Service bulletin 9100465
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 11011995 |
| Published by NHTSA | 2024-12-19 |
| Manufacturer's number | 9100465 |
| Manufacturer's date | 2024-12-16 |
| NHTSA component | SEATS |
| Manufacturer's system | Seat Belt |
NHTSA's summary
SEAT BELT Front Outer Seatbelt Slow Retraction / Seat Belt Cleaning If the vehicle exhibits slow seatbelt retraction, prior to replacing seatbelt please inspect for debris and any build up on the webbing and DRing. If evidence of debris and build up, please clean seatbelt webbing or turning loop as described below. Seat Belt Maintenance: Do not bleach, dye or clean the belts with chemical solvents or abrasive cleaners. This will weaken the fabric. If the belts need cleaning, use a mild soap solution or lukewarm water. Do not remove the belts from the vehicle to wash them. Dry with a soft cloth. Sun damage can also weaken the fabric. Replace the belts if they appear frayed or worn or if the buckles do not work properly. NOTE: If the belts retract slowly, inspect the upper turning loop for soiling. If soiling is present, clean with a wet soft cloth until all residue is removed.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Seats
| RAM 2500 | 2023, 2024, 2025 |
|---|---|
| RAM 3500 | 2023, 2024, 2025 |
| RAM 4500 | 2023, 2024, 2025 |
| RAM 5500 | 2023, 2024, 2025 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| S2508000036 Rev D | 2026-04-01. Service bulletin. The Occupant Restraint Controller (ORC) Sets B2204-00 Unknown Status (Pending), Sets B2204-00 ECU Configuration Mismatch Or/And DTC B222D-00 Active for ECU Unable to Configure/Configuration Not Learned |
|---|---|
| S2608000015 | 2026-03-25. Service bulletin. Memory Seat Does Not Work There Is No Response from The Seat While Pressing the Memory Seat Profiles from the Switch Diagnostic Trouble Code (DTC) B1D9B-54- Seat Horizontal Front Stop Not Learned-Missing Calibration |
| 08-088-26 REV.A | 2026-03-13. Service bulletin. Flash: Heating, Ventilation And Cooling (HVAC) Software Updates Customers may experience the following: SYMPTOM: ● Heated seat and/or heated steering wheel are inoperative. . No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC. |
| S2508000107 | 2025-12-17. Service bulletin. Comfort Seat Module (CSM) or Comfort Steering Wheel Module (CSWM) do Not Operate |
| S2524000014 | 2025-11-26. Service bulletin. Heated Seats And Heated Steering Wheel Inoperative |
| S2508000036 REV.A | 2025-06-17. Service bulletin. The Occupant Restraint Controller (ORC) Will Set The B2204-00 DTC In Unknown Status (pending), For B2204-00 ECU Configuration Mismatch |
| 08-182-25 | 2025-06-10. Service bulletin. "Power Seat Not Adjusting Customers may experience one or more of the following: ● Driver and/or passenger seat moves backwards but not forward. ● Driver and/or passenger seat inoperative. This bulletin involves replacing the front power seat adjusters." |
| 9100562 | 2025-05-29. Service bulletin. Frame - Front Seat Back: 2024 2025 DJ D2 Power back frame with INOP motor replaced seat frame Please review TSB 08-159-25 before replacing any parts on the seat back frame. |
| 08-159-25 | 2025-05-20. Service bulletin. "Front Left Power Seat Back Will Not Recline Customers may experience the following: ● Front left power seat back will adjust forward but will not recline back This bulletin involves replacing the front left power seat back and power seat adjuster." |
| 9100548 | 2025-04-17. Service bulletin. "ADJUSTER Seat DJ D2 DP 1st Row Power Seat Fore/Aft Adjuster Inspection TSB is also released for this concern. SYMPTOM/CONDITION: Fore-aft function does NOT work when actuating the seat switch. DIAGNOSIS: 1) Put seat in position for inspection. 2) Disconnect seat wire harness motor connector from the fore-aft motor on the seat adjuster, wait 10 seconds, and reconnect. 3) Verify function of the fore/aft adjuster. Step 1. Open 2nd row door and function rear seat cushions up to stowed position. Step 2. Adjust the driver front seat to the full up position. Use switches on the side shield to move power seat fully up. Step 3. Remove the 4 bolts that hold the seat to the truck floor and discard. The bolts have lock patch that is not reusable. Step 4. Lay the seat down so its laying on its back so the underside of the seat is easily accessible. Step 5. Remove the fore/aft wire harness motor connector from the fore/aft motor (back right of the seat adjuster). Push on the tab to remove the motor wire harness connector from the motor. Leave disconnected for 10 seconds. Step 6. Reconnect the fore/aft wire harness motor connector to the fore/aft motor. Push / Pull / Push the connector with fingers to ensure the wire harness connector is fully seated to the fore/aft motor connector. Step 7. Before assembling the seat back to the truck floor, cycle the seat to check that the motor is working properly by pressing the fore/aft switch. If fore/aft motor does not function, please refer to Replacement Procedure below. Step 8. If the seat is working properly, carefully reassemble the seat back to the truck floor using the four new bolts. Use a torque wrench to verify 47 Nm. Step 9. *Note: Checking the passenger seat will be the same procedure as the driver seat. REPLACEMENT PROCEDURE Only for seats rejected after inspection. Replace Power Seat Adjuster per MOPAR service part replacement instructions. MOPAR Part Numbers: 68455847AA, 68455848AA, 68455849AA" |