Service bulletins for the 2015 Toyota Highlander
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
335 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Wheels are shown. Show all
| Toyota PRO19-02 | 2022-02-14. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; WHEELS; TIRES. POL: This consolidated Tire Warranty Guide contains the complete warranty terms for all brands of ground and spare tires currently in use by Toyota. This information must be kept near the point of vehicle sale and be available to any customer that requests it. Customers can find this information on the Owner?s section of Toyota.com. Dealers can locate a copy of this guide on the Claims Processing & Resource Center in Dealer Daily as well. |
|---|---|
| T-TT-0528-19_Rev | 2020-03-30. Service bulletin. WHEELS. TT: Some 2014-2020 model year Highlander and Highlander HV vehicles are equipped with alloy wheels that are clad with a plastic cover. Use of a heat gun to facilitate removal of stick-on wheel weights may damage the coating on the cladding and cause it bubble and/or peel off |
| T-TT-0528-19 | 2019-03-25. Service bulletin. WHEELS. TT: Some Highlander and Sienna clad/chrome wheels might experience bubbling and/or peeling off on the wheel coating (see picture below). Table below shows the wheel part numbers affected by the issue. |
| T-TT-0315-14 Rev | 2018-04-02. Service bulletin. WHEELS. TT: Chrometec (plastic clad) wheels are being damaged during mounting and dismounting of tires. |
| T-TT-0424-16 | 2018-04-02. Service bulletin. WHEELS:LUGS/NUTS/BOLTS/STUDS. TT: Front Brake Vibration Key Points: * Issue can occur at any time if improper torque is applied on lug nuts * Over time, even one lug nut over or under torqued, can cause a vibration issue * When lug nuts are over torqued, this causes the rotor to have a runout out condition which can lead to brake vibration concerns * Brake vibration issues can occur at parking lot to highway speeds * Brake vibration issues can occur at light to moderate braking * Tightening lug nuts in a star pattern method during the torqueing process will assure that even/equal pressure is applied across the rotor hub surface * Torque sticks/wrenches should be used to apply accurate torque values when tightening * Do Not use impact guns/ratchets to completely run lug nuts up to the wheel surface |
| T-SB-0149-16 | 2018-04-02. Service bulletin. WHEELS; EQUIPMENT. TSB: Some 2014 ? 2016 Highlander/HV vehicles may exhibit a condition where the spare tire cable does NOT fully unwind. This condition can occur when the spare tire carrier is operated without the wheel attached. Follow the Repair Procedure in this bulletin to address this condition. |
| T-SB-0026-14 | 2018-04-02. Service bulletin. WHEELS. During the manufacturing process tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. |
| T-TT-0315-14 | 2017-08-14. Service bulletin. EQUIPMENT; WHEELS. TT: Chrometec (plastic clad) wheels are being damaged during mounting and dismounting of tires. Refer to photos below for identifying plastic and aluminum portions of wheel: |
| T-SB-0026-14 Rev | 2017-08-14. Service bulletin. TRAILER HITCHES; EQUIPMENT:MECHANICAL; WHEELS. TSB: During the manufacturing process tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Please refer to the following procedure to ensure that the original tires stay in the same location on the vehicle. |
| T-SB-0381-09 Rev | 2017-08-01. Service bulletin. SUSPENSION; WHEELS. TSB: The only acceptable towing method for vehicles equipped with an Active Torque Control 4WD system is to have all four wheels off the ground. Flat towing or towing where only the front or rear wheels are supported may damage the all-wheel drive system. |
| T-TT-0315-14 | 2017-08-01. Service bulletin. WHEELS. TT: Chrometec (plastic clad) wheels are being damaged during mounting and dismounting of tires. |
| T-TT-0315-14 | 2017-03-07. Service bulletin. WHEELS. "TT: CHROMETEC (PLASTIC CLAD) WHEELS ARE BEING DAMAGED DURING MOUNTING AND DISMOUNTING OF TIRES. REFER TO PHOTOS BELOW FOR IDENTIFYING PLASTIC AND ALUMINUM PORTIONS OF WHEEL:" |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.