WenmarOpen by Wenmar Pro

Service bulletin NTB22-080

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id11007874
Published by NHTSA2024-09-18
Manufacturer's numberNTB22-080
Manufacturer's date2024-09-18
Campaign id or software versionR22A6
NHTSA componentSERVICE BRAKES

NHTSA's summary

CAMPAIGN BULLETIN Hydraulic Brake Booster Voluntary Safety Recall Campaign Reference: R22A6 Date: September 18, 2024 Attention: Dealer Principal, Sales, Service & Parts Managers SAFETY RECALL CAMPAIGN ID: R22A6 | REVISION 3 ***** Campaign Summary ***** Nissan is committed to the safety and security of our customers and their passengers. Nissan has notified the National Highway Traffic Safety Administration (NHTSA) that it is recalling certain MY2017-2019 Nissan Rogue Hybrid vehicles to address a hydraulic brake booster concern. Frequent braking in a short period of time, combined with high engine room temperatures can lead to the failure of the hydraulic brake booster motor. If this condition occurs, the customer may observe the illumination of the brake warning light (with buzzer) and the brake pedal will be hard to depress. Dealers will replace the hydraulic brake booster power supply unit. IMPORTANT: It is a violation of Federal law for dealers to sell or deliver new vehicles in their inventory covered by this notification until the campaign’s remedy action is performed.): REVISION 3 Please discard earlier versions of this bulletin. The announcement from November 7, 2023 has been revised to include the following: • Nissan is requesting that dealers return excess inventory of parts that apply to this campaign if they are not needed. • The parts return request has been updated to include part number 47212-4CE0A and has been added to the table under the “Service Parts Return” section of this dealer announcement. • Follow the instructions under the “Service Parts Return” section of this dealer announcement for information on how to return excess inventory of these parts: • Nissan is requesting dealers to check their parts inventories for any of the part numbers listed in the table below under the “Service Parts Return” section. • If any of these parts are found in your inventory and they will not be needed, please return to your facing PDC per the instructions below. • These returns will not affect the dealer’s obsolescence accrual. Affected Models/Years: Affected Population: Dealer Inventory: SERVICE COMM Activation date: Stop Sale In Effect 2017-2019 Rogue Hybrid (T32H) 5,903 NA July 29, 2022 YES

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Brakes

Vehicles listed
NISSAN ROGUE HYBRID2017, 2018, 2019 (the catalog's model; the bulletin names a series or trim of it)

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
22V5490002022-07-28. SERVICE BRAKES, HYDRAULIC:POWER ASSIST:HYDRAULIC
20190902019-02-26. Brakes

