WenmarOpen by Wenmar Pro

Service bulletins for the 2022 Nissan Frontier

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

115 on file from NHTSA, as of 2026-10-19.

About C1142 on the 2022 Nissan Frontier: what the code means, and the bulletins and recalls about the same components.

By type

By component

By trouble code

Only bulletins with trouble code: C1142 are shown. Show all

Bulletins, newest first
NTB22-0842022-10-07. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. DTC C1116 AND/OR C1142 STORED IN THE ABS CONTROL MODULE IF YOU CONFIRM Customer states the ABS warning light is ON and “System fault See Owner’s Manual” appears in the message center (Figure 1), AND DTCs C1116 (Stop Lamp Switch) and/or C1142 (Press Sen Circuit) are stored in the ABS Control Module. ACTION Follow the SERVICE PROCEDURE in this bulletin to: 1. Install the Center High Mount Stop Lamp (CHMSL) Relay and Jumper Harness. 2. Install a new Stop Lamp Switch. 3. Reprogram the ABS Control Module. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
NTB22-0202022-05-20. Service bulletin. ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:WIRING:SWITCHES/KNOBS/BUTTONS. SERVICE INFORMATION FOR BRAKE SWITCH ADJUSTMENT FOR DTC C1142 AND/OR C1116 STORED SERVICE INFORMATION DTC C1142 (PRESS SEN CIRCUIT) and/or C1116 (STOP LAMP SW) may be stored if the Stop Lamp Switch and/or the Brake Pedal Position Switch are out of adjustment. Before replacing any components for DTCs C1142 (PRESS SEN CIRCUIT) and/or C1116 (STOP LAMP SW), stored as past or current, confirm that the Stop Lamp Switch and the Brake Pedal Position Switch are properly adjusted. If either the Stop Lamp Switch and/or the Brake Pedal Position Switch are found to be out of adjustment, adjust them as per the ESM, and then clear the DTCs and perform DTC confirmation. • Refer to the ESM: BRAKES > BRAKE SYSTEM > PERIODIC MAINTENANCE > BRAKE PEDAL > Adjustment

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.