Transport Canada recall 2026432
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2026432 |
| Manufacturer's number | 26S69 |
| Reported | 2026-09-09 |
| Component | Fuel System |
| Notification type | Safety Mfr |
| Units potentially affected | 57077 |
What is wrong
Issue:
On certain trucks, the fuel tank strap(s) may not have been secured properly. As a result, the tank could fall and fuel could leak. If this happens, the engine could stall suddenly.
Safety Risk:
A sudden loss of engine power could increase the risk of a crash. A fuel leak can create the risk of a fire. Additionally, a fuel tank that separates from the truck could create a hazard for other road users and increase the risk of a crash.
Corrective Actions:
Ford will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the fuel tank strap(s).
| 2023 FORD F-150 | |
|---|---|
| 2024 FORD F-150 | |
| 2025 FORD F-150 | |
| 2026 FORD F-150 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 55111 | 2026-09-01. Service bulletin. Some 2022-2026 F-150 Lightning vehicles may exhibit a reduced distance to empty (DTE) projection, a high voltage battery pack state of charge (SOC) that drops from 100% to less than 90% within 60 seconds of being driven, and an inability to reach a target SOC using the scheduled charging feature without any diagnostic trouble codes (DTCs) in the battery energy control module (BECM). This may be due to an issue in one or more cells within the high voltage battery pack. To correct the condition, run the "BECM Battery Health" application using the latest software version of the Ford Diagnosis and Repair System (FDRS). If any cells are identified as exceeding state of charge and/or capacity thresholds, refer to the Workshop Manual (WSM), Section 414-03A High Voltage Battery, Mounting and Cables > Diagnosis and Testing > High Voltage Battery, Mounting and Cables Electric. Perform Pinpoint Test High Voltage Battery Pack Cell Balancing Faults, Step 4 (PPT Step AO4 for 2022-2024 vehicles/PPT Step AQ4 for 2024-2026 vehicles) and proceed with Pinpoint Test directions following the results of Step 4. |
|---|---|
| SSM 55080 | 2026-08-20. Service bulletin. Some 2021-2023 Mustang Mach-E vehicles built on or before 25-Jun-2023, 2022-2025 E-Transit and 2022-2023 F-150 Lightning vehicles may experience a high voltage battery stop charging condition when using a direct current (DC) fast charger level 3 with diagnostic trouble codes (DTCs) P0EEE:27 and P2E53:27 stored in the on-board diagnostic control module A (SOBDM). This may be due to the SOBDM software. Replacement of the charge port will not resolve this concern. Inform customers that their vehicles can still be charged using a level 1 or level 2 alternating current (AC) charger. Engineering is currently working on a software solution expected in Q3 2026. Schedule an appointment with the customer when the repair becomes available. Monitor Professional Technician System (PTS) for additional information. |
| TSB 26-2360 | 2026-08-10. Service bulletin. Some of the vehicles listed in the Model Statement above may exhibit an intermittent extended crank with no relevant diagnostic trouble codes (DTCs) present. This may be due to various software parameters in the powertrain control module (PCM). |
| SSM55059 | 2026-08-03. Service bulletin. Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost engine, 2020-2026 Explorer vehicles equipped with a 3.3L hybrid engine, and 2020-2023 Lincoln Aviator vehicles equipped with a 3.0L EcoBoost hybrid engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM). The vehicle may be unable to enter electric-only drive modes as expected during normal drive cycles. This may be due to the belt integrated starter generator (BISG). For vehicles with this condition, follow the necessary Pinpoint Test in Workshop Manual (WSM), Section 303-06 for DTC P0A1E and repair the vehicle as directed. Note that previous replacement of the BISG does not negate the need for subsequent BISG replacements if directed to do so by the appropriate Pinpoint Test diagnostics. Engineering is investigating this BISG quality concern. Monitor PTS for updates regarding this investigation. |
