WenmarOpen by Wenmar Pro

Service bulletins for the 2007 Toyota Tundra

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

281 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
T-SB-0187-122018-04-23. Service bulletin. STRUCTURE:BODY. Toyota vehicles are equipped with either conventional or run-flat tires. Sometimes punctures may occur as a result of contact with road debris or other hazards. If a puncture occurs, it may be possible to repair the tire and return it to service. With a conventional tire it is not possible to drive for an extended amount of time with the tire at low pressures as damage to the tire may occur. With run-flat tires, due to reinforced sidewalls, it is possible to drive for up to 100 miles (160 km) at speeds less than 55 mph (90 km/h) with little or no damage to the tire.
T-SB-0151-10 Rev2018-04-23. Service bulletin. POWER TRAIN. Some 2007 ? 2010 model year Tundra vehicles may exhibit a howling or growling noise from the rear of the vehicle that increases with vehicle speed. Changes have been made to the rear axle bearing to address this condition. Follow the procedure in the bulletin to address customer concerns.
T-TT-0213-132018-04-23. Service bulletin. AIR BAGS. Toyota vehicles are equipped with SRS, including various airbags and in some models, seat belt pre-tensioners, to help reduce the risk of injury in a collision. If a customer expresses any concerns that the SRS airbags or pretensioner devices did not perform as expected, please follow the steps in the recommendations section below.
T-SB-0064-10 Rev2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This bulletin is now obsolete. Please see T-SB-0012-13.
T-SB-0013-132018-04-23. Service bulletin. PARKING BRAKE. Some 2007 ? 2012 model year Tundra vehicles may exhibit a rubbing or grinding noise from the rear when making left or right turns. New parking brake plate sub-assemblies have been developed to address this condition.
T-SB-0012-132018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the TIS and the CUW.
T-SB-0064-10 Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information.
SST Requirements2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SSTs are key elements to provide your customers with swift and accurate repairs resulting in superior customer satisfaction.
T-TT-0226-132018-04-23. Service bulletin. ELECTRICAL SYSTEM. The customer is having difficulty changing the multi-display screen from Day Mode. If the multi-display screen is set to Day Mode when the headlights are on, the setting we be memorized when the engine is turned off.
T-SB-0391-08 Rev2018-04-23. Service bulletin. POWER TRAIN. This bulletin contains general vehicle pulling diagnosis and repair procedures along with specific information to help correct pulling complaints.
LSC BST Phase 32018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. It has been brought to our attention that claim processing for LSC BST Phase 3 (2003-2009 4Runner and 2007-2010 Tundra vehicles) we be delayed until Monday April 7, 2014.
LSC BST Phase 1.2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. On July 24, 2013, the settlement of claims for Economic Loss arising from allegations of unintended acceleration was approved. As part of the settlement Toyota will be launching the third phase of a Limited Service Campaign to install Smart Stop technology on March 31, 2014., for the following models:
LSC BST Phase 32018-04-23. Service bulletin. POWER TRAIN. As part of the settlement described above, Toyota will install Smart Stop Technology on the above listed model and model year vehicles. This feature will cut engine power in case of simultaneous application of both the accelerator and brake pedal at certain speeds and in certain driving conditions.
LSC BST Phase 32018-04-23. Service bulletin. SERVICE BRAKES, HYDRAULIC. It has been brought to our attention that claim processing for LSC BST Phase 3 (2003-2009 4Runner and 2007-2010 Tundra vehicles) we be delayed until Monday April 7, 2014.
LSC BST Phase 1.2018-04-23. Service bulletin. VEHICLE SPEED CONTROL; VEHICLE SPEED CONTROL:ACCELERATOR PEDAL. On July 24, 2013, the settlement of claims for Economic Loss arising from allegations of unintended acceleration was approved. As part of the settlement Toyota will be launching the third phase of a Limited Service Campaign to install Smart Stop technology on March 31, 2014., for the following models:
LSC BST Phase 32018-04-23. Service bulletin. VEHICLE SPEED CONTROL; VEHICLE SPEED CONTROL:ACCELERATOR PEDAL; SERVICE BRAKES, HYDRAULIC. As part of the settlement described above, Toyota will install Smart Stop Technology on the above listed model and model year vehicles. This feature will cut engine power in case of simultaneous application of both the accelerator and brake pedal at certain speeds and in certain driving conditions.
