NHTSA recall 22V013000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 22V013000 |
| Manufacturer's number | 22S01 |
| Manufacturer | Ford Motor Company |
| Reported | 2022-01-14 |
| Owners notified | 2022-01-28 |
| Component | FUEL SYSTEM, DIESEL |
| Units potentially affected | 19697 |
| Part numbers | LC34-9150-AA |
| Report | Annual report 2, for 2025 quarter 1 to 2025 quarter 4 |
|---|---|
| Filed with NHTSA | 2026-01-20 |
| Vehicles in the campaign | 19697 |
| Reported remedied | 17043 (86%) |
| Reported unreachable | 93 |
| Reported removed | 5 |
These are the manufacturer's totals for the whole campaign at the end of 2025 quarter 4, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.
What is wrong
Ford Motor Company (Ford) is recalling certain 2021 Super Duty F-250, F-350, F-450, F-550, F-600, and Medium Duty F-650 and F-750 vehicles equipped with 6.7L diesel engines. A small void may be present in the top-center of the vehicle's underhood secondary fuel filter cap, which may progress to a pinhole over time, allowing fuel to leak from the top of the secondary fuel filter.
What can happen
A fuel leak in the presence of an ignition source can increase the risk of a fire or injury.
The remedy
Dealers will replace the primary and secondary fuel filters, free of charge. Owner notification letters were mailed January 28, 2022. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 22S01.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.
| 2021 FORD F-250 SD | Listed as a series or trim of this model. |
|---|---|
| 2021 FORD F-350 SD | Listed as a series or trim of this model. |
| 2021 FORD F-450 SD | Listed as a series or trim of this model. |
| 2021 FORD F-550 SD | Listed as a series or trim of this model. |
| 2021 FORD F-600 SD | Listed as a series or trim of this model. |
| 2021 FORD F-650 | |
| 2021 FORD F-750 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 54215 | 2025-09-18. Service bulletin. Some 2019-2026 F-Super Duty vehicles equipped with a 6.7L engine may require various repairs and/or maintenance to the fuel system where quick release couplings are utilized, such as the secondary fuel filter. The Workshop Manual (WSM), Section 310-00 > General Procedures > Quick Release Coupling has been updated to include videos and instructions of proper disconnect/connect steps involving the Type 27 quick release couplings. |
|---|---|
| SSM 52765 | 2024-08-06. Service bulletin. Some 2020-2022 F-Super Duty pickup vehicles equipped with a 6.7L engine, 175 inch wheelbase, and built on or before 23-Sep-2021 may exhibit a thump/whine/knock noise from the midship fuel tank at idle or during key on, engine off (KOEO) after performing TSB 21-2057. The noise may be more pronounced at fuel levels at or below 1/4 tank. This may be due to the fuel pump |
| SSM 50977 | 2022-08-02. Service bulletin. Some 2021-2022 F-Super Duty and 2021-2023 E-Series vehicles equipped with a 6.2L or 7.3L gasoline engine may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P0457 stored in the powertrain control module (PCM). This may be due to a loose fuel filler cap. The fuel filler cap design has changed, requiring multiple turns to seal properly. Advise the customer to turn the fuel filler cap clockwise until there is at least one audible click to seal properly. For further diagnostics, refer to Workshop Manual (WSM), Section 303-13 - pinpoint test HX. |
| SSM 50619 | 2022-03-22. Service bulletin. Some 2020-2022 F-Super Duty pickup vehicles equipped with a 6.7L engine and built on or before 23-Sep-2021 may exhibit a thump/whine/knock noise from the fuel tank at idle or during key on, engine off (KOEO) after performing TSB 21-2057. The noise may be more pronounced at fuel levels at or below 1/4 tank. This may be due to the fuel pump. To correct the condition, replace the fuel pump and sender assembly with service part HC3Z-9H307-AR for vehicles with 160/164 inch wheelbase and a midship fuel tank, HC3Z-9H307-AQ for vehicles with 142/148 inch wheelbase and a midship fuel tank, and HC3Z-9H307-AS for vehicles with an aft of axle fuel tank. For claiming, use causal part 9H307 and applicable labor operations in Section 08 of the Service Labor Time Standards (SLTS) Manual. |