| SSM 55032 | 2026-07-29. Service bulletin. Some 2022-2026 F-150 Lightning vehicles may exhibit a reduced distance to empty (DTE) projection, a high voltage battery pack state of charge (SOC) that drops from 100% to less than 90% within 60 seconds of being driven, and an inability to reach a target SOC using the scheduled charging feature without any diagnostic trouble codes (DTCs) in the battery energy control module (BECM). This may be due to an issue in one or more cells within the high voltage battery pack. To correct the condition, run the "BECM Battery Health" application using the latest software version of the Ford Diagnosis and Repair System (FDRS). If any cells are identified as exceeding state of charge and/or capacity thresholds, refer to the Workshop Manual (WSM), Section 414-03A High Voltage Battery, Mounting and Cables > Diagnosis and Testing > High Voltage Battery, Mounting and Cables - Electric > Pinpoint Test AP > Step AP4 and continue diagnosis. If all cells are within state of charge and capacity thresholds or DTCs are present in the BECM, refer to the WSM for normal diagnosis. For claiming, use causal part 10D672 and labor op |
| SSM 55031 | 2026-07-28. Service bulletin. Some 2021-2026 Ford/Lincoln vehicles may exhibit various symptoms including but not limited to the auto start/stop system not operating as intended with a "Check Charging System" message in the instrument panel cluster (IPC) while the charging system is operating properly with no charging related diagnostic trouble codes (DTC) stored. This may be due to someone using an aftermarket programmer to change the body control module (BCM) configuration to disable the auto start/stop system or perform other unsupported programming modifications. To correct this condition on F-150 and Bronco vehicles, download and run the Ford Diagnosis and Repair System (FDRS) application titled "BCM-Charging System Configuration Correction". Running this application will determine if the BCM configuration was modified by the customer and if so, provide the option to return the configuration back to factory settings. For other vehicle models exhibiting concerns related to unsupported aftermarket BCM programming, submit a Technical Support Request (TSR) requesting support to revert the BCM configuration |
| SSM 54874 | 2026-06-03. Service bulletin. Some 2024-2026 F-150 vehicles may exhibit an incorrect fuel gauge indication when distance to empty (DTE) is below 50 miles. Workshop Manual (WSM), Sections 413-01 > Description and Operation > Instrument Panel Cluster (IPC) - System Operation and Component Description along with 413-01 > Diagnosis and Testing > Pinpoint Test D have been updated for this concern. |
| SSM 54838 | 2026-05-26. Service bulletin. Some 2024 F-150 vehicles may exhibit a condition where the volume is limited to 14 with a "MyKey volume limited" message in the center display screen. To resolve this concern, disconnect the vehicle's 12-volt battery cables for 10 minutes and reconnect. For hybrid vehicles, disconnect the vehicle's primary 12-volt battery and the auxiliary battery located under the rear seat. Refer to Workshop Manual (WSM), Section 414-01. If a battery reset does not resolve this solution inform customers that engineering is currently working on a solution. Monitor Professional Technician System (PTS) for additional information and schedule service appointments for customers once the repair becomes available. If a customer's vehicle exhibits this concern, submit a Vehicle Concern Report. To submit a report, click on the "Submit Global Concern Report (GCR)" link at the upper right of the PTS Vehicle ID screen (vehicle identification number ÝVIN¨ required) and fill out the form. Include the article number of this message in the text of the form. Do not use the "Report A Problem" link to submit a report for this condition. |
| SSM 54803 | 2026-05-14. Service bulletin. Some 2025 Mustang Mach-E vehicles built on or before 30-Jun-2025 and 2024 F-150 Lightning vehicles may exhibit a flashing light on the air conditioning (A/C) button with a lack of heat and/or A/C with diagnostic trouble code (DTC) B1717:06 stored in the heat pump valve control module (HPVCM). This may be due to the software in the HPVCM. To correct the condition, reprogram the HPVCM using the latest software level of the Ford Diagnosis and Repair System (FDRS). If the DTC remains this may be due to the "Heat Pump Vacuum Lock Release Sequence" application performance in the Ford Diagnosis and Repair System (FDRS). The "Heat Pump Vacuum Lock Release Sequence" application has been updated in FDRS to operate properly. For claiming, use causal part 14H266 and labor operations 12651D and 12651D4. |
| 25M04 | 2026-04-07. Other. Certain 2021-2023 Model Year F-150 HEV Vehicles Replacement of Exhaust Gas Heat Exchanger Coolant Spigot, If Required Owner Letters |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.