Transport Canada recall 2000292
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2000292 |
| Reported | 2000-12-13 |
| Component | Steering |
| Notification type | Safety Mfr |
| Units potentially affected | 832 |
What is wrong
On certain vehicles, the two pins that connect the key cylinder cap to the key cylinder were incorrectly inserted during assembly. Over time, vibration may cause the connecting pins to loosen and/or fall out. This condition could cause the cylinder cap to disengage from the key cylinder, allowing the wheel lock rod to move which could lock the steering wheel. Correction: Ignition lock assemblies will be inspected and those with loose or missing end cap connector pins will be replaced. A ring clip will be installed on all others to prevent loosening of the pins.
| 2000 INFINITI QX4 | |
|---|---|
| 2001 INFINITI QX4 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| ITB00024F | 2021-05-10. Service bulletin. SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake issues fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the vehicle, steering wheel, or brake pedal when the brakes are applied. c. Pedal Feel: The effort needed to operate the brakes is too high or too low. SERVICE PROCEDURE 1. Verify the condition by road testing the vehicle with the customer. 2. Determine the specific brake issue based on the description in the Service Information above. 3. Follow the appropriate repair procedure(s), listed on the following pages, for your specific issue. See this bulletin for further details. |
|---|---|
| ITB04038A | 2021-05-10. Service bulletin. If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear). ACTION: Use the ProCut PFM Series on-car brake lathe to perform brake rotor resurfacing and follow the tips listed in this bulletin. - The ProCut PFM Series brake lathe has been chosen as the approved tool for rotor resurfacing. - The ProCut PFM Series brake lathe can be ordered from TECH-MATE at 1-800-662-2001. - ProCut technical support or service can be obtained by calling 1-800-543-6618. NOTE: Brake rotors may need to be resurfaced during routine brake repair or for brake "judder" incidents. - Brake judder: A brake pedal pulsation and/or steering wheel shimmy when braking that occurs when there is too much thickness variation of the brake rotors (see ITB00-024). See this bulletin for further detail. |
| 03005 | 2003-04-10. Service bulletin. RUBBING/WHEEZING NOISE FROM STEERING COLUMN WHEN TURNING. *TT |
| ITB00058A | 2001-02-02. Service bulletin. SOME VEHICLES MAY EXHIBIT POWER STEERING FLUID LEAK NEAR THE PUMP HOSE FITTING. *TT |
| ITB00058 | 2000-12-15. Service bulletin. SERVICE INFORMATION REGARDING POWER STEERING FLUID LEAK NEAR THE PUMP HOSE FITTING. *TT |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.