NHTSA recall 14V683000

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published by	NHTSA (United States)
Campaign number	14V683000
Manufacturer	Nissan North America, Inc.
Reported	2014-11-28
Owners notified	2015-01-25
Component	FUEL SYSTEM, GASOLINE
Units potentially affected	133592

Remedy progress the manufacturer reported
Report	Quarterly report 6, for 2016 quarter 2
Filed with NHTSA	2016-09-22
Vehicles in the campaign	133592
Reported remedied	108224 (81%)
Reported unreachable	0
Reported removed	0

These are the manufacturer's totals for the whole campaign at the end of 2016 quarter 2, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.

What is wrong

Nissan North America, Inc. (Nissan) is recalling certain model year 2012-2014 Nissan Juke, 2012-2013 Infiniti M56, QX56, and 2014-2015 Infiniti Q70 (V8 engine vehicles only), and QX80 vehicles. The fuel pressure sensors may not have been sufficiently tightened during production. As a result, the fuel pressure sensor may loosen with vehicle usage and cause a fuel leak.

What can happen

A fuel leak in the presence of an ignition source could cause a vehicle fire.

The remedy

Nissan will notify owners, and dealers will re-torque the fuel pressure sensors free of charge. The recall began on January 25, 2015. Owners may contact Nissan customer service at 1-800-647-7261.

Notes

Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.This is an expansion of recall 12V-069

Vehicles this campaign lists
2012 INFINITI M56	Built 2011-12-12 to 2013-11-13.
2013 INFINITI M56	Built 2011-12-12 to 2013-11-13.
2012 INFINITI QX56	Built 2011-12-08 to 2013-06-07.
2013 INFINITI QX56	Built 2011-12-08 to 2013-06-07.
2014 INFINITI QX70	Built 2013-11-06 to 2014-05-08.
2015 INFINITI QX70	Built 2013-11-06 to 2014-05-08.
2014 INFINITI QX80	Built 2012-10-02 to 2014-06-27.
2015 INFINITI QX80	Built 2012-10-02 to 2014-06-27.
2012 NISSAN JUKE	Built 2011-11-28 to 2014-03-13.
2013 NISSAN JUKE	Built 2011-11-28 to 2014-03-13.
2014 NISSAN JUKE	Built 2011-11-28 to 2014-03-13.

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
NTB17-082E	2022-03-12. Service bulletin. DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB13-097J	2022-03-12. Service bulletin. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB13-044J	2022-03-12. Service bulletin. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB15-044B	2021-05-24. Service bulletin. Fuel Filler Cap tether clip service information
ITB15021A	2021-05-10. Service bulletin. SERVICE INFORMATION If the clip for the fuel filler cap tether becomes lost or is detached for any reason, it is no longer necessary to replace the fuel filler cap. The clip or "pin" is now available as a separate service part. NOTE - Do not replace the fuel filler cap if only the pin is needed. See this bulletin for further detail.
NTB15044B	2021-05-10. Service bulletin. SERVICE INFORMATION If the clip for the fuel filler cap tether becomes lost or is detached for any reason, it is no longer necessary to replace the fuel filler cap. The clip or "pin" is now available as a separate service part. NOTE - Do not replace the fuel filler cap if only the pin is needed. See this bulletin for further detail.
ITB15033	2021-05-10. Service bulletin. IF YOU CONFIRM: The MIL is ON with one or more of the following DTCs stored: Bank 1 - P2096, P2097 --- POST CAT FUEL TRIM SYS B1 - P0130, P0131, P0132 --- A/F SENSOR1 (B1) - P0031, P0032 --- A/F SEN1 HTR (B1) - P014C, P014D, P015A, P015B --- Air fuel ratio (A/F) sensor 1 (bank 1) Bank 2 - P2098, P2099 --- POST CAT FUEL TRIM SYS B2 - P0150, P0151, P0152 --- A/F SENSOR1 (B2) - P0051, P0052 --- A/F SEN1 HTR (B2) - P014E, P014F, P015C, P015D --- Air fuel ratio (A/F) sensor 1 (bank 2) ACTION: 1. Refer to step 6 in the SERVICE PROCEDURE to confirm ECM reprogramming applies. 2. If reprogramming applies, reprogram the ECM. 3. Replace only the A/F sensors related to the stored DTCs. - If stored DTCs are for only one bank, replace only one A/F sensor for that bank. - If stored DTCs are for both banks, replace both A/F sensors. NOTE: Do NOT replace both A/F sensors if the stored DTC(s) are for only one bank. See this bulletin for further detail.
ITB11066E	2021-05-10. Service bulletin. SERVICE INFORMATION Part order approval from TECH LINE is no longer required when replacing the Audio Visual (A/V) Control Unit on an Applied Vehicle. Previously, TECH LINE would need to be contacted to confirm (or assist with) diagnosis and the proper repair prior to ordering an A/V control unit. This process has been suspended.
P2563	2021-05-10. Service bulletin. Infiniti is conducting a retailer service action to reprogram the ECM on certain specific 2012 and 2013 Infiniti QX56 vehicles to prevent the fuel pump pressure from becoming higher than design specifications and illuminating the MIL light.
ITB17-042c	2020-10-08. Service bulletin. INFINITI; DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See Amendment History on the last page. Please discard previous versions of this bulletin.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.