Transport Canada recall 2016549
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2016549 |
| Manufacturer's number | S83 |
| Reported | 2016-11-07 |
| Component | Visual System |
| Notification type | Safety Mfr |
| Units potentially affected | 1057 |
What is wrong
On certain vehicles, an improper crimp of a diode in the windshield washer pump may cause the windshield wiper circuit located in the body control module (BCM) to fail. If this occurs, the windshield wipers would become inoperative, which could limit the driver’s visibility under certain conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and replace the defective windshield wiper pump.
| 2016 DODGE DART |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 68245074 | 2022-10-17. Service bulletin. Compressor, A/C lines, A/C Condenser This issue pertains to PF, UF, and KL only.~ During service of the AC lines, Compressor or Condenser, do not stow any AC lines in proximity to any heat sources, or sharp edges.~ After the vehicle is reassembled, confirm that all AC lines are in correct design position and not in contact with any heat sources, or sharp edges. |
|---|---|
| 05152029 | 2022-10-17. Service bulletin. Washer Fluid Level Sensor Prior to replacing this part due to "Low Washer Fluid" tell tale light on the dash and the washer fluid bottle is full, please perform the this inspection. Inspect the sensor for a fluid coating on the sensor pins. Orange colored rain repellant can cause this fluid build-up. Clean the pins, drain the reservoir, and fill with Mopar approved washer fluid. Check to determine if the issue has been resolved. Continue with repair if necessary. Also, please inform the customer not to use Rain-X in the system to avoid this issue. Please contact Chuck Hood at cell (248) 613-7591 if you have questions or need additional information. Thank you. |
| S1408000259RevA | 2022-09-26. Service bulletin. Radio Display Screen Goes Blank During ABS Activation, HVAC Controls And Blind Spot System Operate Intermittently, Cluster Warning Chime Goes Off |
| 3100419 | 2022-09-15. Service bulletin. Authentic Mopar® Glass Replacement This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the recommended usage of Authentic Mopar® Glass. |
| 9003109 | 2022-09-15. Service bulletin. Washer Fluid Level Sensor Prior to replacing this part due to "Low Washer Fluid" tell tale light on the dash and the washer fluid bottle is full, please perform this inspection: Check if float sensor is rotated off location from the bottle anti-rotation features that surround the SENSOR. Check to determine if the issue has been resolved. Continue with repair if necessary. Please contact Chris Koch at cell (248) 248-622-6417 if you have questions or need additional information. |
| 31-004-19 | 2019-12-16. Service bulletin. Authentic Mopar® Glass Replacement This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the recommended usage of Authentic Mopar® Glass. |
| 23-024-16 | 2018-06-11. Service bulletin. Distorted Door Run Applique At Top Of Window This bulletin involves inspecting and if necessary, replacing the left front door glass run applique and window glass. The customer may describe that the left front door glass run applique has a wrinkled appearance or that the window does not fully close due to applique seal entrapment. |
| 9003109 | 2018-06-04. Service bulletin. Washer Fluid Level Sensor Prior to replacing this part due to "Low Washer Fluid" tell tale light on the dash and the washer fluid bottle is full, please perform this inspection: Check if float sensor is rotated off location from the bottle anti-rotation features that surround the SENSOR. Check to determine if the issue has been resolved. Continue with repair if necessary. Please contact Chris Koch at cell (248) 248-622-6417 if you have questions or need additional information. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.