WenmarOpen by Wenmar Pro

Service bulletin AS-21578

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10039138
Published by NHTSA2011-07-12
Manufacturer's numberAS-21578
Manufacturer's date2010-11-01
NHTSA componentPOWER TRAIN:DRIVELINE

NHTSA's summary

FORD: THERE IS A RATTLE NOISE WHEN DRIVING 25-30 MPH FROM THE TRANSMISSION WHEN UNDER LOAD. 2009-2010 F-150. *RM

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Transmission and driveline

Vehicles listed
FORD F-1502009, 2010

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
TSB 22-22192022-06-27. Service bulletin. Some 2003-2020 Expedition/Navigator and 2006-2020 F-150 (non-Raptor) vehicles equipped with 4WD may exhibit grinding/clicking/ratcheting noise from the front wheel area. This may be due to partial engagement of the integrated wheel ends (IWE). To correct this condition, follow the Service Procedure to remove and cap the vacuum supply line or to reprogram the transfer case control module (TCCM) and replace any worn vacuum and/or IWE components.
TSB1600322021-12-20. Service bulletin. 4R75E Transmission - Grinding/Whine/Vibration/Gear Slippage - Serrvice Kit available
SSM 479762019-06-07. Service bulletin. On vehicles equipped with an automatic transmission it is imperative that the converter pilot hub be greased with Motorcraft Multi-Purpose Grease Spray XL-5-A even if grease was not applied from the factory. Also verify that the engine/transmission alignment dowel pins are present as well as the engine crankshaft dowel pin, if equipped, when installing the transmission. Failure to adequately lubricate the converter hub greatly increases the likelihood of the flexplate cracking in the future. Missing dowels may cause a misalignment issue also resulting in a premature failure. Refer to Workshop Manual (WSM), Section 307-01.
SSM 469002018-01-29. Service bulletin. Some vehicles may exhibit a no start condition with an illuminated malfunction indicator lamp (MIL) and a DTC P161A after PCM replacement. This may be due to the parameter reset procedure not being properly completed. To clear this DTC, use the Ford Integrated Diagnostic System (IDS) service tool or Ford J2534 Diagnostic Software, select - Toolbox - Body - Security - PATS Functions - Parameter Reset. Follow the on-screen instructions to complete the procedure. This procedure will transfer the existing Key ID information between the modules without the need of having 2 programmed PATS keys present. There is no need to program keys when the PCM is going to be replaced. Additional information can be found in the Workshop Manual (WSM), Section 419-01. Missing or lost keys are not warrantable.
SSM 464512017-05-17. Service bulletin. 2009-2017 VEHICLES EQUIPPED WITH A 6R80, 6R100, 6R140 AUTOMATIC TRANSMISSION HAVE AN UPDATED MAIN CONTROL VALVE BODY OVERHAUL PROCEDURE. REFER TO WORKSHOP MANUAL (WSM), SECTION 307-01 FOR MAIN CONTROL VALVE BODY (7A100) OVERHAUL PROCEDURES. NOT ALL VALVE BODIES REQUIRE REPLACEMENT. INSPECT THE VALVE BODY BORES, SPRINGS AND VALVES AS DIRECTED DURING DIAGNOSIS AND REPAIR. REFER TO GENERAL SERVICE BULLETIN (GSB) G0000093 AUTOMATIC TRANSMISSION MAIN CONTROL INSPECTION FOR A VIDEO CLIP TO AID IN THE DIAGNOSIS OF THESE REPAIRS.
TSB16-01082017-02-21. Service bulletin. SOME 2004-2014 F-150 AND 2006-2008 MARK LT VEHICLES EQUIPPED WITH FOUR-WHEEL DRIVE (4WD) MAY EXHIBIT NOISY OR ENGAGED FRONT HUBS WHEN OPERATING IN TWO-WHEEL DRIVE (2WD) MODE. FOLLOW THE SERVICE PROCEDURE STEPS TO CORRECT THE CONDITION.
16-00322016-06-22. Service bulletin. 4R75E TRANSMISSION - GRINDING/WHINE/VIBRATION/GEAR SLIPPAGE - SERVICE KIT AVAILABLE ISSUE A service kit has been released to assist with proper repair of the 4R75E transmission in 2008 Mark LT, 2008-2010 F-150, 2008-2010 / 2013-2014 E-Series, 2008-2011 Crown Victoria, Grand Marquis and Town Car vehicles that exhibit a grinding, whine-type noise, vibration and/or gear slippage while driving, or a loss of reverse resulting from a planetary gear assembly failure.
TSB-14-01532015-02-03. Service bulletin. FORD/LINCOLN/MERCURY: FAILURE OF PLANETARY GEAR ASSEMBLY IS DUE TO TRANSMISSION, ON CERTAIN VEHICLES, EXHIBITING GRINDING, GEAR SLIPPAGE, WHINE TYPE NOISE, VIBRATION, WHILE DRIVING OR LOSS OF REVERSE. *PE
ASI-445382014-10-01. Service bulletin. FORD/LINCOLN/MERCURY: THE INDICATOR MAY ILLUMINATE OVERDRIVE OFF AND/OR SLIPPING IN 3RD OR NO 4TH GEAR, DUE TO DIRECT CLUTCH FAILURE AND DIAGNOSTIC TROUBLE CODE (DTC) P0733 AND/OR P0734. MODEL 2008-2013 MARK LT, F-150, CROWN VICTORIA, GRAND MARQUIS, TOWN CAR, E SERIES. *PE
TSB-14-00692014-07-17. Service bulletin. LINCOLN/MERCURY/FORD: THERE IS FLUID LEAKING AROUND THE TRANSMISSION BULKHEAD CONNECTOR SLEEVE, FROM THE TRANSMISSION. MODEL 2009-10 EXPEDITION, EXPLORER, EXPLORER SPORT TRAC, F-150, NAVIGATOR, MOUNTAINEER. *PE