Group 66 number 12-24 dated August 24, 2012. Customer may report the license plate attachment screws do not install properly. The license plate brackets are designed to be used with the appropriate length screw installed by hand with a screwdriver. Damaged warranty parts have been returned to Audi of America with evidence of excessive torque used when installing the screw and/or excessive screw length.
A011526 2041120-2017-10-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). The MIL is on. DTC P042000 and/or P043000 (Catalyst system Bank 1/2, Efficiency below threshold) is stored in the engine control module (ECM), J623 (address word 01). The diagnostic limitations were too narrow.
A351620 2030477-2017-10-04. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. Gearbox malfunction message in cluster. DTCs P17D800, P179D00, P174000, P174C, P174B, P174F, P179C, P174A, and/or P174E are stored in the transmission control module. Fault codes and symptom codes must match exactly or this TSB should not be followed. Poor internal contact area on circuit board will lead to faults. Oil additives can cause the plastic circuit plates to delaminate, causing contact loss.
A351619 2032211-2017-10-04. Service bulletin. STEERING:GEAR BOX (OTHER THAN RACK AND PINION); POWER TRAIN:AUTOMATIC TRANSMISSION; ELECTRICAL SYSTEM. Gearbox warning light on (DTCs P179E00, P179F00, P0700, P060A). The driver information system displays the message "gearbox malfunction: you can continue driving". There are two scenarios present. Scenario 1 is that entries are logged individually or in combination, with P179E logged first (using DTC environmental data).The entries are DTC P179E (Drive position sensor electrical error), DTC P0700 with DFCC 20196 (Transmission control system malfunction), DTC P1758 with DFCC 8464 (Terminal 15 voltage supply open circuit), and DTC P060A with DFCC 8126, 8345 (Internal control module monitoring processor performance) In this scenario, if DTC P179E is not logged first, this TSB does not apply. Scenario 2 is that entries are logged individually or in combination. The order in which the DTCs are logged is not relevant. The entries are DTC P179E with DFCC 8050, 8051, 8052, 8053, 17595, 17596, 17597, 17598, 17602 (Drive position sensor electrical error), DTC P179F with DFCC 8054, 8055, 8056, 8057, 17599, 17600, 17601 (Drive position sensor malfunction), DTC P0716 with DFCC 8096, 8101, 18153, 20738 (Input turbine/speed sensor ?A? circ. range/performance), DTC P171F with DFCC 8097, 8102, 18154 (Transmission input speed (RPM) sensor 2 implausible signal), DTC P0715 with DFCC 8094, 8103, 18161 (Input turbine/speed sensor ?A? circuit.), DTC P2765 with DFCC 8095, 8104 (Input turbine/speed sensor ?B? circuit), DTC P0501 with DFCC 8098 (Vehicle speed sensor ?A? range/performance), and DTC P2159 with DFCC 8099 (Vehicle speed sensor ?B? range/performance). Fault codes and DFCC codes must match exactly for this TSB to apply. The DFCC is the 4-6 digit code that is typically listed before the fault code. Incorrect driving mode sensor module.
A351621203047782017-03-03. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. THIS TECHNICAL SERVICE BULLETIN PROVIDES INSTRUCTIONS FOR DIAGNOSING AN ISSUE WITH THE MECHATRONICS CONTROL UNIT CIRCUIT BOARD AND INSTRUCTIONS FOR REPLACING IT.
TSB-37-13-902013-04-11. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). AUDI: PSS 37 TRANSMISSION WARNING MESSAGE IN CLUSTER. GEARBOX IN LIMP MODE, FAULT P17E100 STORED IN TCM. THE FAULT IS SPORADIC AND USUALLY APPEARS AFTER A COLD START. FAULT IS CAUSED BY TRANSMISSION SOFTWARE THAT IS TOO SENSITIVE. *JS
TSB-37-12-382012-04-11. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:COLUMN SHIFT; POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:FLOOR SHIFT; ELECTRICAL SYSTEM:IGNITION. AUDI: VEHICLE HAVE ISSUES WITH IGNITION KEY CAN NOT BE REMOVED FROM IGNITION; VEHICLE IN PARK POSITION BUT UNABLE TO MOVE SHIFTER; ENGINE SWITCHED OFF BUT REMOTE CONTROL CAN NOT LOCK WITH ADVANCED KEY; PARK IS NOT RECOGNIZED ELECTRICALLY. *PE

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.