Service bulletin NTB17-040a
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10125187 |
| Published by NHTSA | 2017-12-14 |
| Manufacturer's number | NTB17-040a |
| Manufacturer's date | 2017-11-21 |
| NHTSA component | SUSPENSION |
NHTSA's summary
REVISED WHEEL ALIGNMENT SPECIFICATIONS This bulletin has been amended to add 2018 Versa Sedan and 2018 Versa Note. No other changes have been made. Please discard previous versions of this bulletin.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Suspension
| NISSAN ALTIMA | 2016, 2017 |
|---|---|
| NISSAN FRONTIER | 2016, 2017 |
| NISSAN LEAF | 2016, 2017 |
| NISSAN MAXIMA | 2016, 2017 |
| NISSAN MURANO | 2016, 2017 |
| NISSAN MURANO HYBRID | 2016 (the catalog's model; the bulletin names a series or trim of it) |
| NISSAN NV | 2016, 2017 |
| NISSAN NV200 TAXI | 2016 (the catalog's model; the bulletin names a series or trim of it) |
| NISSAN PATHFINDER | 2016, 2017 |
| NISSAN ROGUE | 2016, 2017 |
| NISSAN VERSA | 2016, 2017, 2018 |
| NISSAN VERSA NOTE | 2016, 2017 |
| NISSAN redundant NV200 | 2016 to 2017 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| NTB99-001F | 2022-01-08. Service bulletin. STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
|---|---|
| NTB21-045 | 2021-06-12. Service bulletin. 2013-2018 ALTIMA AND 2016-2018 MAXIMA; REAR SUSPENSION LOWER LINK IF YOU CONFIRM The customer experiences a knocking or rattling noise from the rear of the vehicle, Or The rear wheel and tire assemblies have a large amount of positive camber. ACTION Replace both rear lower links. |
| Altima Maxima Lo | 2021-06-08. Service bulletin. Rear Lower Suspension Link Warranty Extension Dealer Notification In October 2019, Nissan launched a Voluntary Service Campaign (P9324) on MY2013 Nissan Altima vehicles registered in high road-salt-usage states (Connecticut, Delaware, Iowa, Illinois, Indiana, Kentucky, Massachusetts, Maine, Maryland, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, Washington D.C., West Virginia and Wisconsin). In the interest of customer satisfaction, Nissan is providing a warranty extension to certain MY2013 Nissan Altima vehicles that were not included in P9324 and certain MY2014-2018 Nissan Altima and MY2016-2018 Nissan Maxima vehicles in all states. On some affected vehicles, one of the rear lower suspension links may corrode and separate at the bushing joint area. Customers may notice a knocking or rattling noise from the rear of the vehicle or observe wheel misalignment on the rear wheel(s) if the link separates. Owners of eligible vehicles will receive a notification indicating their eligibility for the following: •Warranty extension for the rear lower suspension links of 84 months and unlimited miles to their current 36 month/36,000 mile New Vehicle Limited Warranty for a total of 120 months warranty coverage (without regard to mileage). •This warranty extension will allow for a one-time replacement of the rear lower suspension links with new parts and a four-wheel alignment if parts are cracked or broken. Voluntary Service Campaign (P9324) on MY2013 Nissan Altima vehicles registered in high road-salt-usage states will continue. What Dealers Should Do: 1.Verify if vehicles are eligible for this Warranty Extension using the warranty extension page of Service Comm. 2.Dealers should remedy any eligible vehicles subject to this warranty extension to ensure customer satisfaction using Technical Field Bulletin NTB21-045. |
| NTB15095B | 2021-05-10. Service bulletin. SERVICE INFORMATION This bulletin contains information for replacement of the Transverse Link Compression Rod Bushing, which is now available as a separate replacement part. See this bulletin for further detail. |
| NTB16007A | 2021-05-10. Service bulletin. IF YOU CONFIRM A vibration is felt in the center console armrest pad, seat base and steering wheel that is accompanied by a droning sound. - Only while driving (does not occur at idle). And - With engine RPM at approximately 1,600 to 1,800. ACTION Remove two rubber "front exhaust tube hangers" shown in Figure 1 that support the rear of the center exhaust tube. IMPORTANT: Vehicles built after the Applied VIN and Date are no longer equipped with exhaust hangers installed in these locations. See this bulletin for further detail. |
| NTB15062A | 2021-05-10. Service bulletin. IF YOU CONFIRM There is a popping noise from either the right or the left front coil springs when turning to the right or left. NOTE: Electronic chassis ears may be helpful in isolating this type of noise. ACTION Replace both front coil springs, strut mount bearings, and all other parts listed under PARTS INFORMATION. Position the coil springs as shown on pages 2-5. Check the front end alignment, adjust to factory specifications as needed. NOTE: Refer to the Electronic Service Manual (ESM), section FSU Front Suspension, for strut coil spring removal, installation, and alignment information. IMPORTANT: The Coil Spring Installation Guidelines section in this bulletin MUST be followed in order for a correct repair to be performed. |
| NTB99-001e | 2021-03-06. Service bulletin. STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB12-055g | 2020-02-08. Service bulletin. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| DOR-H5Y5B-01 | 2020-01-13. Service bulletin. This SKU is a Suspension Ball Joint. The customer communication requested return of unsold inventory to inspect for the outer diameter of the ball joint housing being too small. The outer diameter being too small would prevent the part from being installed, and would therefore have no impact on the end user besides time to complete installation. |
| NTB18-083 | 2019-02-19. Service bulletin. 2014 - 2019 ROGUE; SQUEAK/CREAK NOISE FROM FRONT SUSPENSION BOUND BUMPER DRIVING OVER BUMPS IF YOU CONFIRM Using the flow chart on page 2, a squeak/creak noise is heard coming from the left or right front suspension bound bumper when driving over speed bumps or similar road surfaces. NOTE: This squeak/creak noise, if it should occur, is more noticeable in cold weather. ACTION Replace the front suspension bound bumper, only on the side that is making noise. - Refer to the appropriate Electronic Service Manual (ESM) for replacement information. SUSPENSION > FRONT SUSPENSION > REMOVAL AND INSTALLATION > FRONT COIL SPRING AND STRUT > Removal and Installation. - Pages 4 - 6 in this bulletin contain helpful information to perform this procedure. - Make sure to replace the one-time-use nuts listed in the PARTS INFORMATION. - Check the front wheel alignment; adjust to factory specifications as needed. NOTE: DO NOT apply lubricant to the bound bumper to resolve this issue. |