WenmarOpen by Wenmar Pro

Service bulletins for the 2013 Audi A4 allroad

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

893 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
A871346 2035582-2017-11-03. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; ENGINE AND ENGINE COOLING. The A/C Compressor has been diagnosed as faulty and will be replaced under warranty. When performing replacement of an A/C Compressor under warranty, the amount of refrigerant and oil recovered must be documented.
741312 2004327-42017-11-03. Service bulletin. STRUCTURE; EQUIPMENT. Supersedes Technical Service Bulletin Group 70 number 08-39 dated December 4, 2008. Leather upholstery is dirty or stained.
A001353 2035505-2017-11-03. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; EQUIPMENT. This vehicle is one of a limited number of specially-built vehicles that are part of the Audi on Demand pilot program in the USA. A Repair Authorization must be obtained for this vehicle when it arrives at an Audi dealership requiring diagnosis or repair. PDI for this vehicle does not require prior authorization or a TAC ticket. For all other concerns, the procedures in this bulletin are mandatory until further notice. Warranty repairs without authorization via a TAC ticket will not be reimbursed. Routine maintenance for this vehicle should be performed only at an authorized Audi AG maintenance facility for Audi on Demand vehicles and should not be performed at the Audi Dealership. Because of the special modifications, SVM work should never be performed on this vehicle. Additionally, a VAS tester should not be hooked into the vehicle under any circumstance except for when the vehicle is being taken out of Transport Mode or when the SRI is being set. Any additional PDI work requiring a VAS tester should not be performed on this vehicle. There may be a warning posted inside of the vehicle at the time of delivery from the port.
MY 2013 A4 PDI C2017-10-31. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This document contains the Audi delivery report checklist.
Dealer Letter-Up2017-10-31. Service bulletin. ELECTRICAL SYSTEM:IGNITION; ENGINE. This communication is to inform you of upcoming Update 28G6. There are 79,232 Audi vehicles affected in the U.S. by this Update. Rough idle or reduced driving power and, in turn, an illuminated Malfunction Indicator Lamp (MIL) on the instrument cluster due to the presence of specific fault codes caused by this component. Inspect and replace ignition coils as required.
A911314 2013790-2017-10-31. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 91 number 11-25 dated November 29, 2011. The navigation DVD or other CD/DVD cannot be ejected. There are no DTCs stored in the corresponding module. The eject button is not stuck. When the eject button is pushed, the drive does not sound as if it is trying to eject the CD/DVD. Vehicles with DVD-based navigation systems now have the navigation DVD installed during production. To prevent theft of the DVD during transportation, the eject button of the navigation drive is disabled. The navigation system itself (e.g., route guidance) functions as specified. The eject buttons of vehicles without DVD-based navigation systems are not disabled during production, but could behave as described in the Condition section of this bulletin. The eject button can be enabled through Guided Fault Finding.
A901342 2035902-2017-10-31. Service bulletin. ELECTRICAL SYSTEM:IGNITION. "Ignition lock faulty" message is displayed in the driver information display with the symbol shown at right. DTCs are stored in the comfort system central control unit. The "ignition lock faulty" message can be triggered by many different DTC entries. Presence of the message does not indicate that the ignition switch is faulty; the message typically has a different root cause. Replacing the ignition switch before completing GFF test plans typically does not correct the condition.
A741316 2035814-2017-10-31. Service bulletin. SEAT BELTS. The armrest will not operate in any direction. The height adjustment of the armrest will not engage or remain in position, or may become stuck in one position during height adjustment. If the armrest slides past its limit and the rods are pulled out of the armrest , it is because the retention of the bracket is insufficient. The armrest bracket is under tension because the guide plate has fallen loose from the bracket or the return spring has slipped from its original position.
A701335 2022773-2017-10-31. Service bulletin. STRUCTURE:BODY:DOOR; EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 57 number 12-70 dated September 5, 2012. Vibration noises from the doors or the rear parcel shelf are heard, particularly when heavy bass audio is playing. Components on the doors or the parcel shelf vibrate while heavy bass audio is played.
