Service bulletins for the 2017 Subaru Impreza
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
569 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Glass, wipers and mirrors are shown. Show all
| Subarunet Announcement | 2025-04-01. Other. VISIBILITY/WIPER. Update safety recall: WRG-22 Impreza headlamp non -compliance final phase mailing to owners. |
|---|---|
| 07-184-20R | 2021-03-04. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT; VISIBILITY:POWER WINDOW DEVICES AND CONTROLS. This bulletin announces a design change made to the power window main switches. |
| 15-210-17 | 2021-02-18. Service bulletin. VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:COMPRESSOR. This bulletin provides a service procedure for replacement of the A/C compressor clutch stator. |
| 15-232-18 | 2018-10-01. Service bulletin. VISIBILITY; EXTERIOR LIGHTING:FOG LIGHTS. This Service Information bulletin announces a change made to the lens portion of the fog light assembly. The new lens has optimized light distribution characteristics while remaining interchangeable with the original type. |
| 12-207-16 | 2018-04-02. Service bulletin. VISIBILITY:GLASS, SIDE/REAR. This bulletin announces a change to the procedure used in production of the rear door glass assembly. The bottom edge of the door glass is pressed into a metal channel lined with rubber. The channel attaches the door glass assembly to the window regulator. In below-freezing temperature conditions, water freezing in the channel combined with the door glass sticking to the door weatherstrip can increase chance of the glass separating from the channel when attempting to operate (lower) the window. A lubricant has been added to the rubber portion to insure the glass gets fully seated during assembly which maximizes the clamping force of the channel on the glass. |
| 01-174-16 | 2017-08-14. Service bulletin. EQUIPMENT:ELECTRICAL; VISIBILITY:WINDSHIELD. This Service Information bulletin provides a guideline to use for placement of required or mandated windshield stickers (inside and / or outside) on vehicles equipped with EyeSight Driver Assist Technology and High Beam Assist (HBA) features. Examples of these types of stickers include: * Government facility / Military base access stickers * State-mandated Vehicle Safety Inspection and Emission Compliance stickers * Parking Permit Stickers The cameras used by both of these features require a clear, unobstructed "view" through the windshield for their proper operation. The illustration below shows the "Prohibited area" in gray. Any stickers mandated to be placed within the Prohibited area should be placed to the right of the EyeSight stereo camera and HBA camera, outside of the Prohibited area as shown in the illustration below. Viewed from inside the vehicle, the left edge of the sticker must be placed no more than 14 inches (slightly less is preferred as a "cushion" for measuring variation) from the right edge of the windshield as shown in the illustration and indicated by the box outlined in blue. Always consult state and local regulations applicable to windshield sticker placement. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.