Service bulletin ITB-13-050

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10054093
Published by NHTSA	2013-12-20
Manufacturer's number	ITB-13-050
Manufacturer's date	2013-12-05
NHTSA component	EQUIPMENT; ELECTRICAL SYSTEM

NHTSA's summary

INFINITI: ONCE BCM GOES INTO SLEEP MODE AND ALL DOORS ARE LOCKED, ALL OF APPLIED VEHICLES REMOTE FUNCTIONS FAILS WORK FOR APPROXIMATELY 15-20 MINUTES. MODEL 2013 JX35. *PE

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Electrical system, Equipment and accessories

Vehicles listed
INFINITI JX35	2013

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
14V138000	2014-03-25. AIR BAGS:FRONTAL; ELECTRICAL SYSTEM:SOFTWARE
13V445000	2013-10-17. ELECTRICAL SYSTEM:SOFTWARE; SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
ITB12-011R	2026-04-29. Service bulletin. TELEMATICS SERVICE INFORMATION See ITB19-029 for models built after those listed above for a different Service Procedure. SERVICE INFORMATION The Applied Vehicles are equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active Infiniti Connection® or Infiniti InTouch Services™, the TCU communicates with the Infiniti Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the Applied Vehicles. Ø A table has been provided on the next page that lists the model and year specific steps required to successfully configure a TCU after it has been replaced. Ø A check OFF sheet has been provided on page 21 to print and check off steps as they are performed. Please staple the completed Check OFF Sheet to the repair order.
ITB13-052E	2024-06-28. Service bulletin. INTELLIGENT KEY NOT DETECTED / ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB13-006D	2024-06-28. Service bulletin. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB10-029C	2024-06-14. Service bulletin. CAN COMMUNICATION CODES – DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB12-011Q	2024-02-08. Service bulletin. TELEMATICS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB19-024C	2023-04-04. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB22-040	2022-12-06. Service bulletin. 3G TELEMATICS HARDWARE DEACTIVATION SERVICE INFORMATION The APPLIED VEHICLES that come equipped with a factory installed SOS switch, located near the overhead map lamp, also come equipped with a wireless communication device called a Telematics Communication Unit (TCU). AT&T discontinued its U.S. 3G network coverage on February 22, 2022. As a result, automakers that utilize AT&T’s 3G network connection, including Nissan Group, have had connectivity services affected. INFINITI Connection with InTouch™ Services are no longer available on the APPLIED VEHICLES listed above.
ITB19-024B	2022-05-20. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB12-072G	2022-05-20. Service bulletin. INFINITI AWD MODELS; ABNORMAL NOISE, VIBRATION AND/OR JUDDER FROM REAR DIFFERENTIAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB22-006	2022-03-12. Service bulletin. BATTERY QUICK CHARGE NOTICE SERVICE INFORMATION When charging the vehicle’s 12 volt battery with the high amperage quick charge function, the ignition should never be ON, or turned ON, while charging. Attempting to start the vehicle, or turning the ignition ON, while using the high amperage quick charge could potentially damage the fuel pump control module. • Only turn the ignition ON when either the ESM or a technical service bulletin service procedure states to do so, and only while using a battery maintainer or smart charger set to reflash mode, or a similar setting. • Battery voltage should not exceed 16V during a reprograming operation.