WenmarOpen by Wenmar Pro

Service bulletin SSM 52189

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10249176
Published by NHTSA2024-01-24
Manufacturer's numberSSM 52189
Manufacturer's date2024-01-18
NHTSA componentELECTRICAL SYSTEM

NHTSA's summary

Some 2020-2024 Explorer/Aviator vehicles may exhibit poor speaker sound quality and/or tick-tock noise while activating turn signals and streaming audio over Bluetooth. Customers may describe static heard during a Bluetooth phone call or a door speaker buzz or tick noise with the pulse of the turn signal. This may be due to concerns with the 14401/14A005 wiring harnesses or connector damage. Prior to the replacement of the affected speaker, inspect for incorrect pin fit/crimp, bent pins, broken wire strands, or other damage at inline connectors C202, C2383A, and/or C4240B. These circuits join the accessory protocol interface module (APIM) and audio front control module (ACM) components. If wiring/connector concerns are found, repair per Wiring Diagram Cell 5.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Electrical system

Vehicles listed
FORD EXPLORER2020, 2021, 2022, 2023, 2024
LINCOLN AVIATOR2020, 2021, 2022, 2023, 2024

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20260052026-01-09. Electrical
20255542025-10-10. Electrical
25V3490002025-05-23. ELECTRICAL SYSTEM:PROPULSION SYSTEM:TRACTION BATTERY
24V6850002024-09-13. HYBRID PROPULSION SYSTEM; ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES
23V6860002023-10-13. BACK OVER PREVENTION:DISPLAY FUNCTION; ELECTRICAL SYSTEM:WIRING
23V6260002023-09-08. ELECTRICAL SYSTEM:PROPULSION SYSTEM:TRACTION BATTERY
21V5340002021-07-15. VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:COMPRESSOR; ELECTRICAL SYSTEM:WIRING
19V6870002019-09-30. ELECTRICAL SYSTEM:WIRING
19V5750002019-08-05. PARKING BRAKE; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL)

