WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Subaru Forester

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

502 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
15-239-192019-05-28. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. This Service information bulletin announces a design change made to the Cargo Net ? Rear Replacement Hardware Kit (F551SAG301). The new part number is F551SAN010. The change was made to address concerns regarding the ?mushroom? anchors either pulling out of the trim panel and or gapping visibly at the base of the anchor between the black plastic spacer and trim panel.
02-163-16R2019-05-28. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This Service Information bulletin provides new inspection and repair procedures for AVCS (Active Valve Control System) -related DTCs on the FA and FB engine equipped models listed above. The applicable Service Manuals will be revised with this new information in the near future.
16-120-192019-05-28. Service bulletin. EQUIPMENT:MECHANICAL; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. This bulletin provides a procedure to follow for addressing customer concerns of a shuddering condition or chattering -type sound heard or felt when making sharp turns. If an applicable vehicle presents with the condition as described, it is recommended to perform the transfer clutch break-in procedure as described.
02-170-17R2019-05-20. Service bulletin. ELECTRICAL SYSTEM:STARTER ASSEMBLY:SOLENOID; ENGINE. This bulletin announces part information for new Active Valve Control System (AVCS) oil control solenoid valves (OCV) which contain a redesigned internal oil seal. The new seal will eliminate potential oil seepage into the wire harness connector portion of the valve. If oil seeps into the connector, over time, the Check Engine lamp may illuminate and set various AVCS-related DTCs.
WUE-90R2019-05-20. Service bulletin. EXTERIOR LIGHTING:BRAKE LIGHTS. Subaru of America, Inc. (Subaru) is recalling certain Crosstrek, Forester, Impreza, and WRX vehicles to replace the brake lamp switch. A total of 1,303,530 U.S. vehicles will be affected by this recall.
15-208-17R2019-05-20. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. This Service Information bulletin announces availability of an enhancement to the Gracenote database included in the vehicles listed above equipped with F10 7? Navigation and 7? Display Audio head units.
02-178-18R2019-03-25. Service bulletin. EQUIPMENT. This Service Information bulletin announces a design change made to the rubber timing hole access plug to improve its retention and prevent water intrusion into the converter case.
11-169-16R2019-03-25. Service bulletin. ENGINE. This bulletin announces the availability of reprogramming files to optimize the ECM. These new files will address customer concerns of: ? Spark knock (ping) during high intake air temperature operation ? Surge on acceleration due to phantom knock detection ? Check Engine light illumination resulting from DTC P113A and / or P0137 being stored in the ECM memory.
16-112-18R2019-03-25. Service bulletin. ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:IGNITION:ANTI-THEFT:CONTROL MODULE; ELECTRICAL SYSTEM:IGNITION. This bulletin announces a design change to the CVT select lever (shifter) mechanism in response to isolated customer concerns of not being able to remove the key from the ignition switch when the vehicle is in Park. The cause is contamination of the Park-Range switch internal components.
02-134-12R2019-03-11. Service bulletin. ENGINE; EQUIPMENT. The purpose of this bulletin is to announce a change to the specification of the valve springs used in the FB engine. The new springs have different color paint marks to help identify their application.
16-119-192019-03-11. Service bulletin. ELECTRICAL SYSTEM. This Service Information bulletin announces availability of a new control valve assembly (valve body) designed to prevent false detection of DTC P0841 and / or illumination of the AT Temp light. Testing has revealed in some limited cases, air bubbles (aerated fluid) may enter certain pressure circuits within the control valve assembly causing fluid pressure control and adjustment to be calculated incorrectly resulting in DTC P0841. The shape of these circuits has been changed to prevent this occurrence.
04-23-18R2019-03-11. Service bulletin. STEERING; STEERING:RACK AND PINION:RACK; STEERING:ELECTRIC POWER ASSIST SYSTEM. This bulletin provides helpful tips to simplify the diagnosis of sound concerns originating in the electronic power steering (EPS) gearbox (steering rack) assembly. If a vehicle presents with a ?rattling?, ?knocking? or possibly a ?clanging? type sound coming from the steering rack and / or a vibration felt through the steering wheel, use the flow chart below to help make diagnosis of the concern easier.
17-17-13R2019-03-11. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; AIR BAGS. This Bulletin provides information regarding Event Data Recorder (EDR) functionality which has been incorporated into the airbag system.
16-103-16R2019-03-11. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This bulletin has been developed in response to a small number of customer concerns regarding fluid seepage found coming from the CVT assembly. Investigation has identified a likely source of the seepage to be the sealant used on the CVT?s oil pump chain cover. The repair involves removal, a thorough cleaning and inspection of the sealing surfaces followed by re-sealing the cover.