A551333 2035797-2017-10-31. Service bulletin. STRUCTURE; SUSPENSION. The customer complains of hearing a creaking or knocking noise from the front of the vehicle when the vehicle is twisted, such as when being driven into or out of a driveway. The customer may describe the location of the noise source as the front suspension area. This type of noise may be caused by the contact between the hood height adjustment stop buffers and the lock carrier. While noises originating from the front of the vehicle may have a number of causes, the repair described below will eliminate this possible cause.
A461362 2033674-2017-10-31. Service bulletin. SERVICE BRAKES. Supersedes Technical Service Bulletin Group 46 number 13-51 dated July 30, 2013. Brakes on vehicles produced before September 3, 2012 (calendar week 36 of 2012), squeak or squeal when used with light to moderate force.
A441344 2022563-2017-10-31. Service bulletin. STEERING; SUSPENSION. Supersedes Technical Service Bulletin Group 44 number 13-42 dated September 27, 2013. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. The customer feels the vibration while driving at highway speeds from 55 - 80 mph (88 - 128 km/h). This bulletin is not applicable if this vehicle has a Repair Authorization on this topic.
A201328 2035073-2017-10-31. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 20 number 13-27 dated October 16, 2013. MIL on. DTC P045600 (EVAP System Leak Detected NVLD (very small leak)) is stored in the engine control module (ECM), J623 (address word 01). Drivability is not affected.
A191346 2033491-2017-10-31. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM; ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 19 number 13-44 dated July 18, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
A171347 2035463-2017-10-31. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 17 number 13-44 dated October 22, 2013. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine, and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner?s Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, and the ambient temperature and road conditions. Additional factors include the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. Utilizing the advanced sensor technology integrated in models equipped with the 3.0 TFSI engine, it is possible to measure oil consumption electronically via a Guided Function test plan. If the electronic oil consumption test is not available for this model, perform the test with the conventional scale/oil weighing method. See TSB 2018550 for instructions for the conventional scale/oil weighing method.
Update Bulletin-2017-10-31. Service bulletin. EQUIPMENT:ELECTRICAL. Rough idle or reduced driving power and, in turn, an illuminated Malfunction Indicator Lamp (MIL) on the instrument cluster due to the presence of specific fault codes caused by this component. This Update is in effect until removed. Procedure is valid only for vehicles that show the 28G6 code in the ElsaWeb Campaign/Action Information screen on the day of repair. Vehicle must be within the New Vehicle Limited Warranty. Procedure must be performed within the allotted time frame stated in this Technical Service Bulletin. Procedure must be performed on applicable vehicles in dealer inventory prior to sale. A faulty ignition coil can result in rough idling or reduced driving power and, in turn, cause the Malfunction Indicator Lamp (MIL) on the instrument cluster to illuminate due to the presence of specific fault codes caused by this component.
A961380 2030583-2017-10-31. Service bulletin. LANE DEPARTURE: ASSIST; LANE DEPARTURE: BLIND SPOT DETECTION. Supersedes Technical Service Bulletin Group 96 number 13-76 dated September 23, 2013. Customer complains that Audi Side Assist is providing false warnings (no vehicle is present). Concern may or may not be duplicated. No DTCs are present in the Audi Side Assist system. This condition occurs due to an incorrect hardware set created by the supplier.
