Transport Canada recall 2015312
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2015312 |
| Manufacturer's number | SRC R08 |
| Reported | 2015-07-15 |
| Component | Powertrain |
| Notification type | Superseded |
| Units potentially affected | 9515 |
What is wrong
On certain vehicles, the Intelligent Power Module (IPM), which is part of the hybrid system inverter assembly, could become damaged under certain driving conditions. This could cause various warning lights to illuminate in the instrument panel of the vehicle and cause a reduction or loss of motive power, increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will update motor/generator and hybrid control ECU software and affect repairs as necessary. Note: This recall is superseded by recall 2018546. Please see <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018546">recall 2018546</a> for more information.
| 2012 TOYOTA PRIUS V | |
|---|---|
| 2013 TOYOTA PRIUS V | |
| 2014 TOYOTA PRIUS V |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 23TE03 | 2023-07-31. Service bulletin. DP: The Customer Confidence Program is a component of a class action settlement that includes several elements of coverage. The Customer Confidence Program provides coverage as it applies to the Intelligent Power Module (IPM). The specific condition covered by this Customer Confidence Program 23TE03 is failure of the IPM located inside the inverter assembly of the hybrid system indicated by DTCs P0A94, P0A1A, P324E, and/or P3004. If any of these DTCs are detected, various warning lamps on the instrument panel will also illuminate and the vehicle will enter Fail Safe Mode. |
|---|---|
| T-SB-0134-16-Rev | 2019-09-03. Service bulletin. TSB: REVISION NOTICE July 01, 2019 Rev2: ? Applicability has been updated to 2019 ? 2020 model year Toyota vehicles. ? The Techstream Preparation and Process Overview sections have been updated. October 30, 2017 Rev1: ? Applicability has been updated to include 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. SUPERSESSION NOTICE The information contained in this bulletin supersedes SB No. T-SB-0012-13. Service Bulletin No. T-SB-0012-13 is obsolete and any printed versions should be discarded. Be sure to review the entire content of this bulletin before proceeding. Flash reprogramming allows the Electronic Control Unit (ECU) software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. NOTE ECU is a Toyota term used to describe integrated computerized devices responsible for managing the operation of a system or subsystem. For the purposes of this bulletin, the term ?ECU? is used as a generic label for the following SAE J1930 standard references: ? Powertrain Control Module (PCM) ? Engine Control Module (ECM) ? Transmission Control Module (TCM) ? Any other Toyota specific control unit |
| ZH1-Toyota POL17 | 2018-11-05. Service bulletin. Warranty Policy Bulletin: Toyota has received reports of customer concerns in which the vehicle may exhibit a brief intermittent shudder during torque converter flex lock up. This shudder may be observed while driving under light throttle conditions between approximately 25-50 mph. |
| T-TT-0086-11 | 2018-04-23. Service bulletin. TechTip: Condition - The vehicle may be difficult to start or have an abnormally low or rough idle after the battery has been disconnected or power to the Engine ECM has been interrupted. |
| T-SB-0196-12 | 2018-04-23. Service bulletin. The Advanced Parking Guidance System (or Park Assist) assists the driver during parking and parallel parking by displaying an image of the area behind the vehicle and controlling the steering wheel with the vehicle in reverse. Removing the short pin or disconnecting the battery interrupts power to the Steering Angle Sensor. When the short pin is reinstalled or the battery terminal is reconnected, the rear view monitor will operate, but the steering angle sensor center position must be set through system initialization before park assist will become operational. Initialize the Advanced Parking Guidance System after installing the short pin during Pre-delivery Service (PDS). |
| T-SB-0147-16 | 2018-04-02. Service bulletin. TSB: Some 2013 ? 2015 Prius PHV, Prius and 2013 ? 2016 Prius V vehicles may exhibit a vibration due to rough idle and/or tapping noise from the HV transaxle at cold start. The check engine light may also illuminate with (DTC) P0300, P0301, P0302, P0303, P0304 (Random/Multiple Cylinder Misfire Detected). The Engine Control Module/ECM (SAE Term: Powertrain Control Module/PCM) logic has been modified to reduce the possibility of this condition occurring. Follow the Repair Procedure in this bulletin to address this condition. |
| T-SB-0087-16 | 2017-08-14. Service bulletin. TSB: Some 2014 - 2016 model year Prius V vehicles may exhibit a MIL "ON" condition with Diagnostic Trouble Code (DTC) P2610 (ECM/PCM Engine Off Timer Performance) present. The Engine Control Module (ECM) logic has been modified to reduce the possibility of this condition. Follow the Repair Procedure below to address this condition. |
| T-SB-0041-15 | 2017-08-14. Service bulletin. TSB: Some 2010 - 2013 model year Prius and 2012 - 2013 model year Prius V vehicles may exhibit a MIL "ON" condition with Diagnostic Trouble Code(s) (DTCs) P0A0F (Engine Failed to Start), caused by Purge VSV/PCV line separation from the throttle body housing. One or more of the following DTCs may also set: * P3190 (Poor Engine Power) * P3191 (Engine Does NOT Start) * P0171 (System Too Lean [Bank One]) Replace the Purge VSV (Vacuum Switching Valve Assembly) and reprogram the Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) with the latest calibration to address this condition. |
| T-SB-0041-15 | 2017-08-14. Service bulletin. TSB: Some 2010 - 2013 model year Prius and 2012 - 2013 model year Prius V vehicles may exhibit a MIL "ON" condition with Diagnostic Trouble Code(s) (DTCs) P0A0F (Engine Failed to Start), caused by Purge VSV/PCV line separation from the throttle body housing. One or more of the following DTCs may also set: * P3190 (Poor Engine Power) * P3191 (Engine Does NOT Start) * P0171 (System Too Lean [Bank One]) Replace the Purge VSV (Vacuum Switching Valve Assembly) and reprogram the Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) with the latest calibration to address this condition. |
| T-SB-0006-11 Rev | 2017-08-01. Service bulletin. TSB: World Standard (WS) Automatic Transmission Fluid (ATF) was introduced to reduce maintenance costs and increase the mileage between scheduled maintenance checks. Here are some important tips when working with ATF-WS in Toyota vehicles requiring it's use. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.