Recalls that may apply to the 2011 Toyota Sienna
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about STRUCTURE are shown.
| 16V858000 | 2016-11-29. STRUCTURE:BODY:DOOR. Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2011-2016 Toyota Sienna minivans manufactured January 4, 2010, to August 12, 2016. If the power sliding door is unable to be opened when commanded, such as if the door is frozen shut, the door may subsequently open unexpectedly, possibly while the vehicle is moving. Built 2010-01-04 to 2016-08-12. |
|---|---|
| 11V566000 | 2011-11-22. STRUCTURE:BODY:ROOF AND PILLARS. SOUTHEAST TOYOTA IS RECALLING CERTAIN MODEL YEAR 2010-2011 COROLLA VEHICLES EQUIPPED WITH A NON-TOYOTA, BLUE TOOTH HANDS FREE DEVICE OR NAVIGATION UNIT AND CERTAIN MODEL YEAR 2011 TOYOTA SIENNA VEHICLES EQUIPPED WITH A NON-TOYOTA, OVERHEAD ENTERTAINMENT SYSTEM AND/OR BLUETOOTH HANDS FREE DEVICE. THERE IS A POSSIBILITY THAT THE FRONT A-PILLAR TRIM PANEL RETENTION CLIP MAY HAVE BEEN DAMAGED DURING THE INSTALLATION OF THE AFTERMARKET ACCESSORY. |
| 2016586 | 2016-11-22. Structure. On certain vehicles equipped with power sliding doors, under certain conditions which impede the opening of the door (such as if the door becomes frozen with ice), the sliding door motor could stall when the door is operated. If the motor stalls, high current in the door motor circuit could be generated, operating the circuit protection for the door motor. If this occurs with the sliding door latch mechanism in an unlatched position, the door could open while driving, increasing the risk of injury to a vehicle occupant. Correction: Dealers will replace the existing junction block and the rear sliding door wire harnesses with newly designed ones. The dealer will also install two sub wire harnesses to connect the junction block to the two rear door wire harnesses. |
|---|---|
| 2014188 | 2014-05-22. Structure. On certain vehicles operated where road salts are frequently used, corrosion of the spare tire carrier assembly cable may cause the separation of the spare tire stowed under the vehicle. The spare tire falling on the road surface creates a safety hazard that may result in a crash causing injury and/or property damage. Correction: As an interim measure, dealers will remove the spare tire and store it in the cargo area of the vehicle. Dealers will replace the spare tire carrier assembly when parts become available. Note: This recall supersedes recall 2010-123. Vehicles that were inspected and/or repaired under the previous recall may still be at risk of spare tire separation and will require re-inspection and/or repair. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.