Service bulletins for the 2013 Audi A4 allroad
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
893 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| A961351 2031095- | 2017-11-17. Service bulletin. EQUIPMENT:ELECTRICAL; LANE DEPARTURE: ASSIST. Supersedes Technical Service Bulletin Group 96 number 13-49 dated February 1, 2013. Audi Side Assist deactivates itself immediately after the engine starts. DTC C1115F2 (Lane change assistance control module 2 Function limitation due to insufficient voltage) is logged in the lane change assistance control module, J769 (3C). The lane change assistance control module, J769 (3C), checks voltage after each engine on cycle. During this check, the voltage can be incorrectly reported which causes the DTC to set. |
|---|---|
| A961350 2032225- | 2017-11-17. Service bulletin. LANE DEPARTURE: ASSIST. Supersedes Technical Service Bulletin Group 96 number 12-46 dated December 21, 2012. The customer complains of the following warning message in the Driver Information Center: "Lane change assistant not available", and the button on the mirror does not stay lit. Audi Side Assist is inoperative. DTCs must be present in the system. Incorrect component installed at the factory. |
| A961349 2031095- | 2017-11-17. Service bulletin. LANE DEPARTURE: ASSIST. Supersedes Technical Service Bulletin Group 96 number 12-45 dated November 7, 2012. Audi Side Assist deactivates itself immediately following the engine starting. The DTC entry "Control unit 2 for lane changing assistant - restricted function because of low voltage, sporadic" is logged in the control unit "3C - Lane Change Assistant". The control unit "3C - Lane Change Assistant" checks voltage after each engine on cycle and during this check the voltage can be incorrectly reported which causes the DTC to set. |
| A941309 2032852- | 2017-11-17. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. Supersedes Technical Service Bulletin Group 94 number 13-08 dated February 26, 2013. Only vehicles with xenon headlights (PR No 8Q3 or 8Q5) are affected. The headlights appear to be adjusted too low. The overall illumination pattern on the road is too short, particularly when driving on non-highway roads. The illumination pattern on road is the same when compared to similarly xenon headlight-equipped vehicles. |
| A941308 2032852- | 2017-11-17. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. Only vehicles with xenon headlights (PR No 8Q3 or 8Q5) are affected. The headlights are adjusted too low. The overall illumination pattern on the road is too short, particularly when not driving on the highway. The headlight adjustment is correct according to the ElsaWeb repair manual, or the overall illumination pattern on the road is the same when compared to another like vehicle. |
| A941306 2017806- | 2017-11-17. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Supersedes Technical Service Bulletin Group 94 number 12-79 dated June 6, 2012. Light bulb warning light and the message Vehicle lights: malfunction is displayed in the instrument cluster display. DTC 03280 (Light switch position implausible signal) is stored in the vehicle electrical system control module, J519 (09). Exterior lights are functioning properly. If the headlight switch is moved to an intermediate position and remains there, the light bulb warning light and the error message appear after approximately ten seconds. Once displayed, the message turns off after approximately five seconds. The light bulb warning light turns off only after the headlight switch is turned to a defined position, and the status of DTC 03280 is changed to sporadic. After 40 driving cycles without an implausible signal detected, the DTC is automatically cleared. |
| A941304 2032891- | 2017-11-17. Service bulletin. VISIBILITY; EXTERIOR LIGHTING. The customer complains that large amounts of water can be seen in the base of the fog lamp. No outside influence, such as rock chips, can be found. The fog lamps function normally. For customer complaints of only condensation buildup on fog lamp, refer to TSB 2012749 94 Exterior lights, moisture accumulation. Under certain circumstances, water can enter through the ventilation opening on the back of the fog lamp. |
| A911375 2032966- | 2017-11-17. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. No sound (from all audio sources) when vehicle is operated above 6 to 10 mph. When the ignition is cycled and the vehicle is stationary, the audio will work until the vehicle is driven again. Concert Radio (PR 8UQ) and standard sound system (PR 9VD). |
| A911374 2024323- | 2017-11-17. Service bulletin. BACK OVER PREVENTION: CAMERA SYSTEM. Supersedes Technical Service Bulletin Group 91 number 12-61 dated October 1, 2012. Parking aid sporadically warns of obstacles when none exist. Parking aid is inoperative or provides constant warning. Various parking aid sensor fitting issues. Environmental conditions. |
| A571382 2017082- | 2017-11-17. Service bulletin. LATCHES/LOCKS/LINKAGES; EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 57 number 11-55 dated August 22, 2011. Central locking via remote control does not work either sporadically or permanently. The locks can still be operated manually. Missing synchronization between the remote control key and vehicle because the battery has been disconnected or the battery of the remote control has been replaced. If other senders operate in the same frequency range (mobile phones, TV stations, wireless headphones, baby monitors, other vehicle remote controls, etc.), the remote control key may have been temporarily switched off because a clear identification of the remote control key is not possible. This is necessary to prevent an unintentional unlocking of the vehicle by other unrelated senders. |
| A481336 2033044- | 2017-11-17. Service bulletin. STEERING; STEERING:ELECTRIC POWER ASSIST SYSTEM. The customer states they have a comfort concern about the steering system. The steering works correctly but intermittently feels notchy. There is no loss of steering functionality. The concern may be more apparent in colder weather, and may improve with warmth or an ignition key cycle. No DTC is stored and no warning appears in the cluster. This PSS TSB applies only to the comfort concern described in the condition of this PSS TSB. Please refer to the attached Information and Q&A document for guidance when handling each case. A solution is in development and will be made available as soon as possible. The steering wheel is mechanically linked to the wheels of the vehicle, and there is no loss of steering functionality. Refer to the attached Information and Q&A document for guidance when handling each case. |
