WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Nissan Murano

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

246 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Driver assistance are shown. Show all

Bulletins, newest first
NTB19-042F2025-02-25. Service bulletin. FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING; ELECTRICAL SYSTEM; SERVICE BRAKES. AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions: • When contamination or foreign material adhere to the lane camera viewing window on the windshield. • When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield. • When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information: • Refer to the following pages. • Use the search keyword “blinking” in the ESM.
NTB19-033G2025-02-25. Service bulletin. SERVICE BRAKES; FORWARD COLLISION AVOIDANCE: ADAPTIVE CRUISE CONTROL; FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING; ELECTRICAL SYSTEM. INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual
NTB19-042E2024-06-07. Service bulletin. ELECTRICAL SYSTEM; FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING. AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-042D2023-04-07. Service bulletin. FORWARD COLLISION AVOIDANCE. AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-042C2022-02-10. Service bulletin. ELECTRICAL SYSTEM; FORWARD COLLISION AVOIDANCE. AEB WARNING LIGHT BLINKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB21-1062022-01-08. Service bulletin. ELECTRICAL SYSTEM; FORWARD COLLISION AVOIDANCE. DTC C1A17-49 OR C2580-49 STORED IN LASER/RADAR SERVICE INFORMATION If DTC C1A17-49 or C2580-49 is stored in LASER/RADAR in the “PAST” column: • Erase the DTC. • DO NOT replace any parts. If DTC C1A17-49 or C2580-49 is stored in LASER/RADAR in the "CURRENT" column, refer to the applicable ESM for instructions.
NTB09131B2021-05-10. Service bulletin. FORWARD COLLISION AVOIDANCE; EQUIPMENT:OTHER:LABELS. SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. See this bulletin for further detail.
NTB15073B2021-05-10. Service bulletin. EQUIPMENT; VEHICLE SPEED CONTROL; ELECTRICAL SYSTEM; BACK OVER PREVENTION. IF YOU CONFIRM The automatic back door does not operate and/or one or a combination of the following DTCs are found stored in the Automatic Back Door Control Module (ABD CU): - B2426-29 (SPINDLE SENSOR LH) - B2427-29 (SPINDLE SENSOR RH) - B2416-1E (TOUCH SEN R OPEN) - B2417-1E (TOUCH SEN L OPEN) - B242A-13 (CLSR CONDITION) ACTION 1. Check the battery voltage (engine not running). - Make sure battery voltage is between 12 and 15.5 volts. - Charge or replace the battery as needed. 2. For 2015 Murano Only: Refer to page 9, step 13 in the Service Procedure to confirm if ABD CU reprogramming is needed. - Reprogram the ABD CU, if needed. - If the ABD CU is reprogramed, also perform Automatic Back Door Manual Configuration. 3. Perform Automatic Back Door Calibration (see page 22). 4. Erase all DTCs. 5. For 2015 Murano Only: If reprogramming was done, inform the customer of changes in automatic back door operation (see page 3, and also Owner?s Manual pages at the end of this bulletin. See this bulletin for further detail.
NTB160252021-05-10. Service bulletin. EQUIPMENT; BACK OVER PREVENTION; ELECTRICAL SYSTEM. SERVICE INFORMATION If an Air Bag Diagnosis Sensor Unit is replaced and the configuration of the old unit could not be saved, use the Service Procedure in this bulletin to: - Load the VIN specific configuration file from your electronic parts catalog (FAST or equivalent) onto a portable USB storage device (thumb drive) - Plug the thumb drive into your CONSULT PC. - Configure the new Air Bag Diagnosis Sensor Unit using the file that you loaded onto the thumb drive. See this bulletin for further detail.
NTB15-099C2021-05-09. Service bulletin. ELECTRICAL SYSTEM; FORWARD COLLISION AVOIDANCE. SERVICE INFORMATION FOR DTCS C1A12 AND C1A16 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.
NTB19-042b2021-03-06. Service bulletin. ELECTRICAL SYSTEM; VISIBILITY:WINDSHIELD; FORWARD COLLISION AVOIDANCE. AEB WARNING LIGHT BLINKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-042a2020-12-09. Service bulletin. LANE DEPARTURE: SENSING SYSTEM: CAMERA; FORWARD COLLISION AVOIDANCE. AEB WARNING LIGHT BLINKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0422019-06-24. Service bulletin. LANE DEPARTURE; LANE DEPARTURE: SENSING SYSTEM: LIDAR; LANE DEPARTURE: SENSING SYSTEM: CAMERA. AEB WARNING LIGHT BLINKING This bulletin applies only to vehicles equipped with a lane camera. SERVICE INFORMATION If the AEB warning light is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions: - When contamination or foreign material adhere to the lane camera viewing window on the windshield - When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield - When the lane camera viewing window on the windshield is temporarily fogged up NOTE: - If DTCs are present in any of the following related systems: - Laser/Radar, - ICC/ADAS, or - Lane Camera, Refer to the related Electronic Service Manual (ESM) for diagnosis. - Refer to the following pages for further information.
NTB16-0772017-02-14. Service bulletin. BACK OVER PREVENTION: CAMERA SYSTEM. "2016 MURANO, ROGUE AND PATHFINDER; AROUND VIEW MONITOR MIRROR CAMERA INOPERATIVE IF YOU CONFIRM - EITHER THE LEFT OR RIGHT AROUND VIEW MONITOR DOOR MIRROR CAMERA IS INOPERATIVE. NOTE: THE FOLLOWING DTCS MAY ALSO BE PRESENT: - U111B (SIDE CAMERA LH IMAGE SIGNAL CIRCUIT) DTC IS STORED. AND/OR - U111D (SIDE CAMERA RH IMAGE SIGNAL CIRCUIT) DTC IS STORED. ACTION CHECK THE SIDE CAMERA HARNESS CONNECTION BETWEEN THE SIDE CAMERA AND THE MIRROR HARNESS LOCATED INSIDE THE INOPERATIVE DOOR MIRROR. - IF THE HARNESS CONNECTOR IS NOT LATCHED (CAN BE DISCONNECTED BY A GENTLE TUG), SEAT THE CONNECTOR, CLEAR THE DTC AND RETEST. - IF THE HARNESS CONNECTOR IS LATCHED (CANNOT BE DISCONNECTED BY A GENTLE TUG) REFER TO THE ELECTRONIC SERVICE MANUAL (ESM) FOR FURTHER DIAGNOSTIC INFORMATION. NOTE: IF A SIDE CAMERA REQUIRES REPLACEMENT, DO NOT REPLACE THE ENTIRE MIRROR, REPLACE ONLY THE SIDE CAMERA."

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.