WenmarOpen by Wenmar Pro

Service bulletins for the 2023 Ram 5500

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

270 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
1032882025-03-04. Service bulletin. LANE DEPARTURE: BLIND SPOT DETECTION. CAMERA - REAR VIEW
03-001-25 REV. B2025-03-04. Service bulletin. UNKNOWN OR OTHER. "Clicking Noise While In 4WD Customers may experience the following: ● Ratcheting, click, or clicking noise in 4WD while turning. This bulletin involves replacing the front driveshaft."
S2108000015 REV.J2025-02-26. Service bulletin. ELECTRICAL SYSTEM. Uconnect Box Require Service Message
91005002025-02-26. Service bulletin. ELECTRICAL SYSTEM. Touchscreen For all infotainment system repairs (touchscreens, radios, etc.), refurbished parts may be available. Follow the Infotainment Ordering guide available under the "Parts" section of Dealer Connect: DealerCONNECT> Parts> News& Information> Audio & Electronic Products Exchange Process
08-044-25 REV.A2025-02-26. Service bulletin. ELECTRICAL SYSTEM. Flash: Radio Frequency Hub Module (RFHM) Updates Customers may experience one or more of the following: ● Wired Remote Start (WRS) may have to be pressed twice to shut the engine off. ● WRS feature unable to turn off the engine when using the WRS button.
08-044-252025-02-25. Service bulletin. ELECTRICAL SYSTEM. "Flash: Radio Frequency Hub Module (RFHM) Updates Customers may experience one or more of the following: ● **Wired Remote Start (WRS) may have to be pressed twice to shut the engine off.** ● WRS feature unable to turn off the engine when using the WRS button This bulletin involves updating the RFHM module with the latest available software"
03-001-25 REV. A2025-02-19. Service bulletin. POWER TRAIN; UNKNOWN OR OTHER. "Clicking Noise While In 4WD Customers may experience the following: ● Ratcheting, click, or clicking noise in 4WD while turning. This bulletin involves replacing the front driveshaft."
S228A000005 REV.E2025-02-18. Service bulletin. ELECTRICAL SYSTEM. Uconnect Box Error Message, With Active or Stored Cellular Antenna Open or Short Diagnostic Trouble Codes (DTCs)
03-001-252025-02-11. Service bulletin. POWER TRAIN. "Clicking Noise While In 4WD ustomers may experience the following: ● Ratcheting, click, or clicking noise in 4WD while turning. his bulletin involves replacing the front driveshaft"
91004932025-02-06. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. SWITCH AND BEZEL Front Door Before replacing the Window Switch/Mirror Switch, please follow these steps: 1.- Check for what DTC are detected and take proper steps acceding to the DTC's. 2.- Make sure all the switches are properly connected to their harness, disconnect the switch and reconnect it. 3.- Review the window Switch for any physical issue (Button stuck, broken) If after performing these steps the switch remains faulty. Follow suggested repairs per diagnostics performed.
S258A0000052025-02-06. Service bulletin. ELECTRICAL SYSTEM. Trailer Tow App Gauges Not Showing Data in Widget Screen
90039802025-01-29. Service bulletin. ELECTRICAL SYSTEM. SWITCH Headlamp Before replacing the Headlamp Switch for faulty dimmer operation. Please follow the next steps to corroborate if the Headlamp Switch is malfunctioning: 1.- Please disconnect and reconnect the headlamp Switch. And verify if the issue is corrected. 2.- Review the internal resistance of the switch: a.- For the Right Dimmer (IP) between Pins 6 & 3. The value should be around 5.74 KOhms, when in the lowest position to 311 ohms in the top position (Parade Detent). b.- For the left Dimmer (Ambient Light) between pins 8 & 3. The value should be around 14.52 KOhms, when in the lowest position to 182 ohms in the top position. If a problem is found in the resistor values. Please replace the Switch.
S1408000384 REV.H2025-01-28. Service bulletin. ELECTRICAL SYSTEM. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS Related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