T-SB-0229-12_Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM. TSB: REVISION NOTICE November 22, 2017 Rev1: ? Applicability has been updated to include 2014 ? 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. In the event that a Toyota vehicle becomes submerged in water, many components may be physically damaged. Electrical and electronic components, including wiring harnesses, are particularly susceptible to corrosion and subsequent malfunction. Although any flooding can be damaging, salt water flooding elevates the potential for abnormal conditions and may increase risks due to its highly corrosive and conductive nature. Salt residue also continues to corrode and remain conductive even after a vehicle dries. This bulletin is intended to assist with safe handling and inspection of flood damaged vehicles and to provide basic guidance on likely needed repairs.
T-SB-0144-08_Obs2018-04-23. Service bulletin. EQUIPMENT. TSB: OBSOLETE NOTICE November 21, 2017: This bulletin is now obsolete. Please see T-SB-0304-17.
ZH7_Toyota POL172018-04-23. Service bulletin. STRUCTURE. Warranty Policy Bulletin: Toyota has received reports of customer concerns in which the vehicles operated in specific cold climate areas (Cold Climate States) with high road salt usage may exhibit more-than-normal corrosion with the vehicle?s frame. On May 21, 2017, a settlement of claims in a class action lawsuit involving 2007 ? 2008 Toyota Tundra vehicles regarding frame corrosion was approved. This class action settlement includes inspection of the customer?s frame, and if the frames meet or exceed the Rust Perforation Standard based on the Court-ordered inspection criteria, the frame will be replaced at no cost to the customer. Toyota is currently preparing parts for frame replacement. This settlement will also include CRC (Corrosion Resistant Compound) application. Toyota is currently preparing parts for CRC application process. Once available, CRC application will be covered under a separate Limited Service Campaign (LSC), and will only be available for vehicles registered in the Cold Climate States1 that pass frame inspection criteria, and did not: ? Previously have the frame replaced and/or: ? Previously had the frame sprayed with CRC under any previous campaign
ZH7_Dealer Packe2018-04-23. Service bulletin. STRUCTURE. Dealer Letter: March 2, 2018. Rental sublet period added for use during repair. ? Primary Coverage expiration date changed. ? Ancillary parts coverage section added. Warranty Enhancement Program ZH7 Certain 2007 ? 2008 Model Year Tundra Extension of Warranty Coverage for Frame Corrosion. In our continuing efforts to ensure the best in customer satisfaction, Toyota is announcing a Warranty Enhancement Program to extend the warranty coverage for Frame Corrosion on certain 2007 ? 2008 model year Tundra vehicles. On May 21, 2017, a settlement of claims in a class action lawsuit involving 2007 ? 2008 Toyota Tundra vehicles regarding frame corrosion was approved. This finally approved class action settlement includes inspection of the customer?s frame, and if the frames meet or exceed the Rust Perforation Standard based on the Court-ordered inspection criteria, the frame will be replaced at no cost to the customer. Toyota is currently preparing parts for frame replacement. This settlement will also include CRC (Corrosion Resistant Compound) application. Toyota is currently preparing parts for CRC application process. Once available, CRC application will be covered under a separate Limited Service Campaign (LSC), and will only be available for vehicles registered in the Cold Climate States1 that pass frame inspection criteria.
T-SB-0012-13 Rev2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: OBSOLETE NOTICE: September 14, 2016: This bulletin is now obsolete. Please see T-SB-0134-16.
T-SB-0142-13 Rev2018-04-02. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. TSB: REVISION NOTICE November 10, 2016 Rev2: ? Applicability has been updated to include 2016 ? 2017 model year Toyota vehicles. ? Parts Information section has been updated. Some 2004 ? 2017 model year Toyota vehicles may exhibit odors naturally occurring from the HVAC system and/or related environmental factors. Although there is no way to eliminate these odors, follow the General Procedure in this bulletin to minimize the odors experienced.
T-SB-0161-162018-04-02. Service bulletin. STRUCTURE:BODY:DOOR. TSB: Some 2008 ? 2016 Sequoia and 2007 ? 2017 model year Tundra vehicles may exhibit a loud popping noise when operating the front doors. Noise is due to a fracture/crack in the plastic over mold of the door check arm by the pivot area. Follow the Repair Procedure in this bulletin to address this condition. NOTE If the vehicle is being repaired due to damage resulting from an accident, this Service Bulletin and part numbers listed do NOT apply. Follow normal parts order and Repair Procedures.
T-TT-0010-10 Rev2018-04-02. Service bulletin. BACK OVER PREVENTION; ENGINE. Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor Circuit) and/or P0340 (Camshaft Position Sensor Circuit) due to inconsistent rotational speed of the engine's crankshaft.
T-SB-0012-13 Rev2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.