Transport Canada recall 2014416
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2014416 |
| Reported | 2014-09-24 |
| Component | Powertrain |
| Notification type | Safety Mfr |
| Units potentially affected | 73 |
What is wrong
On certain hybrid vehicles, the transmission housing may have been damaged during manufacturing. This could allow a crack in the housing to form, and could eventually result in a transmission housing fracture, which would result in debris being spread onto the roadway, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the transmission assembly if cracks are found during inspection.
| 2014 INFINITI Q50 |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| ITB15027 | 2021-05-10. Service bulletin. SERVICE INFORMATION If the glove box is removed for any reason (for example, installing an accessory kick plate, replacing an in-cabin microfilter, etc.), verify the trunk release power cancel switch operates normally after installing the glove box. See this bulletin for further detail. |
|---|---|
| ITB11011A | 2021-05-10. Service bulletin. SERVICE INFORMATION For QX60 Hybrid Vehicles, go to page 4. Q50, Q70, and M35 Hybrid Vehicles The internal combustion (IC) engine in the Q50, Q70, and M35 Hybrid vehicles is started using a high voltage motor that is integrated into the transmission. The high voltage motor gets its power from the high voltage Lithium-Ion (Li-ion) battery that is mounted between the trunk room and the rear seat. The Li-ion battery cannot be recharged using an external battery charger; therefore it is very important that the battery state of charge (SOC) is properly maintained during extended storage periods. Action must to be taken in order to prevent excessive discharge of the high voltage Li-ion battery during an extended storage period. If the reserve capacity of the Li-ion battery is not sufficient, the hybrid system cannot be started. Perform the Battery Discharge Prevention During Extended Storage procedure in this bulletin once a month (every 30 days). NOTE: A discharged high voltage Li-ion battery is not a warrantable issue. See this bulletin for further detail. |
| ITB14028A | 2021-05-10. Service bulletin. SERVICE INFORMATION The information in this bulletin is provided to help ensure correct diagnosis and repair of fluid leaks. All fluid leaks, when properly diagnosed, should be repaired (whether under warranty or customer pay) to ensure proper vehicle operation. However, certain normal operating conditions can be misdiagnosed as a leak requiring repair. Unnecessary repair or replacement of parts in connection with incorrectly diagnosed "leaks" can negatively impact customer satisfaction, be time consuming and costly, and if not performed correctly can lead to future repairs. See this bulletin for further detail. |
| ITB14051A | 2021-05-10. Service bulletin. IF YOU CONFIRM All of the following: The FCW (Forward Collision Warning) malfunction is ON or reported to have been ON, and DTC C1A27 (ECD POWER SUPPLY CIRCUIT) is stored (Past or Current), and the brake fluid level is normal. NOTE: C1A27 is an ICC (Intelligent Cruise Control) DTC. ACTION Reprogram the ABS control unit (ABS) per the Service Procedure in this bulletin. - Part of the Service Procedure, step 20 on page 8, is a confirmation that reprogramming is needed to resolve the incident shown in Figure A and B on page 1. See this bulletin for further detail. |
| ITB15007 | 2021-05-10. Service bulletin. IF YOU CONFIRM A power window auto-up does not work for one or more power windows. ACTION Replace the left front (driver) door finisher with the new one listed in the Parts Information. While replacing the door finisher, also replace the main power window switch. See this bulletin for further detail. |
| ITB14055 | 2021-05-10. Service bulletin. SERVICE INFORMATION If a customer describes lack of power or poor acceleration, perform the following checks before attempting any repair: * Check for stored DTCs. * Check if the driver is resting their left foot on the brake pedal while accelerating. Advise the customer not to rest their foot on the brake while accelerating. * Use CONSULT-III plus in Engine Data Monitor to check operation of the brake lamp circuit signal. Monitor the brake switch during the incident; it should be "OFF". Please see this bulletn for further details. |
| ITB14029 | 2021-05-10. Service bulletin. IF YOU CONFIRM Using chassis ear, a rattle noise coming from the rear propeller shaft center bearing under the following conditions - Light to moderate acceleration, and between 2,000 and 2,800 rpm. ACTION Replace the rear propeller shaft with the new one (new style) listed in the Parts Information of this bulletin. See this bulletin for further detail. |
| ITB14014 | 2021-05-10. Service bulletin. SERVICE INFORMATION When diagnosing an applied vehicle for possible power steering gear (rack and pinion steering rack, or steering rack) leak issues, in some cases it may appear the steering rack is leaking when actually, it?s not. Use this service bulletin to help make a more accurate diagnosis of the steering rack. - Go to Power Steering Gear Inspection starting on page 2. See this bulletin for further detail. |
| ITB13033A | 2021-05-10. Service bulletin. SERVICE INFORMATION: At engine start up, if a low 12 volt battery condition (approximately 8 volts) occurs with an Applied Vehicle, the following conditions may happen: * The Power Steering Warning Light is, or may have been ON. * DTC codes C13EB (DAST1, DAST2) and C13E9 (DAST1) may be stored as current or past. * Power steering will go to EPS mode (reduced power assist). Additionally, * The steering wheel may be off-center when starting to drive. Please see this bulletin for futher details. |
| ITB19-040 | 2019-12-06. Service bulletin. 2014-2015 Q50; MIL ON WITH DTC P0720 AND MAY HAVE HARSH SHIFTING AND/OR LACK OF POWER SERVICE INFORMATION If DTC P0720 OUTPUT SPEED SENSOR is stored, follow the diagnostic procedure in the ESM. If the diagnosis leads to output speed sensor replacement, replace the control valve. Do NOT replace the output speed sensor. • - Refer to the ESM for control valve replacement: TRANSMISSION DRIVELINE> TRANSAXLE TRANSMISSION > 7 AT: RE7R01A > REMOVAL AND INSTALLATION > CONTROL VALVE TCM. HINT: The vehicle may also have harsh shifting and/or lack of power. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.