Service bulletins for the 2011 Toyota Sienna
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
372 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Body and frame are shown. Show all
| T-SB-0044-16 | 2018-07-02. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
|---|---|
| T-SB-0044-16 | 2018-06-11. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-TT-0356-15 | 2018-04-23. Service bulletin. STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. TT: Sliding Door will not latch manually in the closed position due to either the front and or/rear lock malfunctioning. Please see link references of video for example condition. |
| T-SB-0187-12 | 2018-04-23. Service bulletin. STRUCTURE:BODY. Toyota vehicles are equipped with either conventional or run-flat tires. Sometimes punctures may occur as a result of contact with road debris or other hazards. If a puncture occurs, it may be possible to repair the tire and return it to service. With a conventional tire it is not possible to drive for an extended amount of time with the tire at low pressures as damage to the tire may occur. With run-flat tires, due to reinforced sidewalls, it is possible to drive for up to 100 miles (160 km) at speeds less than 55 mph (90 km/h) with little or no damage to the tire. |
| T-SB-0251-12 | 2018-04-23. Service bulletin. STRUCTURE. Some 2011 model year Sienna vehicles may exhibit a condition where a leak is noticed at the rear corner drains of the rear sliding roof assembly. This may be due to an insufficient amount of butyl sealer in the drain end caps. A new rear sliding roof housing sub-assembly has been developed to address this condition |
| T-SB-0170-13_Rev | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR. TSB: REVISION NOTICE September 29, 2017 Rev1: ? The Introduction, Required Tools & Equipment, Parts Information, and Repair Procedure sections have been updated. Some 2011 model year Sienna vehicles may exhibit a condition in which the power sliding door(s), power hatch, or power moonroof are inoperative from the overhead console switch or require excessive pressure on the overhead console switch to operate. Follow the Repair Procedure in this bulletin to address this condition. |
| ZH5_Toyota POL17 | 2018-04-02. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH; STRUCTURE:BODY:DOOR. Warranty Policy Bulletin: Toyota has received a number of reports regarding the power sliding door rear lock assemblies on certain 2011 ? 2015 model year Sienna vehicles. In these reports, corrosion on the position sensor of the left and/or right power sliding door rear lock assembly caused that door to exhibit one or more of the abnormal operations described below: ? During power mode closing operation, as the power sliding door reaches the nearly closed position, the door reverses and moves toward the open positon. ? During power mode closing operation, the power sliding door cannot completely close and latch. ? The power mode closing operation of the power sliding door is inoperative. |
| ZH5_Dealer Lette | 2018-04-02. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH; STRUCTURE:BODY:DOOR. Dealer Letter: Toyota has received a number of reports regarding the power sliding door rear lock assemblies on certain 2011 ? 2015 model year Sienna vehicles. In these reports, corrosion on the position sensor of the left and/or right power sliding door rear lock assembly caused that door to exhibit one or more of the abnormal operations described below: ? During power mode closing operation, as the power sliding door reaches the nearly closed position, the door reverses and moves toward the open positon. ? During power mode closing operation, the power sliding door cannot completely close and latch. ? The power mode closing operation of the power sliding door is inoperative. |
| ZH5_Dealer Email | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. Dealer Email: Toyota has received a number of reports regarding the power sliding door rear lock assemblies on certain 2011 ? 2015 model year Sienna vehicles. In these reports, corrosion on the position sensor of the left and/or right power sliding door rear lock assembly caused that door to exhibit one or more of the abnormal operations described below: ? During power mode closing operation, as the power sliding door reaches the nearly closed position, the door reverses and moves toward the open positon. ? During power mode closing operation, the power sliding door cannot completely close and latch. ? The power mode closing operation of the power sliding door is inoperative. |
| ZH5_Region Lette | 2018-04-02. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH; STRUCTURE:BODY:DOOR. Region Letter: Toyota has received a number of reports regarding the power sliding door rear lock assemblies on certain 2011 ? 2015 model year Sienna vehicles. In these reports, corrosion on the position sensor of the left and/or right power sliding door rear lock assembly caused that door to exhibit one or more of the abnormal operations described below: ? During power mode closing operation, as the power sliding door reaches the nearly closed position, the door reverses and moves toward the open positon. ? During power mode closing operation, the power sliding door cannot completely close and latch. ? The power mode closing operation of the power sliding door is inoperative. |
| ZH5_Region Email | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. Region Email: Toyota has received a number of reports regarding the power sliding door rear lock assemblies on certain 2011 ? 2015 model year Sienna vehicles. In these reports, corrosion on the position sensor of the left and/or right power sliding door rear lock assembly caused that door to exhibit one or more of the abnormal operations described below: ? During power mode closing operation, as the power sliding door reaches the nearly closed position, the door reverses and moves toward the open positon. ? During power mode closing operation, the power sliding door cannot completely close and latch. ? The power mode closing operation of the power sliding door is inoperative. |
