Service bulletins for the 2012 Volkswagen Tiguan
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1003 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Engine are shown. Show all
| TT191302 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING. Inspect the water pump for signs of contact with engine oil. Engine oil may cause the water pump gasket to swell, which may lead to a coolant leak. If water pump replacement is necessary, ensure that any engine oil is thoroughly cleaned off, prior to water pump installation. Please note that when replacing the water pump or opening the cooling system, there is a special bleed procedure that has to be performed. Vacuum bleed the cooling system for 10 minutes. Start the engine and let idle until the thermostat opens and the cooling fan runs, before driving vehicle or raising engine RPM. |
|---|---|
| TT191301 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING. After a cold start, the engine coolant temperature gauge will slowly rise to approximately 190° F. When the F265 mapped thermostat opens, the gauge may drop by approximately 60° F before again rising to 190° F. No repairs should be attempted for this normal concern. F265 is pictured below. |
| TT171202 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING. An oil leak from around the oil drain plug noted after oil change, and/or drain plug replacement, may be caused by installation of incorrect drain plug. Correct part number drain plug is based on the oil pan design as shown below. Original drain plug is 18mm hex for both style oil pans. |
| TT131301a | 2023-07-10. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. When servicing the timing chain sprocket or removing the vibration damper, be aware that one bolt holds both the vibration damper (harmonic balancer) and the crankshaft timing chain sprocket to the crankshaft. Once the damper is removed, the crankshaft should not be rotated unless special tool spacer T10368 has been installed. The crankshaft timing chain sprocket and spur gear drive on the crankshaft have a coupling that must be seated correctly during assembly. Failure to install special tool spacer T10368 before rotating engine will cause the engine to skip time and bend valves. |
| TT131301 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN. CBFA 2.0T TSI Engine |
| TT011401a | 2023-07-10. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. Install a vacuum gauge on the dipstick tube and check crankcase vacuum at idle. Compare to a known good vehicle. If the vacuum reading is lower than the comparison vehicle, visually inspect for oil leaks between the engine and the transmission. Smoke test the crankcase by connecting the EVAP smoke machine to the dipstick tube and inspect for leaks at the rear main seal (this will limit pressure to 2 PSI). DO NOT apply shop air to the dipstick tube or the crankcase. If a rear main seal leak is identified, replace the seal. Once replaced, recheck crankcase vacuum at idle. If low, check for additional oil leaks and verify crankcase breather operation (repairing as necessary). Erase the faults and road test 10 miles to recheck operation. |
| TT011401 | 2023-07-10. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. Install a vacuum gauge on the dipstick tube and check crankcase vacuum at idle. Compare to a known good vehicle. If the vacuum reading is lower than the comparison vehicle, visually inspect for oil leaks between the engine and the transmission. Smoke test the crankcase by connecting the EVAP smoke machine to the dipstick tube and inspect for leaks at the rear main seal (this will limit pressure to 2 PSI). DO NOT apply shop air to the dipstick tube or the crankcase. If a rear main seal leak is identified, replace the seal. |
| V171901201285563 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Volkswagen Engine Oil Standards, updated to include model year 2024. |
| V171806201781318 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Engine Oil Consumption Measurement Instruction and Work sheet. |
| V011615201481517 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE; ENGINE AND ENGINE COOLING. Gasoline quality information in regards to gasoline engine performance. |
| V0116132033805_8 | 2023-07-10. Service bulletin. ENGINE AND ENGINE COOLING. Diagnostic Aid for engine misfire. |
| TT241303 | 2023-07-05. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM). When diagnosing a vehicle concern, and fault P130A ?Hide Cylinder? is found in the Engine Control Module (ECM), be aware that Engine Control Module (ECM) fault P130A ?Hide Cylinder? indicates a cylinder shut down and does not require diagnosis. |
| TT2407103 | 2023-07-05. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM). When diagnosing fault code P2279-Leaking Air in Intake System, be sure to check the cam timing first. |
| TT211001 | 2023-07-05. Service bulletin. ENGINE. When diagnosis on the above engine leads to the testing of the N75, please refer to the picture below. The diagram shows which vacuum ports on the N75 valve should hold vacuum and which ones should not. |
| TB401405 | 2023-06-26. Service bulletin. ENGINE AND ENGINE COOLING. When accelerating after a change of direction (forward or reverse) a one-time clicking or popping noise occurs in the front left or front right of the vehicle. |
| V171901201285562 | 2023-06-06. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. Volkswagen Engine oil quality standards, update to attachments. |
| V191701202254810 | 2023-06-06. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM. Introduce new engine coolant compatible with all models and all model years. |
| TB191601 | 2023-05-22. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. Electric coolant fans continue to run after ignition is switched off. |
| TB011602 | 2023-05-22. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE. Gasoline quality. |
| V171901201285560 | 2023-05-05. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. Engine oil quality standards, update to attachments. |
| V171901201285559 | 2023-04-06. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. Volkswagen Engine Oil Quality Standards |
| V171901201285558 | 2023-03-06. Service bulletin. ENGINE AND ENGINE COOLING. Engine Oil Quality Standards updated to include the latest Engine Oil attachments (excludes Routan & ID.4). |
| V171901201285557 | 2023-02-07. Service bulletin. ENGINE AND ENGINE COOLING. Engine Oil Quality Standards updated to include the latest Engine Oil attachments (excludes Routan & ID.4). |
| V171901201285556 | 2023-01-06. Service bulletin. ENGINE AND ENGINE COOLING. Engine Oil Quality Standards updated to include the latest Engine Oil attachments (excludes Routan & ID.4). |
| V171901201285555 | 2022-12-06. Service bulletin. ENGINE AND ENGINE COOLING. Engine Oil Quality Standards updated to include the latest Engine Oil attachments (excludes Routan & ID.4). |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.