Recalls that may apply to the 2011 Toyota Sienna
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 2010439 | 2010-12-13. Brakes. On certain vehicles, the brake stop lamp switch is mounted on a bracket welded on the service brake pedal support assembly. This bracket is relatively close to the parking brake pedal when the parking brake pedal is fully applied. Due to its proximity to the parking brake pedal, in some instances, the stop lamp switch bracket could be damaged by the operator's foot. Depending on the amount of bracket deformation, this could result in the brake stop lamps remaining "ON". If the deformation is significant, the service brakes could become partially engaged, resulting in brake drag with associated brake noise, vibration and/or illumination of the brake warning light. Should the vehicle continue to be operated in this condition, brake drag could cause excessive heat, which may result in reduced braking performance. This could increase stopping distances, possibly resulting in a crash causing property damage and/or personal injury. Correction: Dealers will replace the service brake pedal support assembly. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.