| A441337 2030275- | 2017-11-17. Service bulletin. SUSPENSION; STEERING. Supersedes Technical Service Bulletin Group 44 number 12-34 dated November 13, 2012. Customers may report the following conditions on vehicles with less than 6000 miles. In some cases these conditions may be noticed at PDI. Vehicle pulls - left or right. Steering wheel not leveled or off-center. If the alignment concern is due to outside influence (e.g. accident), this TSB does not apply. |
| A441336 2022563- | 2017-11-17. Service bulletin. SUSPENSION. Supersedes Technical Service Bulletin Group 44 number 13-35 dated January 18, 2013. Customer feels vibration from 55 - 80 mph (88 - 128 km/h) in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not result in any handling concerns or loss of vehicle control. |
| A371395 2030582- | 2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 37 number 13-89 dated February 11, 2013. Customer may report that the transmission warning light comes on. There are no drivability/starting concerns. GFF scan shows fault code P060600 (Control Module Malfunctioning, Sporadic) stored in the transmission control module, J217 (02). The entry is caused by an overly sensitive diagnosis in the transmission control module. |
| A371391 2032941- | 2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Customer may report transmission warning light comes on. No drivability/starting concerns. GFF scan shows fault code: P172400 Starter Interlock Signal - short to Ground (GND) Sporadic, stored in the Transmission control module (02). Fault code: 00165 Transmission Park/Neutral Position Switch -F322- Incorrect Signal Sporadic, may also be stored in the Comfort module (46). Momentary loss of signal under very specific driving conditions causes fault to set. |
| A371389 2030582- | 2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Supersedes Technical Service Bulletin Group 37 number 12-61 dated August 20, 2012. Customer may report that the transmission warning light comes on. There are no drivability/starting concerns. GFF scan shows fault code P060600 (Control Module Malfunctioning, Sporadic) stored in the transmission control module. The entry is caused by an overly sensitive diagnosis in the transmission control module. |
| A371388 2032094- | 2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); POWER TRAIN. Supersedes Technical Service Bulletin Group 02 number 12-02 dated December 6, 2012. Customer may report transmission warning light comes on. No drivability/starting concerns. GFF scan shows fault code: P060300 (Control Module Malfunctioning, Sporadic), stored in the Transmission control module (02). The entry is caused by an overly sensitive diagnosis in the gearbox control unit. This does not affect the driving characteristics. |
| A371387 2029305- | 2017-11-17. Service bulletin. POWER TRAIN. Supersedes Technical Service Bulletin Group 37 number 13-84 dated January 31, 2013. Customer may report harsh downshifts while braking or harsh 1-2 upshift under acceleration concerns. Customer may report harsh downshifts while braking or harsh 1-2 upshift under acceleration concerns. |
| A371386 2028985- | 2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. Supersedes Technical Service Bulletin Group 37 number 13-85 dated February 4, 2013. Customer may report transmission warning lamp illuminated in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 "Torque Converter Clutch Circuit Performance" or "Stuck Off" is stored in TCM. The fault occurs with ATF temperature below 60o C. Check for this temp range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks. |
| A371385 2028985- | 2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. Supersedes Technical Service Bulletin Group 37 number 13-80 dated January 16, 2013. Customer may report transmission warning lamp illuminated in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 "Torque Converter Clutch Circuit Performance" or "Stuck Off" is stored in TCM. The fault occurs with ATF temperature below 60o C. Check for this temp range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks. |
| Update Bulletin | 2017-11-17. Service bulletin. LANE DEPARTURE: ASSIST; ELECTRICAL SYSTEM:SOFTWARE. On Audi vehicles with lane change assist manufactured within a specific period, the lane change assist control unit may fail in individual cases after a period of time. The Update is in effect until removed. Procedure is valid only for vehicles that show the 96C8 code in the ElsaWeb Campaign/Action Information screen on the day of repair. Vehicles must be within the New Vehicle Limited Warranty. Procedure must be performed within the allotted timeframe stated in this Technical Service Bulletin. Procedure must be performed on applicable vehicles in dealer inventory prior to sale. |
| Audi IQS Newslet | 2017-11-17. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. The topics for the Audi IQS Newsletters are chosen based on "Voice of the Customer" data and respond directly to top concerns of Audi owners. They are designed to help educate you and make an impact on customer satisfaction. Dealer Communications dealing with IQS topics are also distributed on occasion. |
| A941314 2033536- | 2017-11-17. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. A significant amount of water is collecting at the base of the Xenon headlight lens. No outside influence, such as rock chips, can be found. The headlights function normally. If the customer complaint is only about condensation buildup on the fog lamp (not about water collecting as described above), refer to TSB 2012749, 94 Exterior lights, moisture accumulation. Under certain circumstances, water can enter through the headlight adjustment screw (A4), or through the bonding channel between the headlight housing and lens (A5). |
| A701330 2033711- | 2017-11-17. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. Squeak or rattle noises from the instrument panel area. Due to the multiple components that comprise the trim assembly, the panel surrounding the instrument cluster, MMI display screen, etc. can create these noises over bumps or when flexing. |
| A481342 2033044- | 2017-11-17. Service bulletin. STEERING. Supersedes Technical Service Bulletin Group 48 number 13-39 dated March 18, 2013. The customer states they have a comfort concern about the steering system. The steering works correctly but intermittently feels notchy. There is no loss of steering functionality. The concern may be more apparent in colder weather, and may improve with warmth or an ignition key cycle. No DTC is stored and no warning appears in the cluster. This PSS TSB applies only to the comfort concern described in the condition of this PSS TSB. Please refer to the attached Information and Q&A document for guidance when handling each case. A solution is in development and will be made available as soon as possible. The steering wheel is mechanically linked to the wheels of the vehicle, and there is no loss of steering functionality. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.