WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Ram 3500

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

803 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
09-003-20 REV. B2020-05-26. Service bulletin. ENGINE AND ENGINE COOLING; EXTERIOR LIGHTING; STRUCTURE. Inspect Throttle Body Assembly This bulletin involves inspecting the Julian date on the throttle body and possibly replacing it. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) has been set:P2100 - Electronic Throttle Control Motor Circuit/Open - Bank 1. The customer may also describe the following:The vehicle is in limp home mode.
VB6 Rev. 32020-05-26. Service bulletin. ENGINE AND ENGINE COOLING. Revised Emissions Recall VB6 Diesel Engine Calibration
09-003-20 REV. B2020-05-18. Service bulletin. STRUCTURE; ENGINE AND ENGINE COOLING; EXTERIOR LIGHTING. Inspect Throttle Body Assembly This bulletin involves inspecting the Julian date on the throttle body and possibly replacing it. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) has been set:P2100 - Electronic Throttle Control Motor Circuit/Open - Bank 1. The customer may also describe the following:The vehicle is in limp home mode.
VB6 Rev. 32020-05-18. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:DIESEL. Revised Emissions Recall VB6 Diesel Engine Calibration
09-003-20 REV. B2020-04-27. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. Inspect Throttle Body Assembly This bulletin involves inspecting the Julian date on the throttle body and possibly replacing it. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) has been set:P2100 - Electronic Throttle Control Motor Circuit/Open - Bank 1. The customer may also describe the following:The vehicle is in limp home mode.
VB6 Rev. 12020-04-06. Service bulletin. FUEL SYSTEM, DIESEL; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. Emissions Recall VB6 Diesel Engine Calibration
S19180000032020-04-06. Service bulletin. ENGINE. Intermittent Engine Buck, Surge, or Misfire.
18-089-192019-12-16. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE. wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK
D-19-02 REV. B2019-12-16. Service bulletin. ENGINE. Fast Feedback Program - 6.7L Cummins Engine - 2019 HD Ram - All Models (Rev. B)
90041432019-12-02. Service bulletin. ENGINE AND ENGINE COOLING. MASTER CYLINDER, Brake Prior to replacing master cylinder, please call Paul Kuehl at (248) 535 -7013 and/or Tim Parks at (248) 202-0919. If no response in 15 minutes, proceed with repair.
90036802019-10-28. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING. RETAINER, Crankshaft Rear Oil Seal Oil leak from rear engine seal retainer or windage tray/gasket Check for other sources of leaks using dye such as gallery plugs, camshaft cup plug at rear of engine, rear of engine valley for possible MDS solenoid, VVT solenoid, block porosity or transmission leaks. If another source of the leak was identified, proceed with the appropriate repairs. Engineering is looking for assistance in determining root cause and a corrective action on crankshaft rear oil seals and windage tray/gaskets. For concerns related to rear crankshaft seal oil leaks and windage tray gaskets, please send an email to brenton.swank@fcagroup.com. Include the VIN, mileage, and any photos identifying where the leak is coming from using dye, such as: 1. Leak between rear seal and crankshaft (seal rolled during installation) 2. Leak between outer diameter of rear seal and retainer 3. Leak between rear seal retainer and engine block (Please record the 5 retainer bolts residual torque in tightening direction) 4. Leak between rear seal retainer and windage tray/gasket (Please record the oil pan bolts residual torque in tightening direction) If the source of the leak cannot be identified, please contact Brenton Swank at (248) 804-9386 or Brenton.Swank@FCAGroup.com If no response in 15 minutes, proceed with repair.
90041152019-10-28. Service bulletin. ENGINE. SEAL, Crankshaft Oil, Front Front crankshaft oil seal leak: For concern of front crankshaft seal leak please send an email to brenton.swank@fcagroup.com with VIN, Mileage, Photos and indicate where the leak is identified using dye such as: 1. Leak between the outer diameter of the seal to front cover? 2. Leak between the seal and damper 3. Leak through the damper bolt This will help in determining root cause and corrective action. For additional questions, please contact: Brenton Swank: Cell (248) 804-9386 or brenton.swank@fcagroup.com If no response in 15 minutes, proceed with repair.
OD553412019-07-15. Service bulletin. EQUIPMENT; ENGINE. Vehicles Eligible For CSN U07 And V08, V11 or V16 Important Update To U07 Dealer Instructions
549352019-07-15. Service bulletin. ENGINE; EQUIPMENT. Sensor-nitrous oxlde
553112019-07-15. Service bulletin. EQUIPMENT; ENGINE. Damper-Steering
553222019-07-15. Service bulletin. EQUIPMENT; ENGINE. Head-Cylinder
553242019-07-15. Service bulletin. ENGINE. Head-Cylinder
552212019-07-15. Service bulletin. ENGINE; EQUIPMENT. Engine Oil- OW20
550962019-07-15. Service bulletin. ENGINE. Engine Oil- OW20
549312019-07-15. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE. TAILPIPE - EXHAUST
90033572019-07-15. Service bulletin. ENGINE; EQUIPMENT. ADAPTER, Engine Oil Filter (Pentastar V6) Engineering is seeking information regarding OFA leaks. Questions/info can be directed to: Bob Jackson (248) 944-0466 - bob.jackson@fcagroup.com Ron Dallison (248-292-9510) ron.dallison@fcagroup.com Joe Lovell (734) 309-6467 - joe.lovell@fcagroup.com If no response in 15 minutes, proceed with repair. All vehicles equipped with a 3.2L or 3.6L except for model year 2014 vehicles with leak concern: 1) Ensure the Oil Filter Adapter (OFA) Cap O-ring is seated in the proper groove in the cap and not damaged or cut. 2) If replacing the (OFA) due to a leak detected between (OFA) and block. Ensure the torque on the 5 bolts are torqued to 12nm. If not record the actual values, torque to 12nm and contact the FCA employees listed below. 3) Remove the (OFA) and replace the O-ring and gaskets only (Kit #68191356A$), NOT THE OFA. 4) If oil was drained, add oil dye to ensure the leak is repaired. For model year 2014 vehicles replace the Oil Filter Adaptor.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.