NHTSA recall 12V431000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 12V431000 |
| Manufacturer's number | 12S39 |
| Manufacturer | FORD MOTOR COMPANY |
| Reported | 2012-09-04 |
| Owners notified | 2012-09-11 |
| Component | ENGINE AND ENGINE COOLING |
| Units potentially affected | 6146 |
What is wrong
Ford is recalling certain model year 2013 Escape vehicles manufactured from October 5, 2011, through August 31, 2012, equipped with 1.6L engines. The cylinder head cup plug (freeze plug) may become dislodged resulting in significant loss of engine coolant.
What can happen
As leaking engine coolant evaporates on the hot engine, the glycol may ignite causing an engine compartment fire.
The remedy
Ford will notify owners, and dealers will seal the existing plug and add a secondary plug cover, free of charge. The safety recall began on September 11, 2012. Owners may contact Ford at 1-866-436-7332.
Notes
Ford's recall campaign number is 12S39.Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
| 2013 FORD ESCAPE | Built 2011-10-05 to 2012-08-31. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| TSB160075 | 2021-12-20. Service bulletin. Hard start/no start/loss of engine RPM after refueling - built on or before 11/09/2013 |
|---|---|
| TSB160052 | 2021-12-20. Service bulletin. 106L GTDI - service fengine soon light - DTC P26B7 - Built on or before 02/13/2013 |
| TSB160045 | 2021-12-20. Service bulletin. 2.0L Ecoboost - Fuel odor |
| TSB160001 | 2021-12-20. Service bulletin. 49 CFR Part 579.5 Monthly Communications - March 2016 Air bag warning light illuminated with diagnostic trouble code (DTC) B141B and/or B141C |
| LTR3756 | 2021-12-20. Service bulletin. 49 CFR Part 579.5 Monthly Communications - January 2016 |
| SSM 49210 | 2020-10-06. Service bulletin. Some 2009-2020 Ford and Lincoln vehicles equipped with turbochargers may exhibit an oil leak from the turbocharger oil supply or return tubes, O-rings or 6.7L pedestal gasket. Although oil may collect on the turbocharger, it is very rare for a turbocharger to leak oil. To isolate the source of the leak, refer to Workshop Manual (WSM), Section 303-00 General Information > Diagnosis and Testing > Engine > Engine Oil Leaks - Fluorescent Oil Additive Method procedure. When an oil leak is present at a turbocharger oil supply or drain tube, remove the affected oil tube and inspect for damage, and replace the O-ring seals, pedestal gasket or oil tube as required. Refer to WSM, Section 303-04. For claiming, use the affected oil tube or pedestal gasket as the causal part and applicable labor operations in Sections 6 and 9 of the Service Labor Time Standards (SLTS) Manual. |
| TSB 19-2287 | 2019-10-04. Service bulletin. Some 2013-2016 Escape vehicles equipped with a 1.6L EcoBoost engine may exhibit a lack of cooling caused by the A/C inlet line breaking at the compressor. This may be due to the oil cooler coolant lines exerting excess pressure on the A/C inlet line. When replacing the A/C inlet line, a support clip for the oil cooler coolant line should be installed to prevent contacting the A/C inlet line. To correct the condition, follow the Service Procedure steps to replace the A/C inlet line and adjust the gap between the A/C inlet line and the CAC hose. |
| SSM 47948 | 2019-05-07. Service bulletin. SSM 47948 - 2010-2019 Various Vehicles - Turbocharged Engines - Oil Supply Filter Replacement When Replacing The Turbocharger Or The Turbocharger Oil Supply Tube For 2010-2019 vehicles equipped with turbocharged engines, when diagnosing and/or replacing turbo related concerns, all steps within the Workshop Manual (WSM) procedure must be followed including replacement of all mandatory discarded parts. When specified in the WSM, the turbocharger oil supply filter must be replaced whenever the turbocharger or the turbocharger oil supply tube are replaced. Turbocharger bearing failure may occur if oil starvation occurs due to a restricted filter. |
| SSM 47662 | 2019-01-07. Service bulletin. For 2010-2019 vehicles equipped with turbocharged engines, when diagnosing and/or replacing turbo related concerns, all steps within the Workshop Manual (WSM) procedure must be followed including replacement of all mandatory discarded parts. For all turbocharged engine applications, the turbocharger oil supply filter (6C683 gas engine/6L625 connector style or 6A968 diesel engine) must be replaced whenever the turbocharger or the turbocharger oil supply tube are replaced. Turbocharger bearing failure may occur if oil starvation occurs due to a restricted filter. |
| TSB 18-2255 | 2018-09-24. Service bulletin. Some 2013-2018 Escape vehicles equipped with 1.5L/1.6L/2.0L EcoBoost, 2013-2018 Fusion vehicles equipped with 2.0L/2.7L EcoBoost, 2013-2018 MKZ vehicles equipped with 2.0L EcoBoost, 2017-18 MKZ vehicles equipped with 3.0L EcoBoost, 2015-2018 MKC vehicles equipped with 2.0L/2.3L EcoBoost, 2015-2018 Edge vehicles equipped with 2.0L/2.7L EcoBoost, 2016-2018 MKX vehicles equipped with 2.0L and 2.7L EcoBoost, 2016-2018 Explorer vehicles equipped with 2.3L EcoBoost, 2017-2018 Continental vehicles equipped with 2.7L/3.0L EcoBoost and 2016-2018 Focus RS equipped with 2.3L EcoBoost may exhibit a dark black fluid leak from the right side transfer case intermediate shaft seal. Follow the Service Procedure to correct the condition. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.