| ZH4_Toyota POL17 | 2018-04-02. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH; STRUCTURE:BODY:DOOR. Warranty Policy Bulletin: Toyota has received a number of reports regarding sliding door front lock assemblies on certain 2011 ? 2016 model year Sienna vehicles. In these reports, during the closing operation of the left and/or right side sliding door, the door would not completely close and latch due to corrosion on the latch lever pin of the door?s front lock. |
| ZH4_Dealer Lette | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. Dealer Letter: Toyota has received a number of reports regarding sliding door front lock assemblies on certain 2011 ? 2016 model year Sienna vehicles. In these reports, during the closing operation of the left and/or right side sliding door, the door would not completely close and latch due to corrosion on the latch lever pin of the door?s front lock assembly. |
| ZH4_Dealer Email | 2018-04-02. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH; STRUCTURE:BODY:DOOR. Dealer Email: Toyota has received a number of reports regarding sliding door front lock assemblies on certain 2011 ? 2016 model year Sienna vehicles. In these reports, during the closing operation of the left and/or right side sliding door, the door would not completely close and latch due to corrosion on the latch lever pin of the door?s front lock assembly. |
| ZH4_Region Lette | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR. Region Letter: Toyota has received a number of reports regarding sliding door front lock assemblies on certain 2011 ? 2016 model year Sienna vehicles. In these reports, during the closing operation of the left and/or right side sliding door, the door would not completely close and latch due to corrosion on the latch lever pin of the door?s front lock assembly. |
| ZH4_Region Email | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR. Region Email: Toyota has received a number of reports regarding sliding door front lock assemblies on certain 2011 ? 2016 model year Sienna vehicles. In these reports, during the closing operation of the left and/or right side sliding door, the door would not completely close and latch due to corrosion on the latch lever pin of the door?s front lock assembly. |
| T-SB-0244-17 | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. TSB: Some 2011 ? 2016 model year Sienna vehicles may exhibit power or manual sliding door front and rear latches simultaneously NOT latching due to corrosion on the latch lever pin of the front lock assembly. Additionally, some 2011 ? 2015 model year Sienna vehicles may exhibit power sliding door abnormal closing operation due to internal corrosion in the latch switch of the rear lock assembly. |
| T-SB-0141-10 Rev | 2018-04-02. Service bulletin. STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT; BACK OVER PREVENTION. If a creak, tick, or rattle noise is heard at the top or bottom of the windshield, or at the top of the rear glass, the source of the noise may be the two stoppers bonded to the top of the windshield/rear glass, or the windshield retainers bonded to the lower edge of the windshield. This bulletin provides the recommended repair procedure to eliminate these types of noises from the windshield/rear glass area. |
| T-SB-0052-13 | 2018-04-02. Service bulletin. STRUCTURE; STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT. Some 2011 ? 2012 model year Sienna vehicles may exhibit a condition where the front door glass run on either the RH or LH side becomes loose or does not stay in place. Vehicles may also exhibit a condition where the front door glass run is pulled off the track and may come down while the window is operated. Use the following repair procedure to address this condition. |
| T-SB-0044-16_Rev | 2018-04-02. Service bulletin. STRUCTURE:BODY. TSB: REVISION NOTICE March 07, 2017 Rev1: ? Applicability has been updated to include 2017 model year Toyota vehicles. On some vehicles, when Rapgard? is removed the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is NOT necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0304-17 | 2017-11-14. Service bulletin. STRUCTURE:BODY:DOOR. TSB: Vehicle replacement certification labels (the vinyl label installed on the driver door or door post) and VIN plates (the metal plate riveted to dashboard) may be available from Toyota, provided the request meets one of the criteria listed in this Service Bulletin. |
| ESS_ Special Ser | 2017-08-15. Service bulletin. STRUCTURE; EQUIPMENT ADAPTIVE/MOBILITY. Dealer Package: Toyota has received reports indicating that some vehicles experienced symptoms of the condition in Special Service Campaign A7E after being inspected and/or repaired. |
| T-SB-0232-17 | 2017-08-15. Service bulletin. STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS; STRUCTURE:BODY:DOOR. TSB: Some 2014 - 2017 model year Highlander/Highlander HV and 2011 - 2017 model year Sienna vehicles equipped with a Power Back Door (PBD) may exhibit a condition in which the back door latch does not release and the PBD cannot be opened from any switch (IP, key, back door), with one or both of the following conditions: * Excessive force required to operate the manual back door latch release lever * DTC B2250 present. |
| T-SB-0040-08 | 2017-08-14. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0040-08 | 2017-08-14. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.