WenmarOpen by Wenmar Pro

Service bulletin 23-023-16

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10218257
Published by NHTSA2022-08-22
Manufacturer's number23-023-16
Manufacturer's date2016-06-02
NHTSA componentVEHICLE SPEED CONTROL; SEATS

NHTSA's summary

Left Rear Door Replacement Due to A Split Or Strain In The Sheet Metal This bulletin involves inspecting the left rear door for a split or strain in the metal adjacent to the latch. If the metal is split or strained then the door assembly must be replaced. The customer may notice the metal adjacent to the latch is split or not smooth to the touch. This indicates the metal near the left rear door latch area is strained or split (Fig. 1).

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Seats, Throttle and cruise control

Vehicles listed
JEEP CHEROKEE2016

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
18V3320002018-05-17. ELECTRICAL SYSTEM:SOFTWARE; VEHICLE SPEED CONTROL:CRUISE CONTROL; ELECTRICAL SYSTEM:WIRING
20163932016-08-10. Seats And Restraints
16V5900002016-08-10. SEATS:MID/REAR ASSEMBLY; SEATS

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
10001202022-10-17. Service bulletin. Airbag Warning Lamp (AWL) Illuminated B0028-13 and B0020-13 This bulletin involves inspecting and installing a jumper harness in the front seats if needed. Customers may experience a AWL illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) set in memory:B0028-13 - Right Side Seat Deployment Squib 1 - Circuit Open. B0020-13 - Left Side Seat Deployment Squib 1 - Circuit Open.
23005212022-10-17. Service bulletin. Front Seat Side Shield Updated Service Procedure This bulletin informs the technician that when either of the front seat side shields are replaced the buckle will need to be replaced as well. If only the buckle needs to be replaced the front seat side shield will need to be modified. The technician will need to know the following: When either of the front seat side shields are replaced the buckle will need to be replaced as well. If only the buckle needs to be replaced the front seat side shield will need to be modified.
2300521REVB2022-09-26. Service bulletin. Front Seat Side Shield Updated Service Procedure This bulletin informs the technician that when either of the front seat side shields are replaced the buckle will need to be replaced as well. If only the buckle needs to be replaced the front seat side shield will need to be modified. The technician will need to know the following: When either of the front seat side shields are replaced the buckle will need to be replaced as well. If only the buckle needs to be replaced the front seat side shield will need to be modified.
90038252022-09-15. Service bulletin. LATCH, Hood For the following concerns, please verify secondary plunger switch before replacing hood latch with primary switch. Please refer to service information for complete diagnostics of the secondary plunger switch which is located in the left front under hood on RU, MP, and WK/WD and left rear under hood on KL. 1) Electronic Stop Start Message on Cluster or DTC P152F without hood ajar illuminated. 2) KL Hood ajar light is on or unlatched hood due to high closing effort. (KL hood may have a higher closing effort to latch the hood as rubber bumper interference is set purposely high to prevent hood flutter at highway speeds) If stop start message or DTC P152F is present on vehicles without a hood ajar light illuminated, the issue is not related to the primary hood latch switch.
90034132022-09-15. Service bulletin. Accelerator Pedal Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. P2122 and P2127 will set if accelerator pedal connector is disconnected during diagnosis. Make sure codes are active before replacing pedal. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
08016162022-08-22. Service bulletin. This bulletin involves updating the Comfort Seat and Wheel Module (CSWM) software for
08113152022-07-05. Service bulletin. This bulletin involves updating the Comfort Seat and Wheel Module (CSWM) software for the KL/UF
10-001-202020-11-30. Service bulletin. Airbag Warning Lamp (AWL) Illuminated B0028-13 and B0020-13 This bulletin involves inspecting and installing a jumper harness in the front seats if needed. Customers may experience a AWL illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) set in memory:B0028-13 - Right Side Seat Deployment Squib 1 - Circuit Open. B0020-13 - Left Side Seat Deployment Squib 1 - Circuit Open.
53034160A2019-05-20. Service bulletin. Part Description: Accelerator Pedal Issue Description: Vehicle has accelerator pedal fault code. Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
08-113-152019-05-20. Service bulletin. Flash: Heated Steering Wheel Temperature Enhancement Depending on vehicle architecture: This bulletin involves updating the Comfort Seat and Wheel Module (CSWM) software for the KL/UF vehicles or the Heated Seat Module (HSM) software for the WK/WD/LD/LA & LX vehicles. A customer may describe that the heated steering wheel shuts off to soon, usually after 30 seconds and does not achieve satisfactory temperature. This is an intermittent condition and more noticeable at temps below 19.5°C (67.1°F).