WenmarOpen by Wenmar Pro

Service bulletin SSM 52631

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id11003131
Published by NHTSA2024-07-03
Manufacturer's numberSSM 52631
Manufacturer's date2024-06-19
NHTSA componentELECTRICAL SYSTEM

NHTSA's summary

Some 2024 Bronco vehicles equipped with a dealer installed trailer tow kit may exhibit a "No Key Detected" message displayed in the IPC. This may be due to the remote keyless entry (RKE) antenna connection being left loose or disconnected during trailer tow kit installation. Verify that the vehicle is equipped with the trailer tow kit by checking the window sticker for the trailer tow kit option. If the vehicle was equipped with this dealer installed option, before performing normal diagnostics, inspect the RKE antenna connections located behind the left/rear interior quarter panel. If they are loose or unplugged, re-secure the connector(s) and retest operation. If no loose or unplugged connections are found, refer to Workshop Manual (WSM), Section 419-01 for normal diagnostics. If this vehicle does not have the dealer installed option, refer to the WSM, Section 419-01 for normal diagnostics.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Electrical system

Vehicles listed
FORD BRONCO2024

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20263562026-07-20. Electrical
26V4680002026-07-20. ENGINE; ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD
20260052026-01-09. Electrical
20255542025-10-10. Electrical

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
SSM 552402026-10-13. Service bulletin. Some 2021-2024 Bronco vehicles may exhibit an illuminated red brake warning indicator with diagnostic trouble code (DTC) C0049:01 stored in the anti-lock brake system (ABS) module. This may be due to pin fitment at the brake fluid level sensor connector. To resolve this concern, replace the brake fluid reservoir and replace the brake fluid level sensor electrical connector C1052 with service pigtail wiring kit 3U2Z-14S411-BXAB. For claiming, use causal part 2L210 and labor operations 2140A and 2219D45WR.
TSB 26-23802026-09-29. Service bulletin. This article supersedes TSB 25-2575 to update the Parts list to add the applicable body wiring harnesses and underbody shield bolts. Some vehicles listed in the Model statement above may exhibit a "Sta-bar Disconnect Service Required" message in the instrument panel cluster (IPC) with any of the following diagnostic trouble codes (DTCs) stored in the chassis control module (CHCM): C103A, C1A99, C1B03, C1B07, C1B14 and/or B1A67. This may be due to water intrusion in the stabilizer bar wiring harness connector.
ECG-26.2.12.3 Bronco,Esca2026-09-11. Over-the-air update. Quality improvements include: -ePrivacy enhancements
SSM 551182026-09-01. Service bulletin. Some of the following vehicles: * 2023-2025 F-Super Duty built on or before 02-Feb-2025 * 2024-2026 Ranger/Bronco/Mustang * 2024-2025 F-150 built on or before 15-Jul-2025 * 2024-2025 Nautilus built on or before 16-Feb-2025 * 2025 Explorer/Aviator built on or before 01-Feb-2025 may exhibit all of the following symptoms: - "No Key Detected" message displayed on the instrument panel cluster (IPC). - Key fob does not work in the backup slot. - Remote keyless entry (RKE) (lock and unlock from the key fob) functionality will work to lock/unlock the vehicle. If the vehicle exhibits these symptoms, start the vehicle using both key fobs. If the no crank/no start condition with "No Key Detected" concern is present, reprogram both key fobs and retest. If the no crank/no start condition with "No Key Detected" is still present, replace the body control module (BCM). Refer to Workshop Manual (WSM), Section 419-10. For claiming, use causal part 15604 and labor operation MT55118SSM up to 1.8 hours.
26E042026-08-03. Emissions. NEW VEHICLE DELIVERY HOLD - Emissions Recall 26E04 Certain 2021-2025 Model Year F-150, Maverick, Mustang, Ranger, Expedition, Bronco Sport, Explorer, Bronco, Navigator, and Aviator Vehicles Powertrain Control Module Software Update
SSM 550312026-07-28. Service bulletin. Some 2021-2026 Ford/Lincoln vehicles may exhibit various symptoms including but not limited to the auto start/stop system not operating as intended with a "Check Charging System" message in the instrument panel cluster (IPC) while the charging system is operating properly with no charging related diagnostic trouble codes (DTC) stored. This may be due to someone using an aftermarket programmer to change the body control module (BCM) configuration to disable the auto start/stop system or perform other unsupported programming modifications. To correct this condition on F-150 and Bronco vehicles, download and run the Ford Diagnosis and Repair System (FDRS) application titled "BCM-Charging System Configuration Correction". Running this application will determine if the BCM configuration was modified by the customer and if so, provide the option to return the configuration back to factory settings. For other vehicle models exhibiting concerns related to unsupported aftermarket BCM programming, submit a Technical Support Request (TSR) requesting support to revert the BCM configuration
SSM 550282026-07-28. Service bulletin. Some 2021-2024 Ford and Lincoln vehicles may exhibit an "Updating SYNC" message on the vehicle center display screen after an over the air (OTA) update. The message can be cleared from the center display screen and SYNC can be used normally, but it will re-appear at every subsequent ignition cycle. Inform customers that engineering is currently working on a software update solution for this condition to be delivered OTA expected in late Q3 2026. Software will update automatically if vehicle connectivity is enabled in the vehicles settings. Monitor Professional Technician System (PTS) for additional information.
SSM 550092026-07-20. Service bulletin. Some 2021-2026 Bronco vehicles may exhibit a "Park Brake Limited Function Service Required" message in the instrument panel cluster (IPC). This may be due to an issue with the driver door harness connector after removing and installing the removeable doors. If diagnostic trouble code (DTC) B1625:29 is stored in the driver door module (DDM), inspect connector C322C between the upper and lower door hinges that attaches to the body for proper installation and/or pin fitment. Repair as necessary. If the condition was caused by improper door installation, do not submit a claim for this condition. If no concerns are found with the connector, refer to Workshop Manual (WSM), Section 501-11 > Diagnosis and Testing for normal diagnostics.
SSM 549922026-07-13. Service bulletin. Some 2024-2026 Bronco vehicles may exhibit various TRM concerns when attempting first time installation of a dealer installed accessory TRM, including one or more of the following: TRM unable to be programmed -Trailer lights inoperative -DTC U2100 stored in the TRM. This may be due to any of the following conditions:-The incorrect trailer tow kit is being installed. The TRM is model year specific. Refer to the parts catalog using the VIN and base part number 15A416 for the vehicle specific trailer tow kit.-The "TRM - Trailer Module (TRM) Configuration" application being run instead of the "Towbar Configuration" application during first time TRM installation using the Ford Diagnosis and Repair System (FDRS). Dealer installed accessory TRMs are preprogrammed and only the "Towbar Configuration" application should be run during first time TRM installation to configure the TRM properly and support proper function of trailer tow capabilities. Any attempts to program the TRM using the "TRM - Trailer Module (TRM) Configuration" application a
TSB 26-22972026-06-29. Service bulletin. Some of the vehicles listed in the model statement above equipped with SYNC4 may experience a blank center display screen or black center display after welcome animation. The rear-view camera will still function when shifting the vehicle to reverse under these conditions.