Recalls that may apply to the 2014 Nissan Juke
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 15V418000 | 2015-07-01. ELECTRICAL SYSTEM:IGNITION:SWITCH. Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Versa Sedan vehicles manufactured July 16, 2013, to January 29, 2014, 2013-2014 Cube vehicles manufactured July 3, 2013, to October 21, 2013, and 2013-2014 Juke vehicles manufactured July 3, 2013, to October 22, 2013. When exposed to hot temperatures, the affected vehicles have an engine start/stop button that may stick inside the button housing. Built 2013-07-03 to 2013-10-22. |
|---|---|
| 14V683000 | 2014-11-28. FUEL SYSTEM, GASOLINE. Nissan North America, Inc. (Nissan) is recalling certain model year 2012-2014 Nissan Juke, 2012-2013 Infiniti M56, QX56, and 2014-2015 Infiniti Q70 (V8 engine vehicles only), and QX80 vehicles. The fuel pressure sensors may not have been sufficiently tightened during production. As a result, the fuel pressure sensor may loosen with vehicle usage and cause a fuel leak. Built 2011-11-28 to 2014-03-13. |
| 2015282 | 2015-06-25. Electrical. On certain vehicles, due to a manufacturing defect the start/stop button could stick inside of its housing. If this occurs, vibration could cause the electrical components inside the button to contact repeatedly in quick succession and initiate the emergency engine shut off procedure while the vehicle is in motion. This could result in increased steering and braking effort, a loss of motive power and would disable the supplemental restraint systems (SRS), increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair defective start/stop switch as necessary. |
|---|---|
| 2014539 | 2014-11-28. Fuel System. On certain vehicles, the fuel pressure sensor connected to the engine fuel delivery rail may not have been sufficiently tightened during vehicle assembly. Should the pressure sensor loosen, fuel could leak past a gasket used in the connection between the sensor and the rail. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury. Correction: Dealers will inspect the pressure sensor and tighten to specification. Note: This is an expansion of recall 2012-074. Vehicles that were repaired under the previous campaign are not affected because that remedy would have corrected the subject condition. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.