Recalls that may apply to the 1993 WHITEGMC WHR
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Steering are shown.
| 95V038000 | 1995-02-28. STEERING:LINKAGES. THE WRONG BALL SOCKET ASSEMBLY WAS USED TO ATTACH THE STEERING ARMS TO BOTH THE STEERING DRAG LINK AND THE STEERING RAM ASSIST CYLINDER, RESULTING IN A BINDING CONDITION. Built 1993-10-01 to 1995-01-01. |
|---|
| 1995089 | 1995-05-31. Steering. THE WRONG BALL SOCKET ASSEMBLY WAS USED TO ATTACH THE STEERING ARMS TO THE STEERING DRAG LINK AND THE STEERING RAM ASSIST CYLINDER. THE ASSEMBLY MAY BIND UNDER EXTREME STEER ARTICULATION. THIS CONDITION COULD OVER TIME, WITHOUT WARNING, FATIGUE FAIL THE BALL SOCKET CAUSING POSSIBLE LOSS OF STEERING CONTROL AND AN ACCIDENT. CORRECTION: DEALERS WILL INSPECT AND WHERE REQUIRED, REPLACE THE FACTORY INSTALLED BALL SOCKET ASSEMBLY(S). |
|---|---|
| 1994050 | 1994-03-14. Steering. NOTE: VEHICLES EQUIPPED WITH DOUGLAS AUTOTECH TILT STEERING COLUMN. THE UPPER STEERING SHAFT RETAINING BALL MAY HAVE BEEN OMITTED FROM THE STEERING COLUMN DURING ASSEMBLY. THIS COULD ALLOW THE UPPER SHAFT TO TELESCOPE OUT TOO FAR AND DISENGAGE FROM THE STEERING COLUMN WHEN THE STEERING WHEEL IS DRAWN TO ITS MAXIMUM EXTENDED POSITION. CORRECTION: VEHICLES WILL BE INSPECTED AND STEERING COLUMNS WITH NO UPPER SHAFT RETAINING BALL WILL BE REPLACED. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.