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
NTB19-042F2025-02-25. Service bulletin. AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions: • When contamination or foreign material adhere to the lane camera viewing window on the windshield. • When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield. • When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information: • Refer to the following pages. • Use the search keyword “blinking” in the ESM.
NTB19-033G2025-02-25. Service bulletin. INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual
NTB10-145B2023-04-06. Service bulletin. ABS/VDC CAN DIAGNOSIS INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
PC687 Rogue2019-07-22. Service bulletin. Left Rear Brake Caliper Voluntary Service Campaign ***** Campaign Summary***** Nissan is conducting a Voluntary Service Campaign to inspect and if necessary replace the left rear brake caliper in certain 2019 model year Rogue (T32) vehicles. Subject vehicles that are equipped with a left rear caliper with a specific lot code do not meet Nissan quality standards. If the vehicle is equipped with a subject brake caliper, the caliper mounting may crack. While vehicle braking effectiveness may be reduced in this condition, the customer?s ability to control and decelerate the vehicle will not be significantly affected. To identify if this condition exists, dealers will inspect the lot code and, if applicable, replace the left rear brake caliper. ***** What Dealers Should Do ***** 1. Verify if vehicles are affected by this Voluntary Service Campaign using Service Comm or DBS National Service History - Open Campaign I.D. PC687. 2. Dealers should repair any affected vehicles in retailer new or pre-owned inventory to help ensure customer satisfaction. 3. Dealers should use NTB19-051 to inspect and, if necessary, remedy any vehicles subject to this campaign. 4. The service department should submit the applicable warranty claim for the action performed so it can be closed on Service Comm and release the vehicle.
NTB19-0512019-07-22. Service bulletin. VOLUNTARY SERVICE CAMPAIGN 2019 ROGUE; LEFT REAR BRAKE CALIPER ASSEMBLY INTRODUCTION Nissan is conducting this voluntary service campaign on certain specific model year 2019 Rogue vehicles. The left rear brake caliper assembly will be inspected, and replaced if needed. This service will be performed at no charge to the customer for parts or labor. IDENTIFICATION NUMBER Nissan has assigned identification number PC687 to this campaign. This number must appear on all communication and documentation of any nature dealing with this campaign. DEALER RESPONSIBILITY Dealers are to repair vehicles falling within range of this campaign that enter the service department. This includes vehicles purchased from private parties, vehicles presented by transient (tourists) owners, and vehicles in a dealer?s inventory.
PC687 Rogue Rear2019-03-18. Service bulletin. Rear Brake Caliper *****Dealer Announcement***** Nissan is conducting a quality action to inspect the lot code on the left hand rear brake caliper on 14 specific 2019 Rogue vehicles identified in Service Comm, and if necessary, replace the brake caliper. Affected vehicles are subject to stop sale and are either currently in dealer inventory or assigned and in transit to the dealer. *****What Dealers Should Do***** PLEASE FOLLOW THE ATTACHED REPAIR INSTRUCTIONS: 1. Verify if vehicles currently in new dealer inventory are affected by this quality action using Service Comm I.D. PC687 ? New vehicles in dealer inventory can also be identified using DCS (Sales-> Vehicle Inventory, and filter by Open Campaign). ? Refer to NPSB 15-460 for additional information ? Please continue to check newly arriving inventory for campaign applicability. 2. Use the attached procedure to inspect the left hand rear brake caliper: ? If the lot code is 9A24, the brake caliper must be replaced ? Nissan has developed an automatic parts shipment to proactively provide affected dealers with replacement brake calipers for affected vehicles in dealer inventory, in the event they are needed. Parts should begin to arrive at dealers on February 27, 2019 ? If not, reassemble the wheel and tire 3. The service department should submit the applicable warranty claim for the action performed so it can be closed on Service Comm and release the vehicle. ***** Dealer Responsibility ***** It is the dealer?s responsibility to check Service Comm or DBS National Service History ? Open Campaign using the appropriate campaign I.D for the inspection status on each affected vehicle currently in new vehicle inventory.
PC6512018-12-10. Service bulletin. CAMPAIGN BULLETIN Rear Brake Hose Bracket *****Dealer Announcement***** Nissan is conducting a quality action to inspect 1,120 specific 2018.5 Rogue and Rogue Hybrid vehicles identified in Service Comm, and if necessary, tighten the rear brake hose bracket fasteners to the specification. Affected vehicles are not subject to stop sale and are either currently in dealer inventory or assigned and in transit to the dealer. Nissan requests dealers to complete this inspection and, if necessary, repair prior to sale to ensure customer satisfaction. *****What Dealers Should Do***** PLEASE FOLLOW THE ATTACHED REPAIR INSTRUCTIONS: 1. Verify if vehicles currently in new dealer inventory are affected by this service action using Service Comm I.D. PC651 - New vehicles in dealer inventory can also be identified using DCS (Sales-> Vehicle Inventory, and filter by Open Campaign). - Refer to NPSB 15-460 for additional information - Please continue to check newly arriving inventory for campaign applicability. 2. Use the attached procedure to inspect the vehicle. - Do not file a claim if the bracket is loose (moveable by hand) or the bolt(s) are missing. Additional Steps are required for a Loose Bracket or Missing bolts. - Email the following information to: nnafqasupport@nissan-usa.com - E-mail subject line: PC651 Rear Brake Hose Bracket - Attach clear pictures of bracket - Dealer Name: - Dealer Code: - Dealer Address: - VIN: - Contact Person Name: - Contact Person Phone Number: - Continue to HOLD the vehicle.
NTB17-0912017-10-15. Service bulletin. 2013-2017 ALTIMA AND 2014-2017 ROGUE; MIL ON WITH DTC P2004 STORED IF YOU CONFIRM MIL is ON with P2004 (INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSOR) stored. And There are no drivability issues. ACTION 1. Remove the intake manifold. 2. Replace the intake manifold runner control valve position sensor. 3. Re-install intake manifold.
NTB17-082a2017-10-15. Service bulletin. NISSAN; DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. The APPLIED VEHICLES and CLAIMS INFORMATION sections have been revised. No other changes have been made. Please discard previous versions of this bulletin.