WenmarOpen by Wenmar Pro

Service bulletin NTB22-104

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10229661
Published by NHTSA2023-01-10
Manufacturer's numberNTB22-104
Manufacturer's date2022-12-12
NHTSA componentSTRUCTURE

NHTSA's summary

DIAGNOSING DOOR LOCK OPERATION SERVICE INFORMATION If a customer describes a concern of a door not opening and/or unlocking properly, on any of the APPLIED VEHICLES, use the Questions for the Customer below to help reproduce the concern, and then follow the SERVICE PROCEDURE starting on page 2 to determine if the Door Lock should be replaced. • Do not replace a Door Lock unless instructed to by the SERVICE PROCEDURE. Questions for the Customer: • When did you first notice the issue? • Is it consistent or intermittent? • Under what conditions does it occur? • Does it seem more likely to happen to a specific passenger/person in your family? • Has there been any change to the issue since it first began?

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Body and frame

Vehicles listed
NISSAN ALTIMA2021
NISSAN ALTIMA2023
NISSAN FRONTIER2022, 2023
NISSAN PATHFINDER2022, 2023
NISSAN ROGUE2021, 2022, 2023
NISSAN SENTRA2021, 2022
NISSAN redundant ALTIMA2022

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20233442023-06-13. Structure
23V4210002023-06-12. STRUCTURE:BODY
20215572021-09-13. Structure

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
ITB09-063C2026-04-29. Service bulletin. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
NTB09-131C2026-04-29. Service bulletin. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
NTB09-131C2026-04-29. Service bulletin. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
NTB25-0422025-09-15. Service bulletin. EXCESSIVE WIND NOISE FROM WINDSHIELD AREA YOU CONFIRM The customer states there is a screeching, humming, buzzing, whistling and/or squealing type wind noise from the windshield/roof area of the vehicle, AND The wind noise is most noticeable at speeds of 50 mph or higher. ACTION Use the SERVICE PROCEDURE starting on page 4 to install two (2) pieces of foam (one on each side) between the windshield molding and the body roof line. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
NTB25-0292025-06-04. Service bulletin. EXCESS DUST ENTERING CABIN WHILE DRIVING ON DIRT ROADS IF YOU CONFIRM That while driving on dirt roads with all doors and windows closed, that there is excessive dust intrusion into the vehicle’s cabin that is settling on the inside of the doors. ACTION Refer to the SERVICE PROCEDURE in the bulletin to: 1. Install Butyl Patches around the door seals of driver (LH) side and passenger (RH) side front and rear doors. 2. Install drain plugs into door drains of driver (LH) side and passenger (RH) side front and rear doors.
NTB22-068A2024-09-04. Service bulletin. WATER LEAKING FROM REAR WIPER ARM PIVOT SEAL APPLIED VEHICLES: 2021-2024 Rogue (T33) APPLIED DATES: VINs starting with 5N1 built on or before October 1, 2021 VINs starting with JN8 built on or before April 7, 2024 IF YOU CONFIRM Water is found to be leaking around the rear window wiper arm pivot seal after performing a water soak test. ACTION Replace the rear window wiper arm pivot seal with the one listed in PARTS INFORMATION on page 3. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
NTB22-045B2024-09-04. Service bulletin. RATTLE OR KNOCK NOISE FROM FRONT WHEN DRIVING OVER BUMPS AND/OR TURNING APPLIED VEHICLES: 2021-2024 Sentra (B18) APPLIED DATES: Built from January 2, 2021 to April 11, 2024 IF YOU CONFIRM A rattle or knock noise is heard from the front of the vehicle when driving over bumps and/or turning. HINT: To aid in diagnosis, it is recommended that you view the video clip on ASIST before starting. To view the video full screen, right click the center of the video screen and select “Full Screen”. ACTION Follow the SERVICE PROCEDURE in this bulletin to verify the passenger (RH) side Engine Mounting Insulator is the source of the noise, and replace it with the one listed in the PARTS INFORMATION on the last page. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM A rattle or knock noise is heard from the front of the vehicle when driving over bumps and/or turning. HINT: To aid in diagnosis, it is recommended that you view the video clip on ASIST before starting. To view the video full screen, right click the center of the video screen and select “Full Screen”. ACTION Follow the SERVICE PROCEDURE in this bulletin to verify the passenger (RH) side Engine Mounting Insulator is the source of the noise, and replace it with the one listed in the PARTS INFORMATION on the last page. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
NTB22-104A2024-06-13. Service bulletin. DIAGNOSING DOOR LOCK OPERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB21-097B2024-02-08. Service bulletin. WATER LEAK AT TOP FRONT CORNERS OF WINDSHIELD This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB21-019C2024-01-09. Service bulletin. FRONT MAP LAMP NOT WORKING OR SWITCH COMING APART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.