91004902025-01-23. Service bulletin. ELECTRICAL SYSTEM. SWITCH Instrument Panel Before replacing the driver window switch, please follow these steps: 1.- Review the Trailer brake Switch for any physical issue (Button stuck, broke). If no physical issue identified, move to next steps. 2.- Make sure the switch harness is properly connected, disconnect the switch and reconnect it, and reverify the issue. 3.- Check for what DTC are detected and take proper steps. 4.- Review the internal resistance of the switch to corroborate if it is shorted: a) Between Pins 10&2 it should be around 13ohms +/- 4ohms b) Between Pins 3 & 4 and 4 & 6, 160 ohms +/-10 Ohms If a problem is found in the resistor values. Please replace the Switch.
S1425000019 REV.A2025-01-23. Service bulletin. UNKNOWN OR OTHER. Malfunction Indicator Lamp (MIL) Illuminated. Diesel Exhaust Fluid (DEF) System Diagnostic Trouble Codes (DTCs) due to Hydrocarbon Contamination.
91004872025-01-15. Service bulletin. STEERING. MODULE Steering Control Before replacing the steering column control module (SCCM) due to turn signal inop, wipers inop, steering controls inop, TCS light DTC C0051 or horn blowing while turning, please follow these steps: 1.- Refer to service library procedure and follow diagnosis steps. 2.- If failure still present, make sure all the switches', horn's, airbag's harness are properly connected and there is no corrosion or pinching, disconnect the switches & reconnect them, and reverify the issue. 3.- Verify if failure is still present, review if there is lack of communication between SCCM and BCM. For example, activate turn signals or wipers. 4.- Read at the BCM diagnosis session if BCM is receiving information from SCCM. Through diagnosis review if activation from horn, wipers or turn signal is requested and are working. 5.- Disconnect the SCCM fuse for around 30s,and repeat the previous steps to see if failure still present. 6.- Do a hard reset to BCM and evaluate if any DTC is set. Retest if failure still present. 7.- Before replacing the SCCM disconnect it and reconnect it again. If there are no DTC's active, physical defects, steering controls inop, wipers inop, nor turn signal inop, horn inop, then SCCM does not need to be replaced.
S1408000384 REV.G2025-01-09. Service bulletin. ELECTRICAL SYSTEM. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
1023872025-01-04. Service bulletin. POWER TRAIN. SEAL - OUTPUT SHAFT
1023892025-01-04. Service bulletin. POWER TRAIN. SEAL - OUTPUT SHAFT
S2008000186 REV.B2024-12-21. Service bulletin. ENGINE. Engine Control Module (ECM) Flash Failure, Diagnostic Trouble Code (DTC) U1601 – ECU Application Software Code 1 Missing Or Corrupted
S24080001232024-12-20. Service bulletin. ELECTRICAL SYSTEM. Push to Start Button Has a Delay Switching Ignition Positions, DTCs (Diagnostic Trouble Codes), B1A7D-2A Start Button - Stuck, U103C-00 KIN/IGNM Communication
91004652024-12-19. Service bulletin. SEATS. SEAT BELT Front Outer Seatbelt Slow Retraction / Seat Belt Cleaning If the vehicle exhibits slow seatbelt retraction, prior to replacing seatbelt please inspect for debris and any build up on the webbing and DRing. If evidence of debris and build up, please clean seatbelt webbing or turning loop as described below. Seat Belt Maintenance: Do not bleach, dye or clean the belts with chemical solvents or abrasive cleaners. This will weaken the fabric. If the belts need cleaning, use a mild soap solution or lukewarm water. Do not remove the belts from the vehicle to wash them. Dry with a soft cloth. Sun damage can also weaken the fabric. Replace the belts if they appear frayed or worn or if the buckles do not work properly. NOTE: If the belts retract slowly, inspect the upper turning loop for soiling. If soiling is present, clean with a wet soft cloth until all residue is removed.
08-186-24 REV. A2024-12-18. Service bulletin. ELECTRICAL SYSTEM. "Flash: Radio Frequency Hub Module (RFHM) Updates Customers must experience the following: ● Wired Remote Start Stop (WRSS) feature unable to turn off the engine stop/start with the WRSS button. This bulletin involves updating the RFHM module with the latest available software."
S2208000045 REV.B2024-12-11. Service bulletin. BACK OVER PREVENTION: REARVIEW SYSTEM BRAKING. Backup Camera Poor Image Quality Inspection
S248A0000182024-12-10. Service bulletin. ELECTRICAL SYSTEM. Trailer Tow Pages App Gauges Not Showing Data After Radio Update

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.