| SSM 50448 | 2022-02-04. Service bulletin. Some 2017-2022 F-Super-Duty vehicles equipped with a 6.7L diesel engine may exhibit a hard start, lack of power and/or runs rough concern with an illuminated malfunction indicator light (MIL) and diagnostic trouble codes (DTCs) P0087 and/or P008A. This may be due to low fuel level or fuel gelling in cold ambient temperatures. If no root cause is determined after normal Powertrain Control/Emissions Diagnosis (PC/ED) pinpoint test MA, recommend that the customer use a different brand of fuel and use Motorcraft® PM-23-A Diesel Fuel Anti-Gel and Performance Improver. Inform the customer that bio-diesel blended fuels have a higher occurrence of fuel gelling. Fuel gelling and or low fuel conditions causing a P0087 and/or P008A is not covered under warranty. |
| SSM 50380 | 2022-02-04. Service bulletin. Some 2020-2022 F-Super Duty pickup vehicles equipped with a 6.7L engine, 175 inch wheelbase, and built on or before 23-Sep-2021 may exhibit a thump/whine/knock noise from the midship fuel tank at idle or during key on, engine off (KOEO) after performing TSB 21-2057. The noise may be more pronounced at fuel levels at or below 1/4 tank. This may be due to the fuel pump. To correct the condition, replace the fuel pump and sender assembly with service part HC3Z-9H307-AP. For claiming, use causal part 9H307 and applicable labor operations in Section 08 of the Service Labor Time Standards (SLTS) Manual. |
| TSB 21-2309 | 2021-09-30. Service bulletin. Some 2020-2021 F-Super Duty vehicles equipped with a 6.7L engine may exhibit an illuminated malfunction indicator lamp (MIL) with various fuel system related diagnostic trouble codes (DTC) stored in the powertrain control module (PCM). While performing pinpoint test (PPT) M in the Powertrain Control/Emissions Diagnosis (PC/ED) Manual, the fuel pressure control valve (F_PCV) and/or fuel volume control valve (F_VCV) parameter identifications (PIDs) may not have an option to manually command them with the Ford Diagnosis and Repair System (FDRS) scan tool. This may be due to the PCM software. To correct the condition, follow the Service Procedure to reprogram the PCM. |
| SSM 49785 | 2021-06-01. Service bulletin. Some 2021 F-Super Duty and 2021-2022 E-Series vehicles equipped with a 6.2L or 7.3L gasoline engine may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P0457 stored in the powertrain control module (PCM). This may be due to a loose fuel filler cap. The fuel filler cap design has changed, requiring multiple turns to seal properly. Advise the customer to turn the fuel filler cap clockwise until there is at least one audible click to seal properly. For further diagnostics, refer to the Powertrain Control/Emissions Diagnosis (PC/ED) manual, pinpoint test HX. |
| SSM 49778 | 2021-06-01. Service bulletin. Some 2021 F-Super Duty/F-650/F-750 and 2021-2022 E-Series vehicles equipped with a 6.2L or 7.3L gasoline engine may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P0457 stored in the powertrain control module (PCM). This may be due to a loose fuel filler cap. The fuel filler cap design changed for 2021 to require three full turns to properly tighten. Advise the customer of the design change. For further diagnostics, refer to the Powertrain Control/Emissions Diagnosis (PC/ED) manual, pinpoint test HX. |
| TSB 21-2058 | 2021-04-03. Service bulletin. Some 2020-2021 F-Super Duty vehicles equipped with a 6.7L engine built on or before 10-Feb-2021 may exhibit an illuminated malfunction indicator lamp (MIL) with various fuel system related diagnostic trouble codes (DTCs) stored in the powertrain control module (PCM). While performing pinpoint test (PPT) M in the Powertrain Control/Emissions Diagnosis (PC/ED) Manual, the fuel pressure control valve (F_PCV) and/or fuel volume control valve (F_VCV) parameter identifications (PIDs) may not have an option to manually command them with the scan tool. This may be due to the PCM software. To correct the condition, follow the Service Procedure to reprogram the PCM. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.