A961379 2035047-2017-10-31. Service bulletin. LANE DEPARTURE: BLIND SPOT DETECTION; LANE DEPARTURE: ASSIST. Supersedes Technical Service Bulletin Group 96 number 13-77 dated September 23, 2013. Audi Lane Change Assistant deactivates or is sporadically inoperative when the vehicle is driven in slow-moving stop-and-go traffic, especially on roads with multiple lanes.The message "Audi side assist unavailable: Sensors blocked" appears in the driver information system. The system is able to be activated approximately ten minutes after the traffic condition is removed, or after an ignition cycle. DTCs are stored in the Lane Change Assistance control module. Audi Lane Change Assistant can be activated without issue. No obstructions can be found on the outside or inside of bumper. No re-work of the bumper can be found. The control module mounting brackets are securely fastened to the lower rear bumper, and no damage is found on the inside or on the outside rear bumper area. The control module mounting brackets are not broken or loose. In certain normal driving conditions, the Audi Side Assist system can automatically deactivate, and the driver information display shows the "sensors blocked" message. This is normal, as the nature of certain driving conditions can make it difficult for the Audi Side Assist system to track vehicles.
A911317 2035919-2017-10-31. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). GPS inaccuracies can be caused by several different factors. If it is unclear if this PSS applies, submit a Technical Assistance Center ticket for additional instruction. Perform Spec Actual and attach the GFF log to the ticket. Customer states the navigation system is not tracking the vehicle correctly. No DTCs related to the GPS antenna or MMI system are present. The issue occurs after the vehicle is parked overnight or for several hours in a parking garage or other similar enclosed space. A private home garage does not apply. The issue does not occur if the vehicle is parked overnight or for several hours in an open-sky environment. The condition continues for the duration of the drive. The issue only corrects itself with a 3-finger reset or during a vehicle sleep cycle. The vehicle is not a Q7 or A8. If the above conditions apply and the customer vehicle is a Q7 or A8, submit a Technical Assistance Center ticket for additional instruction. Perform Spec Actual and attach the GFF log to the ticket.
A571398 2035173-2017-10-31. Service bulletin. ELECTRICAL SYSTEM; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. Supersedes Technical Service Bulletin Group 57 number 13-96 dated October 16, 2013. Customer may report that the automatic door lock function cannot be deactivated. The "Lock when driving" (Autolock) configuration setting has been discontinued starting in some model year 2013 vehicles, and it is no longer available in the Car >> Vehicle Settings category in the MMI. The vehicle can still be unlocked while it is being driven, at any time, with the central locking switch in the door.
A481356 2036032-2017-10-31. Service bulletin. STEERING. The customer states that the steering feels stiff during turning. The condition occurs when the vehicle is stationary. The steering shaft needs to be updated.
A461363 2034181-2017-10-31. Service bulletin. SERVICE BRAKES. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking.
A441346 2010334-2017-10-31. Service bulletin. WHEELS:LUGS/NUTS/BOLTS/STUDS; WHEELS. Supersedes Technical Service Bulletin Group 44 number 12-32 dated August 2, 2012. Wheel bolt requires torque adjustment. Torque sticks, torque extension bars, and impact guns/wrenches are not approved by Audi of America, Inc., and should not be used to apply torque to wheel bolts. Always use a calibrated torque wrench to attain the correct wheel bolt torque and follow the proper wheel tightening procedure as outlined in Elsa. Proper use of a calibrated torque wrench ensures that all wheel bolts are tightened equally and reduces the chances of repeat repairs. Using methods other than a calibrated torque wrench to attain correct wheel bolt torque may lead to problems.
A401337 2035854-2017-10-31. Service bulletin. SERVICE BRAKES, HYDRAULIC; SUSPENSION. The customer reports hearing a rattling or knocking noise when the car is driven over bumps or uneven road surfaces. The noise is noticed after the car has been driven for a while and is warmed-up, and when the temperature outside is warm. The condition can be duplicated if the brakes are applied while the car is driven over bumps. High ambient temperatures at the hydraulic guide links cause the noise.
A271320 2033524-2017-10-31. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 27 number 13-17 dated April 5, 2013. Cruise control deactivates sporadically or cannot be activated. A new set speed cannot be saved. ?Set? button on cruise control stalk does not work. DTCs are present in the vehicle. Incorrect tolerances of cruise control ?Set? button.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.