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
TSB 26-23252026-10-05. Service bulletin. Some of the vehicles listed in the Model statement above may exhibit a front courtesy lamp that is inoperative. This may be due to a concern with the front courtesy lamp light module.
TSB 26-23952026-09-01. Service bulletin. This article supersedes 26-2287. Reason for update: update the labor operation numbers to add MT to operations C, F, G, H, J, K, L and M, and correct the part number LIMZ-4A015-B to L1MZ-4A015-B. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: Harsh engagement Delayed engagement Harsh shift Delayed shift Illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC)s P0751, P0752, P0756, P0757, P0761, P0762, P0766, P0767, P0771, P0772, P2700, P2701, P2702, P2703, P2704, P2705, P2707, P2708, P0729, P0731, P0732, P0733, P0734, P0735, P0736, P076F, P07D9, P07F6 and/or P07F7 stored in the powertrain control module (PCM) or transmission control module (TCM). This may be due to axial movement of the CDF clutch cylinder sleeve causing hydraulic circuit leaks. NOTE: If internal transmission service is required to address a concern detected with the CDF clutch cylinder following this article, technicians should carefully inspect and replace other transmission components and flush transmission fluid cooler only as ne
SSM 550692026-08-11. Service bulletin. Some 2020-2025 Explorer vehicles equipped with a power roof opening panel may exhibit a sunshield with localized bunching or binding/inoperative. This may be due to a broken or missing sunshield fabric retainer/clip. A revised sunshield clip (LJ6Z-5452118-B) is now available to address this condition. It is not necessary to replace the entire sunshield assembly if the clip(s) are broken or missing. Refer to Workshop Manual (WSM), Section 501-17 Roof Opening Panel > General Procedures > Inspection and Replacement of the Roof Opening Panel Shield Clip.
SSM 550602026-08-04. Service bulletin. Some 2024-2026 Explorer vehicles built on or before 27-Feb-2026 and equipped with the panoramic glass roof may exhibit an uneven gap at the front edge of the roof opening panel shield when fully closed. The gap is an appearance issue only, but may allow outside light to pass through the opening. A new gap hider seal has been released to correct this condition (service part number SB5Z-7851884-A). Adjustment or replacement of the glass, shade or headliner assembly is not necessary. The new seal is installed directly onto the existing vertical flange that is present and visible at the front of the opening when the shade is opened. Once installed, the front edge of the shade will press against the new seal when fully closed. To install, center the seal in the opening with the flexible material facing the power shade and press the seal u-channel over the vertical flange. Explorer vehicles built on or after 27-Feb-2026 have the seal already installed and can be referenced if necessary. Once the seal is installed, perform the shield/shade initialization procedure in Workshop Manual (WSM), Section 501-05 > Gen
SSM550592026-08-03. Service bulletin. Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost engine, 2020-2026 Explorer vehicles equipped with a 3.3L hybrid engine, and 2020-2023 Lincoln Aviator vehicles equipped with a 3.0L EcoBoost hybrid engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM). The vehicle may be unable to enter electric-only drive modes as expected during normal drive cycles. This may be due to the belt integrated starter generator (BISG). For vehicles with this condition, follow the necessary Pinpoint Test in Workshop Manual (WSM), Section 303-06 for DTC P0A1E and repair the vehicle as directed. Note that previous replacement of the BISG does not negate the need for subsequent BISG replacements if directed to do so by the appropriate Pinpoint Test diagnostics. Engineering is investigating this BISG quality concern. Monitor PTS for updates regarding this investigation.
26E042026-08-03. Emissions. NEW VEHICLE DELIVERY HOLD - Emissions Recall 26E04 Certain 2021-2025 Model Year F-150, Maverick, Mustang, Ranger, Expedition, Bronco Sport, Explorer, Bronco, Navigator, and Aviator Vehicles Powertrain Control Module Software Update
SSM 550312026-07-28. Service bulletin. Some 2021-2026 Ford/Lincoln vehicles may exhibit various symptoms including but not limited to the auto start/stop system not operating as intended with a "Check Charging System" message in the instrument panel cluster (IPC) while the charging system is operating properly with no charging related diagnostic trouble codes (DTC) stored. This may be due to someone using an aftermarket programmer to change the body control module (BCM) configuration to disable the auto start/stop system or perform other unsupported programming modifications. To correct this condition on F-150 and Bronco vehicles, download and run the Ford Diagnosis and Repair System (FDRS) application titled "BCM-Charging System Configuration Correction". Running this application will determine if the BCM configuration was modified by the customer and if so, provide the option to return the configuration back to factory settings. For other vehicle models exhibiting concerns related to unsupported aftermarket BCM programming, submit a Technical Support Request (TSR) requesting support to revert the BCM configuration
SSM 547952026-05-08. Service bulletin. Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost engine and 2020-2026 Explorer vehicles equipped with a 3.3L hybrid engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM). The vehicle may be unable to enter electric-only drive modes as expected during normal drive cycles. This may be due to the software within the belt integrated starter generator (BISG). For vehicles with this condition, follow Pinpoint Test I: Battery Isolation/Voltage Stabilization Control Circuit Carry Outance located in the Workshop Manual (WSM), Section 303-06D and repair the vehicle as necessary. Note that the BISG is on backorder status at the time of this publication and Ford is working to make parts available. Engineering is investigating this concern. Monitor PTS for updates.
23B642026-04-30. Other. Customer Satisfaction Program 23B64 Certain 2020-2024 Model Year Multiple Vehicle Lines Equipped with High Voltage Batteries Battery Energy Control Module (BECM) Software Update
SSM 547202026-04-10. Service bulletin. Various 2020-2026 Ford and Lincoln vehicles equipped with blind spot information system (BLIS) may experience an inoperative blind spot monitoring with a "Blind Spot System Fault" message displayed in the instrument panel cluster (IPC). This may also be accompanied by diagnostic trouble codes (DTCs) B118C:11 and/or B118C:15 stored in the driver door module (DDM), and/or B118D:11 and/or B118D:15 stored in the passenger door module (PDM). This may be due to the wiring connector from the mirror to the BLIS module. If diagnostics lead to an internal mirror wiring harness fault, a new lower level BLIS light pigtail is now released for service. It is not necessary to replace the exterior mirror assembly. Use part number SC3Z-14A411-B to resolve the concern.