Service bulletin PM552
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10192509 |
| Published by NHTSA | 2021-05-10 |
| Manufacturer's number | PM552 |
| Manufacturer's date | 2015-01-15 |
| NHTSA component | SUSPENSION |
NHTSA's summary
Nissan is conducting a dealer inventory service action to trim the front strut insulator on 7,098 specific 2014 Sentra (B17) vehicles.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Suspension
| NISSAN SENTRA | 2014 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| NTB99-001F | 2022-01-08. Service bulletin. STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
|---|---|
| NTB15068 | 2021-05-10. Service bulletin. IF YOU CONFIRM * A rattle noise inside the vehicle coming from the engine compartment or instrument panel and/or a brake pedal vibration is present at idle in drive. And * The engine room harness is in contact with the air filter assembly ACTION * Install a zip tie to secure the engine room harness to the driver?s side frame rail. Please see this bulletin for further information. |
| NTB14088B | 2021-05-10. Service bulletin. IF YOU CONFIRM: There is a noise (clunking, popping, or bumping) when the steering wheel is turned AND the noise is coming from the top of either front strut assembly. NOTE: The location of the noise can be determined by using Essential Tool J39570 (Chassis Ear), positioning a clamp on each front strut spring, and then turning the steering wheel back and forth. ACTION: Install a spacer in both the left front and right front strut assemblies where shown in this bulletin. - Refer to the Electronic Service Manual (ESM), section FSU- Front Suspension for removal and installation instructions. See this bulletin for further detail. |
| NTB15020 | 2021-05-10. Service bulletin. IF YOU CONFIRM: - The engine has an over temp condition. - The radiator fan does not operate. - The 40A fusible link for the fan shroud and motor assembly (cooling fan or radiator fan) is open or has no continuity. NOTE: - The MIL may be ON with DTC P1217 (ENG OVER TEMP) stored in the ECM. - The customer may state the A/C does not produce cold air as defined in the Electronic Service Manual. ACTION: 1. Compare the vehicle?s current ECM part number to those listed in Table A (see page 6). 2. If the ECM part number matches one listed in Table A, reprogram the ECM. 3. Replace the 40A fusible link. 4. Replace the fan shroud and motor assembly (cooling fan/radiator fan). 5. Inspect the engine room harness, replace as necessary. 6. Verify cooling system operation and related engine condition. See this bulletin for further detail. |
| NTB99-001e | 2021-03-06. Service bulletin. STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB12-055g | 2020-02-08. Service bulletin. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |