WenmarOpen by Wenmar Pro

Service bulletins for the 2022 Mercedes-Benz AMG GT

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

199 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
LI07.61-P-0707072024-06-01. Service bulletin. ENGINE; FUEL/PROPULSION SYSTEM. The customer complains of a check engine light (CEL) on. May also complain of the engine running roughly and/or a loss of power. Multiple Causes Remedy Please see the document "Remedy Instructions" in attachments. For MY19+ G63 there may be an alternate solution available. Please reference LI07.61-P-076755 before performing the steps in this LI.
NCU-20221000052023-04-05. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. Mercedes-Benz AG (“MBAG”), the manufacturer of Mercedes-Benz vehicles, has determined that the affected vehicles may not meet current On Board Diagnostics (“OBD”) emissions specifications. Under certain conditions, the permanent OBD fault code memory of the 48V ISG control unit may not activate. What We’re Doing MBUSA will conduct a voluntary Emission Recall Campaign in which an authorized Mercedes- Benz dealer will update the software in the affected vehicles.
LI20.10-P-0753742022-12-05. Service bulletin. ENGINE AND ENGINE COOLING. Complaint Red coolant warning in instrument cluster. Fault codes U019F00 or U019F87 current/stored in MRG1 control unit. Cause Various causes Remedy Perform guided test for fault code U019F with XENTRY diagnosis. Verify the following connections are clean and tight. Correct any problems and retest pump actuation: -12V plug at M75/11 -48V plug at M75/11 -48V connector X192/4 -Connections at 48V fuse box F153/2 -Sockets 1,2, and 5 at connector 2 of MRG1 control unit -M75/11 circuit 41 ground If actuation and above connections are OK, but resistance between M75/11 and engine block is less than 2 ohms or heat shield touching coolant pump, proceed with below steps.
LI20.10-P-0728862022-09-07. Service bulletin. ENGINE AND ENGINE COOLING. Complaint CEL on with Code P012800 "The Coolant Temperature is Below the Specified Temperature" Cause Under investigation. This is not an issue that affects drivability or performance and is not a safety concern. The vehicle remains safe to operate with this code, but the measures listed in the "Remedy" section are recommended. Remedy Due to formatting issues please see "remedy instructions" in attachments
LI18.00-P-0731142022-06-02. Service bulletin. ENGINE AND ENGINE COOLING. Complaint Message in instrument cluster "Engine Oil Level - Reduce Oil Level" Cause Under analysis Remedy Record the oil flow quantity, drain & replace oil, open PTSS case if issues persists.
LI18.00-P-0731372022-02-04. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. Complaint Sporadic warning message in instrument cluster "Engine oil pressure stop switch off vehicle" (or similar) is shown in red on vehicles with low mileage. Cause Directional control valve may stick. Remedy 1- Read off oil level in instrument cluster and correct if necessary. 2- Perform approx. 10-15 engine starts, then clear fault codes. 3- Perform road test with vehicle. If fault code reoccurs during road test: Install new directional control valve.
LI09.00-P-0740932022-01-06. Service bulletin. ENGINE AND ENGINE COOLING. "MY15+ M278 and M157 Equipped Vehicles with Fault Code ""P023400 – Boost Pressure is Too High"" "
LI0761P0707072021-10-25. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM. M17x.xxx Check Engine Light on with Misfire DTC's

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.