11-187-182019-02-25. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:GAS RECIRCULATION VALVE (EGR VALVE); FUEL SYSTEM, GASOLINE; ELECTRICAL SYSTEM. This bulletin announces reprogramming file availability to optimize the ECM and address isolated customer concerns of hesitation on acceleration. The new logic provides enhanced ignition timing control during Exhaust Gas Recirculation (EGR) operation.
07-133-182019-02-19. Service bulletin. ENGINE. This Service Information Bulletin announces design changes to the engine?s knock sensor which will help improve vehicle assembly line efficiency and increase durability. In some cases, the Check Engine light may illuminate and a knock sensor-related DTC set in the ECM memory: P0327, P0328, P0332 and P0333. The knock sensor for DIT engines is now utilized for NA engines to improve durability and resistance to heat.
04-24-182019-02-19. Service bulletin. STEERING; STEERING:ELECTRIC POWER ASSIST SYSTEM. This bulletin announces a new Electronic Power Steering (EPS) control module for the models listed above. These new EPS control modules address a limited number of customer concerns regarding increased steering effort which may occur during freezing temperatures after a cold start. The cause has been identified as a frozen relay contact inside the control module. Illumination of the EPS warning lamp can also occur and a DTC C2532 may be stored.
16-112-18R2019-02-19. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:IGNITION. This bulletin announces a design change to the CVT select lever (shifter) mechanism in response to isolated customer concerns of not being able to remove the key from the ignition switch when the vehicle is in Park. The cause is contamination of the Park-Range switch internal components.
03-82-182018-12-10. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; POWER TRAIN. This Service Information bulletin announces a design change to the clutch release bearing used on the models as listed above. During assembly of the bearing, a different type of grease is used which has a higher resistance to heat. In cases where the operator keeps a foot on the clutch pedal for extended periods, an increased amount of heat is generated which can cause the grease inside the bearing to deteriorate. In a case of prolonged clutch pedal application, seizure of the bearing can occur with potential damage to other related components.
15-199-16R2018-12-10. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; EQUIPMENT ADAPTIVE/MOBILITY. This bulletin announces reprogramming file availability and the software installation procedure to address a group of operational concerns received from the field and listed below involving the Clarion Display Audio unit with 6.2? display.
12-251-182018-12-10. Service bulletin. LATCHES/LOCKS/LINKAGES; STRUCTURE:BODY. This bulletin provides a service procedure to address a gap between the top edge of the door and the instrument panel on the models listed as shown in the photo below. The gap may also make the glove box door difficult to close fully.There is a latch to keep the glove box closed on both sides of the glove box door. If the door is closed without using enough force to engage both latches or by pushing it shut on just one side instead of in the middle, one may close and not the other. Over time, if the door is not fully closed with both latches, high cabin temperatures along with weight of the items inside the glove box may cause the assembly to deform slightly and a gap to develop.
15-208-17R2018-12-10. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. This Service Information bulletin announces availability of an enhancement to the Gracenote database included in the vehicles listed above equipped with F10 7? Navigation and 7? Display Audio head units. When the user plays a pre-recorded CD, Gracenote recognizes the disc then shows the artist and track name information along with the album cover art on the head unit display (when available). This enhancement brings the currently installed database up to date with the most recent information available.
03-82-182018-12-10. Service bulletin. POWER TRAIN; EQUIPMENT ADAPTIVE/MOBILITY. This Service Information bulletin announces a design change to the clutch release bearing used on the models as listed above. During assembly of the bearing, a different type of grease is used which has a higher resistance to heat. In cases where the operator keeps a foot on the clutch pedal for extended periods, an increased amount of heat is generated which can cause the grease inside the bearing to deteriorate. In a case of prolonged clutch pedal application, seizure of the bearing can occur with potential damage to other related components.
15-199-16R2018-12-10. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This bulletin announces reprogramming file availability and the software installation procedure to address a group of operational concerns received from the field and listed below involving the Clarion Display Audio unit with 6.2? display.
12-251-182018-12-10. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; STRUCTURE:BODY; STRUCTURE:FRAME AND MEMBERS. This bulletin provides a service procedure to address a gap between the top edge of the door and the instrument panel on the models listed as shown in the photo below. The gap may also make the glove box door difficult to close fully.There is a latch to keep the glove box closed on both sides of the glove box door. If the door is closed without using enough force to engage both latches or by pushing it shut on just one side instead of in the middle, one may close and not the other. Over time, if the door is not fully closed with both latches, high cabin temperatures along with weight of the items inside the glove box may cause the assembly to deform slightly and a gap to develop.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.